Photocatalytic Properties of Graphene/Gold and Graphene Oxide/Gold Nanocomposites Synthesized by Pulsed Laser Induced Photolysis.

Graphene (Gr)/gold (Au) and graphene-oxide (GO)/Au nanocomposites (NCPs) were synthesized by performing pulsed-laser-induced photolysis (PLIP) on hydrogen peroxide and chloroauric acid (HAuCl4) that coexisted with Gr or GO in an aqueous solution. A 3-month-long aqueous solution stability was observed in the NCPs synthesized without using surfactants and additional processing. The synthesized NCPs were characterized using absorption spectroscopy, transmission electron microscopy, Raman spectroscopy, energy dispersive spectroscopy, and X-ray diffraction to prove the existence of hybrid Gr/Au or GO/Au NCPs. The synthesized NCPs were further evaluated using the photocatalytic reaction of methylene blue (MB), a synthetic dye, under UV radiation, visible light (central wavelength of 470 nm), and full spectrum of solar light. Both Gr/Au and GO/Au NCPs exhibited photocatalytic degradation of MB under solar light illumination with removal efficiencies of 92.1% and 94.5%, respectively.

Composition of phenolic compounds and antioxidant attributes of Cyclea gracillima Diels extracts.

Cyclea gracillima Diels is a Taiwanese native medicinal herb. However, there are currently few relevant reports on its biochemical activity. In this study, the antioxidant attributes of the ethanol and hot water extracts of this herb were assayed using in vitro models, including the following: 2,2-diphenyl-1-(2,4,6-trinitrophenyl)-hydrazyl radical scavenging, Trolox equivalent antioxidant capacity, reducing power, and chelating ferrous ions. The following biochemical models were also assayed: inhibition of human low density lipoprotein oxidation, inhibition of human erythrocyte hemolysis, and scavenging oxygen radicals in human blood. The composition and content of flavonoids and phenolic acids in these extracts were also analyzed. The results showed that these extracts with high polyphenol levels presented remarkable antioxidant effects in all assays, especially when extracted with ethanol. Six phenolic acids (mainly ferulic acid, sinapic acid, and syringic acid) and 12 flavonoids (mainly narigenin, myricetin, naringin, and apigenin) were found in these extracts.

Effects of heat treatment on the antioxidative and anti-inflammatory properties of orange by-products.

This study investigated the changes in the functional components, antioxidative activities, antibacterial activities, anti-inflammatory activities of orange (Citrus sinensis (L.) Osbeck) by-products (OBP) on heat treatment at 50 and 100 °C (hereafter denoted 50D and 100D extracts, respectively). Optimal heating conditions were also investigated. The total phenolic content, flavonoid content and antioxidative activities of OBP extracts significantly increased on heat treatment. The lag time of Cu2+-induced oxidation of human LDL was increased by 2.61, 8.61 and 8.76-fold with the addition of 0.6, 0.8 and 1.0 mg ml-1 100D extracts, respectively. The 100D extracts may significantly inhibit the growth of E. coli O157, Salmonella typhimurium and Listeria monocytogenes. 1 µg mL-1 of 100D extract may suppress the TNF-α-induced ICAM-1 protein expression. The optimal heating time for OBP was 26 h at 100 °C, which resulted in the highest antioxidant activities.

Electrospinning Pullulan Fibers from Salt Solutions.

There is an increasing interest in applying the technology of electrospinning for making ultrafine fibers from biopolymers for food-grade applications, and using pullulan (PUL) as a carrier to improve the electrospinnability of proteins and other naturally occurring polyelectrolytes. In this study, PUL solutions containing NaCl or Na3C6H5O7 at different concentrations were electrospun. The inclusion of salts interrupted the hydrogen bonding and altered solution properties, such as viscosity, electric conductivity, and surface tension, as well as physical properties of fibers thus obtained, such as appearance, size, and melting point. The exogenous Na⁺ associated to the oxygen in the C6 position of PUL as suggested by FTIR measurement and was maintained during electrospinning. Bead-free PUL fibers could be electrospun from PUL solution (8%, w/v) in the presence of a 0.20 M NaCl (124 ± 34 nm) or 0.05 M Na3C6H5O7 (154 ± 36 nm). The further increase of NaCl or Na3C6H5O7 resulted in fibers that were flat with larger diameter sizes and defects. SEM also showed excess salt adhering on the surfaces of PUL fibers. Since most food processing is not carried out in pure water, information obtained through the present research is useful for the development of electrospinning biopolymers for food-grade applications.

Phenolic compositions and antioxidant attributes of leaves and stems from three inbred varieties of Lycium chinense Miller harvested at various times.

Antioxidant components and properties (assayed by scavenging DPPH radicals, TEAC, reducing power, and inhibiting Cu(2+)-induced human LDL oxidation) of leaves and stems from three inbred varieties of Lycium chinense Miller, namely ML01, ML02 and ML02-TY, harvested from January to April were studied. Their flavonoid and phenolic acid compositions were also analyzed by HPLC. For each variety, the leaves and stems collected in higher temperature month had higher contents of total phenol, total flavonoid and condensed tannin. Contents of these components in the samples collected in different months were in the order: April (22.3°C)>March (18.0°C)>January (15.6°C)>February (15.4°C). Antioxidant activities of the leaves and stems for all assays also showed similar trends. The samples from different varieties collected in the same month also possessed different phenolic compositions and contents and antioxidant activities. Their antioxidant activities were significantly correlated with flavonoid and phenolic contents.

Improving agar electrospinnability with choline-based deep eutectic solvents.

Very recently our group has produced novel agar-based fibers by an electrospinning technique using water as solvent and polyvinyl alcohol (PVA) as co-blending polymer. Here, we tested the deep eutectic solvent (DES), (2-hydroxyethyl)trimethylammonium chloride/urea prepared at 1:2 molar ratio, as an alternative solvent medium for agar electrospinning. The electrospun materials were collected with an ethanol bath adapted to a previous electrospinning set-up. One weight percent agar-in-DES showed improved viscoelasticity and hence, spinnability, when compared to 1 wt% agar-in-water and pure agar nanofibers were successfully electrospun if working above the temperature of sol-gel transition (∼80 °C). By changing the solvent medium we decreased the PVA concentration (5 wt% starting solution) and successfully produced composite fibers with high agar contents (50/50 agar/PVA). Best composite fibers were formed with the 50/50 and 30/70 agar/PVA solutions. These fibers were mechanically resistant, showed tailorable surface roughness and diverse size distributions, with most of the diameters falling in the sub-micron range. Both nano and micro forms of agar fibers (used separately or combined) may have potential for the design of new and highly functional agar-based materials.

Electrospinning of agar/PVA aqueous solutions and its relation with rheological properties.

In this work, we report the successful fabrication of agar-based nanofibers by electrospinning technique, using water as solvent media. A tubeless spinneret was attached inside the electrospinning chamber, operating at 50°C, to avoid agar gelation. Agar pure solution (1 wt%) showed inadequate spinnability regardless of the used electrospinning conditions. The addition of a co-blending polymer such as PVA (10 wt% starting solution) improved the solutions viscoelasticity and hence, the solutions spinnability. Agar/PVA solutions were prepared with different mass ratios (100/0, 50/50, 40/60, 30/70, 20/80 and 0/100) and electrospun at various sets of electrospinning conditions. Best nanofibers were obtained with 30/70 and 20/80 agar/PVA blends while samples with higher agar contents (50/50 and 40/60 agar/PVA) were harder to process and led to discontinuous fibrous mats. This first set of encouraging results can open a new window of opportunities for agar-based biomaterials in the form of nanofibers.

Study of the Antibacterial Efficacy of Bainiku-Ekisu against Pathogens.

The research was undertaken to determine the bacteriostatic effects of the concentrate of Japanese apricot juice (bainiku-ekisu), which is a popular health food in Taiwan and Japan, on Enterococcus faecalis ATCC 29212, Staphylococcus aureus ATCC 25923, and Escherichia coli ATCC 25922. The results show that E. faecalis, S. aureus, and E. coli could be killed or inhibited by bainiku-ekisu at concentrations between 1.0 and 10.0 mg/mL. The minimum inhibitory concentration (MIC) was 1 mg/mL for all strains, and the minimum bactericidal concentrations (MBCs) were 5, 2.5, and 2.5 mg/mL for E. faecalis, S. aureus, and E. coli, respectively. Using the growth rate to calculate the MICs and MBCs, the MICs were 1.55, 1.43, and 0.97 mg/mL, and the MBCs were 2.59, 2.63, and 2.25 mg/mL for E. faecalis, S. aureus, and E. coli, respectively. According to the D values, E. faecalis and S. aureus exhibited lower resistance than E. coli at lower bainiku-ekisu concentrations (1.0 and 2.5 mg/mL), and the resistance of these two pathogens was better than that of E. coli at higher bainiku-ekisu concentrations (5.0 and 10.0 mg/mL). The Z values of the E. faecalis, S. aureus, and E. coli strains were 3.47, 4.93, and 11.62 mg/mL, respectively.

Antioxidant effect and active components of litchi (Litchi chinensis Sonn.) flower.

The effects of scavenging 2, 2-diphenyl-2-picrylhydrazyl hydrate (DPPH) radicals and inhibiting low-density lipoprotein (LDL) oxidation, and phenolic quantities were used for the activity-guided separation to identify the effective components of litchi flower. The acetone extract of the flower with notable antioxidant capacities was suspended in water and sequentially partitioned with n-hexane, ethyl acetate (EA) and n-butanol. The EA partition with the highest phenolic levels and antioxidant capacities was subjected to silica gel column chromatography. Thirteen fractions (Fr. 1-13) were collected; Fr. 10-12 with higher phenolic levels and antioxidant effects were applied to Sephadex LH-20 column chromatography. Each fraction was further separated into three sub-fractions and the second ones (Fr. 10-II, 11-II, and 12-II) were the best, which two major compounds could be isolated by semi-preparative high performance liquid chromatography (HPLC). Through Mass (MS) and Nuclear Magnetic Resonance (NMR) measurements, they could be identified as (-)-epicatechin and proanthocyanidin A2. Their contents in the litchi flower were 5.52 and 11.12 mg/g of dry weight, respectively. The study was the first time to reveal the effective antioxidant components of litchi flower.

Kinetics of color development, pH decreasing, and anti-oxidative activity reduction of Maillard reaction in galactose/glycine model systems.

Galactose/glycine model systems of sugar concentration 0.035, 0.069, 0.139, and 0.278M were incubated at 60, 75, and 90°C separately for studying the reaction kinetics of color development, pH change, and system anti-oxidative activity change in Maillard reaction. The results indicated that system color development followed first-ordered kinetics on galactose concentration; system pH went linearly down with a logarithm-ordered kinetics on galactose concentration; and anti-oxidative activity reduced linearly with a first-ordered kinetics on galactose concentration. The values of Q10 and activation energy ranged from 1.98 to 2.00 and from 68.8 to 69.5kJ/mol, respectively, for these three properties.

Effects of domestic processing on steroidal saponins in Taiwanese yam cultivar (Dioscorea pseudojaponica Yamamoto).

The effects of domestic processing on steroidal saponins and furostanol and spirostanol glycosides in Taiwanese yam cultivar (Dioscorea pseudojaponica Yamamoto) were studied. The baking or frying of yam slices was conducted at 150, 180, and 200 degrees C for 3, 5, and 10 min. Yam slices were steamed or microwave cooked at 2450 MHz with an output power of 850 W for 3, 5, and 10 min. The various saponins were quantified by HPLC with an evaporative light scattering detector (ELSD). Results showed that the contents of saponins were decreased along with increasing cooking temperature and time except for the steaming treatment. None of the steamed yam slices significantly change their initial compositions or quantities of furostanol and spirostanol glycosides. Fried yam slices had the highest loss of saponins, especially at 200 degrees C for 10 min (93 and 97% reductions for total furostanol and spirostanol glycosides, respectively). After baking for 10 min at 200 degrees C, the total furostanol and spirostanol glycosides were reduced by 67 and 74%, respectively. There were 12, 44, and 84% decreases for total furostanol glycosides and 10, 35, and 75% reductions for total spirostanol glycosides in yam slices after microwave cooking for 3, 5, and 10 min, respectively. Diosgenin, the aglycone of these saponins, could be found in yams after microwave cooking and baking, but not in steamed and fried yams.