Scintillation characteristics of chemically processed Ce:GAGG single crystals.

We investigated the correlation between the surface finish and luminescence properties of chemically polished cerium-doped single-crystal Gd3Al2Ga3O12 scintillators (Ce:GAGG), from the crystallographic perspective. The intrinsic defects in the crystals were identified via photoluminescence spectroscopy followed by scanning electron microscopy and X-ray diffraction to analyze their surface morphologies. Finally, the samples were individually wrapped with an enhanced specular reflector (ESR), coupled with a photomultiplier tube, placed inside a dark box, connected to a digitizer, and irradiated with a 137Cs radioactive source to evaluate the relative light (signal) output and energy resolution of each sample. The as-cut (rough) Ce:GAGG single-crystal samples, that were chemically polished with phosphoric acid at 190°C in air for 60 min, demonstrated a 33.1% increase in signal amplitude (light output to photosensor) and 2.4% (absolute value) improvement in energy resolution, which were comparable to those obtained for the mechanically polished sample. For these samples, the surface roughness was found to be ~430 nm, which was approximately half of that of the mechanically polished sample. The chemical polishing method used in this study is a cost-effective and straightforward technique to improve structural imperfections and can facilitate the treatment of inorganic scintillators with complex shapes and/or on a large scale.

Enhancement of the luminescent and optical properties of ceramic Ce:GAGG after surface treatment with phosphoric acid.

Surface modification of ceramic Ce-doped Gd3Al2Ga3O12 (Ce:GAGG) was performed by exposing small samples to anhydrous phosphoric acid (H3PO4) under different conditions (temperature and duration) to investigate the effects of chemical polishing treatment. When coupled to a photomultiplier tube (PMT) and used as a radiation detector, chemical treatment for 3 min at 190 °C improved the light (signal) output by 24.8% and energy resolution by 2.5% (percentage point), respectively. This can be attributed to a reduction in surface roughness that enhanced optical properties. Thus, chemical polishing could be a low-cost alternative to mechanical polishing especially for small or complex shaped ceramic scintillators.