RESUMEN
We report and discuss high-flux generation of circularly polarized γ-rays by means of Compton scattering. The γ-ray beam results from the collision of an external-cavity-enhanced infrared laser beam and a low emittance relativistic electron beam. By operating a non-planar bow-tie high-finesse optical Fabry-Perot cavity coupled to a storage ring, we have recorded a flux of up to (3.5 ± 0.3) × 108 photons per second with a mean measured energy of 24 MeV. The γ-ray flux has been sustained for several hours. In particular, we were able to measure a record value of up to 400 γ-rays per collision in a full bandwidth. Moreover, the impact of Compton scattering on the electron beam dynamics could be observed resulting in a reduction of the electron beam lifetime correlated to the laser power stored in the Fabry-Perot cavity. We demonstrate that the electron beam lifetime provides an independent and consistent determination of the γ-ray flux. Furthermore, a reduction of the γ-ray flux due to intrabeam scattering has clearly been identified. These results, obtained on an accelerator test facility, warrant potential scaling and revealed both expected and yet unobserved effects. They set the baseline for further scaling of the future Compton sources under development around the world.
RESUMEN
Optimization of Yb-free Er-doped fiber for lasers and amplifiers cladding pumped at 976 nm was performed in this Letter. The single-mode fiber design includes an increased core diameter of 34 µm and properly chosen erbium and co-dopant concentrations. We demonstrate an all-fiber high power laser and power amplifier based on this fiber with the record slope efficiency of 40%. To the best of our knowledge, the achieved output power of 75 W is the highest power reported for such lasers.
Asunto(s)
Erbio , Rayos Láser , Fibras ÓpticasRESUMEN
We report on high-energy femtosecond pulse generation from an ytterbium-doped rod-type fiber oscillator emitting around 976 nm. Self-starting and stable single-pulse operation are demonstrated with 4.2 W of average output power at a repetition rate of 8.4 MHz. The resulting energy level reaches 0.5 µJ. Because of the all-normal dispersion of the laser cavity, output pulses are naturally chirped with a duration of 14 ps. External compression using diffraction gratings shortens the pulse duration down to 460 fs.
RESUMEN
A very compact and innovative pulse shaper is proposed and demonstrated. The standard architecture for pulse shaping that is composed of diffraction gratings associated with an amplitude-phase spatial light modulator (SLM) is replaced by a single phase-only SLM. It acts as a pulse stretcher and as an amplitude and phase modulator at the same time. Preliminary experiments demonstrate the accurate control of amplitude and phase of shaped pulses.
RESUMEN
We report on a passively mode-locked fiber laser emitting around 976nm. The self-starting mode locking is achieved in an unidirectional ring cavity by means of nonlinear polarization evolution. Stable single-pulse operation is observed for 480mW of average output power. This all-normal dispersion laser generates naturally chirped pulses with 1ps duration. The repetition rate is 40.6MHz, resulting in 12nJ pulse energy. External compression using bulk grating shortens the pulse duration down to 286fs.
RESUMEN
We report co-phasing of 49 beams from a multicore fiber based on a spatial light modulator using a simple feedback loop control. A specific fiber of 7x7 Germanium doped cores was fabricated. The power carried by the far field main lobe of the phased array, in the continuous wave regime, amounts to 96% of its theoretical value. Femtoseconde pulses were also phase-locked with the same device configuration.