RESUMEN
To manage the interactions between wax and hydrate formation, a comprehensive understanding of the system's thermodynamics and flow characteristics is essential. Wax and hydrates coexist under low-temperature and high-pressure conditions, mutually influencing each other both thermodynamically and kinetically. This study focused on two main aspects: how wax affects the rate of hydrate formation in the oil-water system and how hydrate formation influences the thermodynamics of wax crystal precipitation. The presence of wax decreased the rate of hydrate formation, especially at higher wax contents. In systems with high wax content, over 70% of wax precipitated before hydrate formation, leading to less precipitation within the hydrate formation temperature range. With low water content, there were more nucleation sites for wax crystals in the oil phase, resulting in a greater difference in precipitation rates among different wax contents. For water content greater than 10%, the differences in precipitation rates were less significant, indicating a diminished effect of water content on wax crystal precipitation rates. Hydrates' hydrophilic nature had a limited impact on wax crystal nucleation and growth. Generally, wax crystals precipitate before hydrate formation, necessitating control measures for wax deposition during production processes.
RESUMEN
The enormous demand for petroleum consumption has resulted in the shortage of fossil resources, prompting the need to explore unconventional reservoirs. Polyacrylamide emulsion drag reducers are capable of inhibiting the turbulence of fracturing fluids for enhancing the reservoir stimulation results, but the poor dissolution efficiency of polyacrylamide emulsion drag reducers is the primary limitation to their large-scale application. Here, a pH-responsive ionic liquid surfactant, oleic acid/cyclohexanediamine (HOA/HMDA), is synthesized by using oleic acid (HOA) and cyclohexanediamine (HMDA). HOA/HMDA shows a remarkable pH-responsive behavior due to the pH-induced deconstruction of the HOA/HMDA structure. Interestingly, the HOA/HMDA-stabilized monomer emulsion exhibits an obvious pH-induced emulsion structure transformation behavior. In addition, the HOA/HMDA-stabilized monomer emulsion possesses excellent dynamic and storage stability, supporting the inverse emulsion polymerization of the polymer P(AM/AMPS/AA). The obtained P(AM/AMPS/AA) polymer inverse emulsions maintained stability for 30 days. Our finding proposes that the structure of the P(AM/AMPS/AA) polymer inverse emulsions changes with pH stimulation, which is capable of facilitating the release of polymers. P(AM/AMPS/AA) is released from the P(AM/AMPS/AA) polymer inverse emulsions within 30 s at a pH value of 12.06, along with a drag reduction rate of 62.54%. Obviously, the HOA/HMDA-stabilized P(AM/AMPS/AA) polymer inverse emulsions eliminate the contradiction between the stability and release of polyacrylamide emulsion drag reducers, which is promising for meeting the demands of reservoir stimulation.
RESUMEN
Gas hydrates have gained great interest in the energy and environmental field as a medium for gas storage and transport, gas separation, and carbon dioxide sequestration. The presence of small doses of surfactants in the aqueous phase has been reported to enhance hydrate formation; however, the underlying mechanisms remain poorly understood. Thus, in situ high-resolution X-ray computed tomography measurements were performed to monitor the upward water migration and the resulting hydrate nucleation and growth. It was found that the presence of hydrate crystals at the gas-liquid-solid contact line triggered the enhanced growth of hydrates on the reactor wall. A time delay was observed between the disappearance of the bulk water reservoir and its transformation into hydrate. The lower interfacial tension between the hydrate surface and the solution facilitated its adsorption onto the reactor wall once a thin film of hydrate nucleated on the solid wall surface. These hydrate layers present on the reactor wall were found to be porous, wherein the porosity decreased with increased subcooling. These fundamental results will be of value in understanding the mechanism of hydrate growth in the presence of surfactants and its potential application in hydrate-based technologies.