Sorption equilibria of ethanol on cork.

We report here for the first time a thermodynamic study of gaseous ethanol sorption on raw cork powder and plate. Our study aims at a better understanding of the reactivity of this material when used as a stopper under enological conditions, thus in close contact with a hydroethanolic solution, wine. Sorption−desorption isotherms were accurately measured by thermogravimetry at 298 K in a large range of relative pressures. Sorption enthalpies were determined by calorimetry as a function of loading. Sorption−desorption isotherms exhibit a hysteresis loop probably due to the swelling of the material and the absorption of ethanol. Surprisingly, the sorption enthalpy of ethanol becomes lower than the liquefaction enthalpy as the filling increases. This result could be attributed to the swelling of the material, which would generate endothermic effects. Sorption of SO2 on cork containing ethanol was also studied. When the ethanol content in cork is 2 wt %, the amount of SO2 sorbed is divided by 2. Thus, ethanol does not enhance the sorption rate for SO2 but, on the contrary, decreases the SO2 sorption activity onto cork, probably because of competitive sorption mechanisms.

Dry vs soaked wood: modulating the volatile extractible fraction of oak wood by heat treatments.

The aim of this study was to analyze the impact of the water content of wood on the concentrations of volatile compounds which can be extracted after heat treatments. Head Space-Solid Phase Micro Extraction Gas Chromatography coupled to Mass Spectrometry (HS-SPME GC-MS) has been used to compare the concentrations of six aroma compounds (vanillin, furfural, eugenol, guaïacol and cis- and trans-whisky lactones) in hydroalcoholic extracts of heated oak wood samples either previously soaked in hot water or not. Except for eugenol, concentrations of extracted aromas appeared to be lower in soaked woods than in dry woods for temperatures up to 200 °C. If a delaying effect of water could explain such overall lower extracted concentrations from soaked woods, a PCA analysis revealed that for the longer duration (25 min of heat treatment), the adsorbed water could promote a higher impact of furfural, eugenol and both whisky lactones on the composition of hydroalcoholic extracts, suggesting that alternative mechanisms of thermal modifications of the wood macromolecular network could exist at high temperatures in presence of adsorbed water.

Diffusion of oxygen in cork.

This work reports measurements of effective oxygen diffusion coefficient in raw cork. Kinetics of oxygen transfer through cork is studied at 298 K thanks to a homemade manometric device composed of two gas compartments separated by a cork wafer sample. The first compartment contains oxygen, whereas the second one is kept under dynamic vacuum. The pressure decrease in the first compartment is recorded as a function of time. The effective diffusion coefficient D(eff) is obtained by applying Fick's law to transient state using a numerical method based on finite differences. An analytical model derived from Fick's law applied to steady state is also proposed. Results given by these two methods are in close agreement with each other. The harmonic average of the effective diffusion coefficients obtained from the distribution of 15 cork wafers of 3 mm thickness is 1.1 × 10(-9) m(2) s(-1) with a large distribution over four decades. The statistical analysis of the Gaussian distribution obtained on a 3 mm cork wafer is extrapolated to a 48 mm cork wafer, which length corresponds to a full cork stopper. In this case, the probability density distribution gives a mean value of D(eff) equal to 1.6 × 10(-9) m(2) s(-1). This result shows that it is possible to obtain the effective diffusion coefficient of oxygen through cork from short time (few days) measurements performed on a thin cork wafer, whereas months are required to obtain the diffusion coefficient for a full cork stopper. Permeability and oxygen transfer rate are also calculated for comparison with data from other studies.

Adsorption equilibria of water vapor on cork.

We report here for the first time a complete thermodynamic study of water vapor adsorption on crude cork powder and plate. Adsorption-desorption isotherms were accurately measured by thermogravimetry at 283, 298, and 313 K in a large range of relative pressure. Adsorption enthalpies were determined by calorimetry as a function of loading. Adsorption-desorption isotherms exhibit a hysteresis due to the swelling of the material. The influence of the presence of lenticels on the adsorption properties of cork is found to be negligible. A detailed analysis and interpretation of adsorption data allow proposal of an adsorption mechanism in two steps. (i) First, water adsorbs on hydrophilic sites constituted by hydroxyl and methoxyl groups. (ii) Then water adsorption continues by clusters formation around the hydrophilic sites.

Tracer aroma compound transfer from a solid and complex-flavored food matrix packed in treated papers or plastic packaging film.

The objective of this work was to study the transfer of four aroma compounds (ethyl butyrate, ethyl hexanoate, cis-3-hexenol, and benzaldehyde) from a solid and complex-flavored food matrix (sponge cake) toward and through packaging films placed in indirect contact during storage in accelerated aging conditions (38 degrees C and 86% relative humidity gradient). The efficiency of treated papers relative to that of standard paper and plastic as barrier was tested. Before storage, aroma compound volatility in the sponge cake was measured, and similar values were found between aroma compounds, due to the fat content of the sponge cake. Whatever the aroma compound, permeability values during storage were similar for the same packaging film. The plastic film was the highest barrier, whereas calendering and coating treatments applied to treated papers decreased effectively their permeability. An opposite trend was observed for aroma compound sorption into packaging films during storage.