An improved headspace solid-phase microextraction method for the analysis of free-base nicotine in particulate phase of mainstream cigarette smoke.

The content of free-base nicotine in cigarette smoke is a controversial subject, partly due to methodological issues. In this investigation, an improved method to measure free-base nicotine in cigarette smoke using headspace solid-phase microextraction (HS-SPME) combined with GC/MS analysis, was developed and validated for this purpose. Cigarette smoke particulate phase (PP) was collected onto a 44mm glass fiber filter pad. The pad was cut in halves with one half used to determine the concentrations of total nicotine and water. The remaining half was analyzed by HS-SPME for free-base nicotine. The following factors were found to have a significant impact on the responses of free-base nicotine: SPME fiber type, pre-equilibrium time before HS-SPME, extraction time and temperature, PP water content, and the solvent used for the preparation of standards. It was also found that the impact of PP water content on the determination of free-base nicotine from smoke sample could be corrected by a water correction factor calculated based on an experimentally determined reciprocal model. The precision of the method was evaluated with smoke samples of reference cigarettes: Canadian flue-cured monitor and Kentucky reference 2R4F. The RSD values obtained were in the 12.8-16.8% range.

Quantitative method for the analysis of tobacco-specific nitrosamines in cigarette tobacco and mainstream cigarette smoke by use of isotope dilution liquid chromatography tandem mass spectrometry.

An improved liquid chromatography tandem mass spectrometry (LC-MS/MS) method has been developed for the determination of tobacco specific nitrosamines (TSNA). It utilizes four stable isotope-labeled internal standards instead of two as reported by others. A separate internal standard for each analyte is required to minimize sample matrix effects on each analyte, which can lead to poor analyte recoveries and decreases in method accuracy and precision if only one or two of the internal standards are used, especially for complex sample matrixes and when no sample cleanup steps are performed as in this study. In addition, two ion-transition pairs (instead of one) are used for each analyte for the confirmation and quantification, further enhancing the method's accuracy and robustness. These improvements have led to a new LC-MS/MS method that is faster, more sensitive, and selective than the traditional methods and more accurate and robust than the published LC-MS/MS methods. The linear range of the method was from 0.2 to 250 ng/mL with a limit of detection of each TSNA varied from 0.027 to 0.049 ng/mL. Good correlations between the results obtained by the new method and the traditional method were observed for the samples studied.

Effect of smoking conditions and methods of collection on the mutagenicity and cytotoxicity of cigarette mainstream smoke.

There is a history for the use of in vitro bioassays to assess the toxicological properties of mainstream cigarette smoke (MSS). The results described in the literature were, for the most part, obtained with MSS collected under Federal Trade Commission (FTC) or International Organization for Standardization (ISO) conditions. However, numerous studies have shown that smokers smoke their cigarettes more intensely (e.g., they take larger puffs and/or more frequent puffs and/or partially occlude filter ventilation) than they are smoked on smoking machines operated under FTC (or ISO) conditions. It has also been reported that MSS composition changes with changes in smoking conditions. Furthermore, some governmental agencies have adopted regulations that specify more intensive protocols (i.e., Health Canada Intensive, HCI) for the collection of MSS for in vitro toxicological assays. Consequently, the performance of the Ames assay (TA98+S9, TA100+S9) and neutral red uptake assay under ISO and HCI protocols was studied with two blended (KR1R4F/KR2R4F, KR1R5F) and one flue-cured (CIM-7) reference cigarettes. The main outcome was when results were reported on a per milligram TPM (that portion of the mainstream smoke which is trapped in the smoke trap, expressed as milligrams per cigarette) basis generated under ISO conditions was more mutagenic and more cytotoxic than was TPM generated under HCI conditions. However, the decrease in biological activity could not be explained only by the increased in the water content of the TPM on going from ISO to HCI smoking conditions, and the results may be influenced by differences in smoke chemistry as a result of differing smoke collection systems.

Determination of S-phenylmercapturic acid in human urine using an automated sample extraction and fast liquid chromatography-tandem mass spectrometric method.

S-phenylmercapturic acid is widely accepted as a specific biomarker for the evaluation of benzene exposure. Here, we describe a fast, specific and sensitive high-performance liquid achromatography coupled with tandem mass spectrometry (LC-MS/MS) method that has been developed and validated for the determination of S-phenylmercapturic acid in human urine. Isotope-labeled S-phenylmercapturic acid-d5 was used as internal standard to improve the method ruggedness. The fully automated solid-phase extraction method on a 96-well Oasis MAX (mix-mode anion exchange) plate was employed to clean up the urine samples before analysis. The rapid LC-MS/MS analysis of extracted samples was achieved on a Genesis C18 column with a run time of only 3 min. Negative electrospray ionization with multiple reaction monitoring (ESI-MRM) mode was used to detect S-phenylmercapturic acid (m/z 238 --> 109) and S-phenylmercapturic acid -d5 (m/z 243 --> 114). The method fulfils all the standard requirements of method validation. The calibration curve was linear within the concentration range 0.400-200 ng/mL. The method performed accurately and precisely in validation with <7.5% relative error and <6.5% relative standard deviation of quality control samples. The method efficacy was also verified by the analysis of urine samples from 12 smokers and 12 non-smokers. With the fully automated sample cleanup procedure and the fast LC-MS/MS analysis, a sample analysis throughput of 384 samples per day could be achieved.

The use of chemical derivatization to enhance liquid chromatography/tandem mass spectrometric determination of 1-hydroxypyrene, a biomarker for polycyclic aromatic hydrocarbons in human urine.

This article presents an analytical approach that used chemical derivatization to enhance mass spectrometric (MS) response in electrospray ionization (ESI) mode of 1-hydroxypyrene (1-OHP), a commonly used biomarker to monitor human exposure to polycyclic aromatic hydrocarbons (PAHs). The enhancement successfully enabled the desired detection of 50 pg/mL in human urine. The introduction of an MS-friendly dansyl group to 1-OHP enhanced both ionization efficiency in the ESI source and collision-activated dissociation (CAD) in the collision cell. The response increase was estimated to be at least 200-fold, and enabled the reduction of sample size to only 100 microL. The selective MS detection also facilitated a fast (run time 3 min) liquid chromatography (LC) method which successfully resolved the analyte and interferences. The sample processing procedure included enzymatic hydrolysis of glucuronide and sulfate conjugates, liquid-liquid extraction, derivatization with dansyl chloride and a final liquid-liquid extraction to generate clean extracts for LC/MS/MS analysis. This approach has been validated as sensitive, linear (50-1000 pg/mL), accurate and precise for the quantitation of 1-OHP in human urine. This is the first report of using chemical derivatization to enhance MS/MS detection with fast chromatography in the determination of 1-OHP in human urine.

The role of the anion in the reaction of reducing sugars with ammonium salts.

Reactions of reducing sugars with ammonia and its compounds are important commercially, particularly in the preparation of flavors and caramel colors. However, such reactions generally produce a complex series of products ranging from simple molecules to complex polymeric materials, particularly since commercial systems generally involve mixtures of sugars as opposed to single sugars. This complexity has made understanding the mechanisms of such reactions difficult. Therefore, investigatory work has generally been focused on model systems. Herein we report one such study with model systems: the effects of the nature of the anion of the reactions of reducing sugars with ammonium salts. D-Glucose was reacted in aqueous solution with each of the following ammonium salts: acetate, bicarbonate, carbonate, chloride, citrate, formate, monohydrogenphosphate (DAP), sulfate, and sulfite. These reactions were carried out in a Parr bomb at 93 degrees C for 2.5 h. The initial pH of the reaction mixtures was adjusted to pH 8.0 at 25 degrees C. The resulting mixtures were analyzed by LC-MS, and the results were analyzed by comparing the product yields and distributions with those obtained with DAP. The major reaction product of interest was 2,6-deoxyfructosazine, as it had been shown to be a marker for the polymeric material formed from such reactions. It was found that ammonium salts of weak acids were much more effective in effecting the desired reactions than were those of strong acids; however, none was as effective as DAP.