Detection of nitroaromatics in the solid, solution, and vapor phases using silicon quantum dot sensors.

Silicon quantum dots (Si-QDs) represent a well-known QD fluorophore that can emit throughout the visible spectrum depending on the interface structure and surface functional group. Detection of nitroaromatic compounds by monitoring the luminescence response of the sensor material (typically fluorescent polymers) currently forms the basis of new explosives sensing technologies. Freestanding silicon QDs may represent a benign alternative with a high degree of chemical and physical versatility. Here, we investigate dodecyl and amine-terminated Si-QD luminescence response to the presence of nitrobenzene and dinitrotoluene (DNT) in various solid, solution, and vapor forms. For dinitrotoluene vapor the 3σ detection limit was 6 ppb for monomer-terminated QDs. For nitroaromatics dissolved in toluene the detection limit was on the order of 400 nM, corresponding to ∼100 pg of material distributed over ∼1 cm(2) on the sensor surface. Solid traces of nitroaromatics were also easily detectable via a simple 'touch test'. The samples showed minimal interference effects from common contaminants such as water, ethanol, and acetonitrile. The sensor can be as simple and inexpensive as a small circle of filter paper dipped into a QD solution, with a single vial of QDs able to make hundreds of these sensors. Additionally, a trial fiber-optic sensor device was tested by applying the QDs to one end of a 2 × 2 fiber coupler and exposing them to controlled DNT vapor. Finally, the quenching mechanism was explored via luminescence dynamics measurements and is different for blue (amine) and red (dodecyl) fluorescent silicon QDs.

Detection of high-energy compounds using photoluminescent silicon nanocrystal paper based sensors.

Luminescent silicon nanocrystals (Si-NCs) surface functionalized with dodecyl groups were exposed to solutions of nitroaromatic compounds including nitrobenzene, nitrotoluene, and dinitrotoluene. It was found that Si-NC luminescence was quenched upon exposure to nitroaromatics via an electron transfer mechanism as indicated by Stern-Volmer analysis. This quenching was exploited and a straightforward paper-based Si-NC sensor was developed. This paper motif was found to be sensitive to solution, vapor, and solid phase nitroaromatics, as well as solution borne RDX and PETN.

Bridging the gap between the technological singularity and mainstream medicine: highlighting a course on technology and the future of medicine.

The "technological singularity" is defined as that putative point in time forecasted to occur in the mid twenty-first century when machines will become smarter than humans, leading humans and machines to merge. It is hypothesized that this event will have a profound influence on medicine and population health. This work describes a new course on Technology and the Future of Medicine developed by a diverse, multi-disciplinary group of faculty members at a Canadian university. The course began as a continuous professional learning course and was later established as a recognized graduate course. We describe the philosophy of the course, the barriers encountered in course development, and some of the idiosyncratic solutions that were developed to overcome these, including the use of YouTube audience retention analytics. We hope that this report might provide a useful template for other institutions attempting to set up similar programs.

A convenient method for electron tomography sample preparation using a focused ion beam.

Here we report a new sample preparation method for three-dimensional electron tomography. The method uses the standard film deposition and focused ion beam (FIB) methods to significantly reduce the problems arising from the projected sample thickness at high tilt angles. The method can be used to prepare tomography samples that can be imaged up to a ±75° tilt range which is sufficient for many practical applications. The method can minimize the problem of Ga⁺ contamination, as compared to the case of FIB preparation of rod-shaped samples, and provides extended thin regions for standard 2D projection analyses.