Exploring the Physicochemical, Mechanical, and Photocatalytic Antibacterial Properties of a Methacrylate-Based Dental Material Loaded with ZnO Nanoparticles.

While resin-based materials meet the many requirements of a restorative material, they lack adequate, long-lasting antimicrobial power. This study investigated a zinc oxide nanoparticle (ZnO NP)-loaded resin-blend (RB) toward a new antimicrobial photodynamic therapy (aPDT)-based approach for managing dental caries. The results confirmed that up to 20 wt% ZnO NPs could be added without compromising the degree of conversion (DC) of the original blend. The DC achieved for the 20 wt% ZnO NP blend has been the highest reported. The effects on flexural strength (FS), shear bond strength to dentin (SBS), water sorption (WS), solubility (SL), and viability of Streptococcus mutans under 1.35 J/cm2 blue light or dark conditions were limited to ≤20 wt% ZnO NP loading. The addition of up to 20 wt% ZnO NPs had a minimal impact on FS or SBS, while a reduction in the bacteria count was observed. The maximum loading resulted in an increase in SL. Furthermore, 28-day aging in 37 °C water increased the FS for all groups, while it sustained the reduction in bacteria count for the 20 wt% resin blends. Overall, the ZnO NP-loaded resin-based restorative material presents significant potential for use in aPDT.

The antimicrobial, physical, and chemical properties of a riboflavin-loaded dental resin intended for antimicrobial photodynamic therapy.

BACKGROUND: Dental caries remain a significant global health challenge. Unfortunately, current dental materials lack sufficient antimicrobial power to address the pathogenic species involved in this disease. In this study the potential to load a dental resin blend (RB) with riboflavin (B2) for use in an antimicrobial photodynamic therapy (aPDT) approach was investigated. METHODS: B2 was added to our experimental RB (0.1 - 10 wt%). Upon investigating the degree of conversion and specimen integrity of the RB as a function of B2 concentration, it was determined that loading should be restricted to 0.1, 1.0, and 1.5 wt%. Subsequent investigation included water sorption (WS) and solubility (SL), as well as shear bond strength (SBS) and flexural strength (FS) of the specimens after 24 h and 28-day water storage. Lastly, the antimicrobial response of Streptococcus mutans (S. mutans) biofilm following 6 h growth and 60 s of blue LED light (1.3 J/cm2) in an aPDT-based approach was measured. RESULTS AND CONCLUSIONS: Adding up to 1.5 wt% B2 had minimal impact on the FS or SBS of the RB. However, aging for 28-days notably increased the FS by as much as 50% for the 1.5 wt% B2-loaded RB. In addition, adding 1.5 wt% B2 resulted in a significant reduction in WS/SL of the RB. Lastly, while adding B2 did not change the antimicrobial response, this was an initial study under these conditions and future investigation will seek to optimize light parameters to produce a more agonistic response. Overall, a riboflavin-loaded dental resin shows significant promise for utilization in restorative dentistry with aPDT.

Nonlocal Uniform-Mode Ferromagnetic Resonance Spin Pumping.

Nonlocal spin transport using lateral structures is attractive for spintronic devices. Typically, a spin current is generated by a ferromagnetic (FM) or a heavy metal (HM) electrode in a nonlocal structure, which can be detected by another FM or HM electrode. Here, we report a new nonlocal spin injection scheme using uniform-mode ferromagnetic resonance (FMR) spin pumping in Pt/Y3Fe5O12 (YIG) lateral structures. This scheme is enabled by well-separated resonant fields of Pt/YIG and bare YIG due to substantial change of anisotropy in YIG films induced by a Pt overlayer, allowing for clearly distinguishable local and nonlocal spin pumping. Our results show that the spin decay length of nonlocal uniform-mode spin pumping in 20 nm YIG films is 2.1 µm at room temperature.

Interfacial Rashba-Effect-Induced Anisotropy in Nonmagnetic-Material-Ferrimagnetic-Insulator Bilayers.

Interfacial magnetic anisotropy in magnetic insulators has been largely unexplored. Recently, interface-induced skyrmions and electrical control of magnetization have been discovered in insulator-based heterostructures, which demand a thorough understanding of interfacial interactions in these materials. We observe a substantial, tunable interfacial magnetic anisotropy between Tm_{3}Fe_{5}O_{12} epitaxial thin films and fifteen nonmagnetic materials spanning a significant portion of the periodic table, which we attribute to Rashba spin-orbit coupling. Our results show a clear distinction between nonmagnetic capping layers from the d block and the p block. This work offers a new path for controlling magnetic phases in magnetic insulators for low-loss spintronic applications.

Investigation of the Role of Rare-Earth Elements in Spin-Hall Topological Hall Effect in Pt/Ferrimagnetic-Garnet Bilayers.

Topological magnetic textures such as skyrmions are being extensively studied for their potential application in spintronic devices. Recently, low-damping ferrimagnetic insulators (FMI) such as Tm3Fe5O12 have attracted significant interest as potential candidates for hosting skyrmions. Here, we report the detection of the spin-Hall topological Hall effect (SH-THE) in Pt/Tm3Fe5O12 and Pt/Y3Fe5O12 bilayers grown on various orientations of Gd3Ga5O12 substrates as well as on epitaxial buffer layers of Y3Sc2Al3O12, which separates the FMI from the substrate without sacrificing the crystal quality. The presence of SH-THE in all of the bilayers and trilayers provides evidence that rare-earth ions in either the FMI or substrate may not be critical for inducing an interfacial Dzyaloshinskii-Moriya interaction that is necessary to stabilize magnetic textures. Additionally, the use of substrates with various crystal orientations alters the magnetic anisotropy, which shifts the temperatures and strength of the SH-THE.

Probing the Source of the Interfacial Dzyaloshinskii-Moriya Interaction Responsible for the Topological Hall Effect in Metal/Tm_{3}Fe_{5}O_{12} Systems.

The interfacial Dzyaloshinskii-Moriya interaction (DMI) is responsible for the emergence of topological spin textures such as skyrmions in layered structures based on metallic and insulating ferromagnetic films. However, there is active debate on where the interfacial DMI resides in magnetic insulator systems. We investigate the topological Hall effect, which is an indication of spin textures, in Tm_{3}Fe_{5}O_{12} films capped with various metals. The results reveal that Pt, W, and Au induce strong interfacial DMI and topological Hall effect, while Ta and Ti cannot. This study also provides insights into the mechanism of electrical detection of spin textures in magnetic insulator heterostructures.

Outcomes for urologic oncology procedures: are there differences between academic and community hospitals?

OBJECTIVE: To compare the rate of hospital-based outcomes including costs, 30-day readmission, mortality, and length of stay in patients who underwent major urologic oncologic procedures in academic and community hospitals. METHODS: We retrospectively reviewed the Vizient Database (Irving, Texas) from September 2014 to December 2017. Vizient includes ~ 97% of academic hospitals (AH) and more than 60 community hospitals (CH). Patients aged ≥ 18 with urologic malignancies who underwent surgical treatment were included. Chi square and Student t tests were used to compare categorical and continuous variables, respectively. RESULTS: We identified a total of 37,628 cases. There were 33,290 (88%) procedures performed in AH and 4330 (12%) in CH. These included prostatectomy (18,540), radical nephrectomy (rNx) 8059, partial nephrectomy (pNx) (5287), radical cystectomy (4421), radical nephroureterectomy (rNu) (1006), and partial cystectomy (321). There were no significant differences in 30-day readmission rates or mortality for any procedure between academic and community hospitals (Table 1), p > 0.05 for all. Length of stay was significantly lower for radical cystectomy and prostatectomy in AH (p < 0.01 for both) and lower for rNx in CH (p = 0.03). The mean direct cost for index admission was significantly higher in AH for rNx, pNx, rNu, and prostatectomy. Case mix index was similar between the community and academic hospitals. CONCLUSION: Despite academic and community hospitals having similar case complexity, direct costs were lower in community hospitals without an associated increase in readmission rates or deaths. Length of stay was shorter for cystectomy in academic centers.

Spin-Hall Topological Hall Effect in Highly Tunable Pt/Ferrimagnetic-Insulator Bilayers.

Electrical detection of topological magnetic textures such as skyrmions is currently limited to conducting materials. Although magnetic insulators offer key advantages for skyrmion technologies with high speed and low loss, they have not yet been explored electrically. Here, we report a prominent topological Hall effect in Pt/Tm3Fe5O12 bilayers, where the pristine Tm3Fe5O12 epitaxial films down to 1.25 unit cell thickness allow for tuning of topological Hall stability over a broad range from 200 to 465 K through atomic-scale thickness control. Although Tm3Fe5O12 is insulating, we demonstrate the detection of topological magnetic textures through a novel phenomenon: "spin-Hall topological Hall effect" (SH-THE), where the interfacial spin-orbit torques allow spin-Hall-effect generated spins in Pt to experience the unique topology of the underlying skyrmions in Tm3Fe5O12. This novel electrical detection phenomenon paves a new path for utilizing a large family of magnetic insulators in future skyrmion technologies.

Metallic ferromagnetic films with magnetic damping under 1.4 × 10-3.

Low-damping magnetic materials have been widely used in microwave and spintronic applications because of their low energy loss and high sensitivity. While the Gilbert damping constant can reach 10-4 to 10-5 in some insulating ferromagnets, metallic ferromagnets generally have larger damping due to magnon scattering by conduction electrons. Meanwhile, low-damping metallic ferromagnets are desired for charge-based spintronic devices. Here, we report the growth of Co25Fe75 epitaxial films with excellent crystalline quality evident by the clear Laue oscillations and exceptionally narrow rocking curve in the X-ray diffraction scans as well as from scanning transmission electron microscopy. Remarkably, the Co25Fe75 epitaxial films exhibit a damping constant <1.4 × 10-3, which is comparable to the values for some high-quality Y3Fe5O12 films. This record low damping for metallic ferromagnets offers new opportunities for charge-based applications such as spin-transfer-torque-induced switching and magnetic oscillations.Owing to their conductivity, low-damping metallic ferromagnets are preferred to insulating ferromagnets in charge-based spintronic devices, but are not yet well developed. Here the authors achieve low magnetic damping in CoFe epitaxial films which is comparable to conventional insulating ferromagnetic YIG films.