Theoretical investigations on microwave Fano resonances in 3D-printable hollow dielectric resonators.

High-index dielectric structures have recently been studied intensively for Mie resonances at optical frequencies. These dielectric structures can enable extreme light manipulation, similar to that which has been achieved with plasmonic nanostructures. In the microwave region, dielectric resonators and metamaterials can be fabricated directly using 3D printing, which is advantageous for fabricating structurally complicated 3D geometries. It is therefore especially suitable for the fabrication of subwavelength structures. Here we report theoretical investigations on microwave Fano resonances in 3D-printable dielectric materials and structures. In particular, we propose and analyse 3D-printable, hollow, dielectric resonators with relatively low refractive indices, which exhibit sharp Fano resonances. We can control the interaction between bright and dark modes in a coupled dielectric particle pair by adjusting the inner-hole size, and thus we can increase the radiative Q factors further. We also find that Fano resonances in these hollow dielectric resonators are very sensitive to an index change in the surrounding medium, which could be useful for long-distance environmental sensing. New possibilities and opportunities are opening up with the rapid development of 3D-printing technologies. Our findings and the detailed investigations reported here can provide useful guidelines for future photonic devices based on 3D-printable materials and structures.

Active switching and tuning of sharp Fano resonances in the mid-infrared spectral region.

We propose and analyze a scheme for active switching and spectral tuning of mid-infrared Fano resonances. We consider dielectric resonators made of semiconductor cylinder arrays and block pairs, and theoretically investigate their optical response change due to carrier generation. Owing to sharp optical resonances in these structures and large dielectric constant variations with carrier densities, the significant spectral tuning of Fano resonances is achievable. Furthermore, selective optical pumping in coupled semiconductor structures can even enable dynamic switching of Fano resonances. This leads to a drastic change in the scattering spectra as well as in the near-field intensity. We also observe a stark difference between Fano resonances in cylinder arrays and block pairs. To understand this unusual behavior, we adopt the two coupled oscillator model, and extract the relevant Fano resonance parameters that explain this difference. Our findings and in-depth analyses can be useful for molecular sensors and switching devices in the technologically important mid-infrared spectral region.

Incident light adjustable solar cell by periodic nanolens architecture.

Could nanostructures act as lenses to focus incident light for efficient utilization of photovoltaics? Is it possible, in order to avoid serious recombination loss, to realize periodic nanostructures in solar cells without direct etching in a light absorbing semiconductor? Here we propose and demonstrate a promising architecture to shape nanolenses on a planar semiconductor. Optically transparent and electrically conductive nanolenses simultaneously provide the optical benefit of modulating the incident light and the electrical advantage of supporting carrier transportation. A transparent indium-tin-oxide (ITO) nanolens was designed to focus the incident light-spectrum in focal lengths overlapping to a strong electric field region for high carrier collection efficiency. The ITO nanolens effectively broadens near-zero reflection and provides high tolerance to the incident light angles. We present a record high light-conversion efficiency of 16.0% for a periodic nanostructured Si solar cell.

Capturing wetting states in nanopatterned silicon.

Spectacular progress in developing advanced Si circuits with reduced size, along the track of Moore's law, has been relying on necessary developments in wet cleaning of nanopatterned Si wafers to provide contaminant free surfaces. The most efficient cleaning is achieved when complete wetting can be realized. In this work, ordered arrays of silicon nanopillars on a hitherto unexplored small scale have been used to study the wetting behavior on nanomodulated surfaces in a substantial range of surface treatments and geometrical parameters. With the use of optical reflectance measurements, the nanoscale water imbibition depths have been measured and the transition to the superhydrophobic Cassie-Baxter state has been accurately determined. For pillars of high aspect ratio (about 15), the transition occurs even when the surface is grafted with a hydrophilic functional group. We have found a striking consistent deviation between the contact angle measurements and the straightforward application of the classical wetting models. Molecular dynamics simulations show that these deviations can be attributed to the long overlooked atomic-scale surface perturbations that are introduced during the nanofabrication process. When the transition condition is approached, transient states of partial imbibition that characterize intermediate states between the Wenzel and Cassie-Baxter states are revealed in our experiments.

Surface-concentrated light and efficient carrier collection in microhole-patterned Si solar cells.

We investigate photovoltaic characteristics of crystalline Si solar cells with microhole-patterned surface. We compare patterned samples with different hole-widths and periods with a planar counterpart. From the finite-difference time-domain simulation, the patterned and planar samples are expected to have similar short circuit current density, J(sc) (difference: 1.2%). In contrast, the difference in the measured J(sc) is as large as 12.6%. The simulated optical field patterns reveal that the sample with more significantly concentrated light near the surface has higher quantum efficiency due to more efficient carrier collection. We report the highest efficiency of 15.6% among the hole-patterned solar cells.

Surface-plasmon-enhanced visible-light emission of ZnO/Ag grating structures.

We investigated the optical properties of ZnO/Ag grating structures fabricated by sputtering and nanoimprint lithography. The grating structures exhibited multiple peak features in broad visible-range photoluminescence (PL) spectra. The PL intensity of the grating was larger than that of a planar thin film by up to two orders of magnitude. The surface plasmon (SP) dispersion relation suggested excitation of SPs with various energies of the grating, explaining the broad PL emission. The spectral dependence of the PL intensity was also well supported by the experimental reflectance spectra and the simulated electric field distribution at the ZnO/Ag interface.

Individual Pd nanowire hydrogen sensors fabricated by electron-beam lithography.

We report on the hydrogen gas (H2) sensing performance of lithographically patterned Pd nanowires as a function of the nanowire thickness and H2 concentration. A combination of electron-beam lithography and a lift-off process has been utilized to fabricate four-terminal devices based on individual Pd nanowires with width w = 300 nm, length l = 10 microm, and thickness t = 20-400 nm from continuous Pd films. The variation of the resistance and sensitivity at 20 000 ppm H2 of Pd nanowires was found to be much lager than at 10 000 ppm H2, which can be explained by an alpha-beta phase transition occurring at 20 000 ppm H2. This is confirmed by the observation of hysteresis behavior in the resistance versus H2 concentration for Pd thin films. The response time was found to decrease with decreasing thickness regardless of H2 concentration due to a higher surface-to-volume ratio and a higher clamping effect. A single Pd nanowire with t = 100 nm was found to successfully detect H2 at a detection limit of 20 ppm. Our results suggest that lithographically patterned Pd nanowires can be used as hydrogen gas sensors to quantitatively detect H2 over a wide range of concentrations.

Finite size effect on hydrogen gas sensing performance in single Pd nanowires.

We present the hydrogen sensing performance of individual Pd nanowires grown by electrodeposition into nanochannels of anodized aluminum oxide (AAO) templates investigated as a function of the nanowire diameter. Four-terminal devices based on individual Pd nanowires were found to successfully detect hydrogen gas (H(2)). Our experimental results show that the H(2) sensing sensitivity increases and the response time decreases with decreasing diameter of Pd nanowires with d = 400, 200, 80 and 20 nm, due to the high surface-to-volume ratio and short diffusion paths, respectively. This is in qualitatively good agreement with simulated results obtained from a theoretical model based on a combination of the rate equation and diffusion equation.