RESUMEN
Characterization of lignin and its degradation products, more specifically determination of their molecular weight (MW) distribution, is essential for assessment and applications of these potentially renewable phenolics. Several representative gel filtration and gel permeation systems were evaluated in this work focusing on understanding of undesired secondary non-SEC interactions while utilizing four sets of commercially available polymeric standards as well as low-MW lignin model compounds including diarene standards synthesized in-house. The gel permeation column with a nonpolar highly cross-linked porous polystyrene/divinylbenzene-based stationary phase provided the most effective separation by MW for both low and high MW model compounds. Notably, the column with a higher pore and lower particle size provided a better resolution towards polymeric standards, even though the particle size effect was downplayed in the earlier SEC studies of lignin. For two other evaluated gel filtration and gel permeation columns, the separation was strongly affected by functionalities of the analytes and correlated with the compounds' pKa rather than MW. We showed that the separation on the stationary phases featuring polar hydroxyl groups led to specific column-analyte secondary interactions, perhaps based on their hydrogen bonding with lignin. Further, the SEC column evaluation yielded similar results with two sets of chemically different standards. This setup may be used as a general approach to selecting an applicable column for lignin SEC analysis. We confirmed the obtained results with a different independent method implementing a novel approach for lignin number-average MW (Mn) calculation based on laser desorption/ionization time-of-flight mass spectrometry (LDI-TOF-MS) data. The determined Mn corroborated the SEC results.
