RESUMEN
This article introduces an eco-friendly method for the reclamation of carbon fiber-reinforced polymers (CFRP). The research project involved numerous experiments using microwave-assisted pyrolysis (MAP) to explore a range of factors, such as the inert gas flow, the power level, the On/Off frequency of rotation, and the reaction duration. To design the experiments, the three-level Box-Behnken optimization tool was employed. To determine the individual and combined effects of the input parameters on the thermal decomposition of the resin, the data were analyzed using least-squares variance adjustment. The results demonstrate that the models developed in this study were successful in predicting the direct parameters of influence in the microwave-assisted decomposition of CFRPs. An optimal set of operating conditions was found to be the maximum nitrogen flow (2.9 L/min) and the maximum operating experimental power (914 W). In addition, it was observed that the reactor vessel's On/Off rotation frequency and that increasing the reaction time beyond 6 min had no significant influence on the resin elimination percentage when compared to the two other parameters, i.e., power and carrier gas flow rate. Consequently, the above-mentioned conditions resulted in a maximum resin elimination percentage of 79.6%. Following successful MAP, various post-pyrolysis treatments were employed. These included mechanical abrasion using quartz sand, chemical dissolution, thermal oxidative treatment using a microwave (MW) applicator and thermal oxidative treatment in a conventional furnace. Among these post-treatment techniques, thermal oxidation and chemical dissolution were found to be the most efficient methods, eliminating 100% of the carbon black content on the surface of the recovered carbon fibers. Finally, SEM evaluations and XPS analysis were conducted to compare the surface morphology and elementary constitution of the recovered carbon fibers with virgin carbon fibers.
RESUMEN
We have analyzed human genomic diversity in 32 individuals representing four continental populations of Homo sapiens in the context of four ape species. We used DNA resequencing chips covering 898 expressed sequence tags (ESTs), corresponding to 109 kb of sequence. Based on the intra-species data, the neutral hypothesis could not be rejected. However, the mutation rate was two times lower than typically observed in functionally unconstrained genomic segments, suggesting a certain level of selection. The worldwide diversity (297 segregating sites and nucleotide diversity of 0.054%) was partitioned among continents, with the greatest amount of variation observed in the African sample. The long-term effective population size of the human population was estimated at 13,000; a similar figure was obtained for the African sample and a 20% lower estimate was obtained for the other continents. Africans also differed in having a higher number of continental-specific polymorphisms contributing to the higher average nucleotide diversity. These results are consistent with the existence of two distinct lineages of modern humans: amalgamation of these lineages in Africa led to the higher present-day diversity on that continent, whereas colonization of other continents by one of them gave the effect of a population bottleneck.