Graft Reorientation and Lateral Extra-articular Tenodesis in Revision Surgery for Persistent Rotational Instability of a Verticalized Anterior Cruciate Ligament Graft.

Persistent rotational instability after anterior cruciate ligament reconstruction is a relatively common postoperative complication, typically associated with graft verticalization due to improper femoral tunnel placement, especially with classic transtibial femoral tunnel techniques. This article describes a technique designed to reorient a verticalized anterior cruciate ligament graft at its femoral insertion to a more anatomic position in the coronal and sagittal planes, aiming to restore knee stability without the need for a complete revision operation. Additionally, a lateral extra-articular tenodesis with fascia lata is added to reinforce rotational stability.

The Proportion of Meniscus Tears Considered Repairable, and Thus Repaired, Increased During a Single Surgeon's Practice of 20 Years.

Purpose: The purpose of this study was to evaluate practice patterns of a single surgeon with respect to meniscectomy and meniscal repair over a 20-year period at a single institution. Methods: A cross-sectional descriptive study was carried out by reviewing the surgical data from the past 20 years (2002-2021) of patients who underwent arthroscopic primary meniscal surgery. Age, sex, knee and meniscus affected, morphology of the meniscal tear, meniscal radial location, location on the axial plane, tissue quality, and associated injuries were recorded. An analysis of the evolution of the characteristics of the meniscal lesions was performed according to the presence of degenerative tissue, the repairability of the lesion, and the treatment performed. Categorical data were represented in contingency tables and compared using the χ2 test for significance of differences, which was set at P < .05. Results: In total, 1,892 cases were included. A decrease in degenerative meniscal tears was found, from 63.2 in 2002 to 2006 to 9.7% in 2017 to 2021 (P < .001), while repairable tears increased from 1.6% to 82.3% P < .001); in the same periods, arthroscopic partial meniscectomy procedures declined from 75.7% to 17.7% (P < .001) while meniscal repair increased from 0.4% to 81.3% (P < .001). All types of tears increased significantly their repairability, although longitudinal tears, root tears, and ramp lesions showed the highest possibilities for repair. Conclusions: In the present study, a drastic change in the attitude toward meniscal preservation in the past 20 years was observed, with a large increase in the proportion of tears considered repairable found in primary arthroscopic surgery (to 80% of cases) and a decrease in degenerative meniscus tears (to less than 10%). Clinical Relevance: In the past 2 decades, arthroscopic knee surgery has evolved such that more meniscus tears are deemed repairable, and fewer tears considered degenerative are indicated for arthroscopy.

Anterior Cruciate Ligament Revision Surgery Associated to Lateral Collateral and Anterolateral Ligaments Reconstruction With Single Achilles Tendon Allograft and Single Femoral Tunnel.

Lateral collateral ligament (LC) injuries that go unnoticed when associated with an anterior cruciate ligament (ACL) tear can increase stress forces on the ACL graft causing its failure. Furthermore, it is a main stabilizer to varus stress and external rotation. On the other hand, the reinforcement of anterolateral structures during ACL reconstruction has regained popularity in recent years, because evidence has shown that it increases the control of rotational laxity and decreases ACL graft failures, especially in revision surgery. The present article shows a technique to perform an ACL reconstruction, associated with the reconstruction of the LCL and of the anterolateral ligament using a single Achilles tendon allograft, which is split after the fixation of the ACL graft into two fascicles.

Anterior Cruciate Ligament Reconstruction Using Combined Graft of Hamstring and Fascia Lata With Extra-articular Tenodesis. A Technique in Case of Insufficient Hamstrings.

A technique for augmentation of the anterior cruciate ligament (ACL) with hamstring graft and lateral extra-articular tenodesis is presented. The patient is positioned supine with the knee flexed 90°. First, intra-articular injuries are addressed arthroscopically, and then autologous hamstring tendons are harvested and measured; the present technique is a resource for cases with a very small graft diameter (less than 8 mm), due to thin tendons or to tendon breakage, even after tripling the hamstring graft, which is prepared using a facia lata strip long enough to fit the lengths of the femoral tunnel, the anterior cruciate ligament graft, and the tibial tunnel. A single femoral tunnel is performed and only 2 interference screws are needed for fixation.

Assessment of fixation for anterior cruciate ligament reconstruction using oversized suspensory devices on full-length femoral tunnels.

BACKGROUND: In ACL repair, full-length single-diameter tunnels facilitate anatomic femoral fixation with suspensory devices, especially with outside-in techniques, and are required after accidental cortical perforation. With tunnel diameters over 6 mm, fixation resistance using regular suspensory devices may not suffice. Oversized cortical footprint devices could be a solution to guarantee fixation performance in larger tunnel diameters. This study aims to assess the biomechanical properties of ACL femoral fixation provided by two enlarged suspensory devices of similar characteristics, a fixed loop (G-Lok™ with G-Lok-XL™) and an adjustable loop (ProCinch™ with G-Lok-XL™), resting on a full-length 9 mm diameter tunnel compared to the widely accepted regular fixed-loop device (G-Lok™) on a socket tunnel. METHODS: Twenty-seven fresh frozen porcine femurs and flexor digitorum profundus tendons were randomly assigned to a study group depending on the fixation method used (N = 9). Graft-femur constructs were subjected to a traction cyclic test (5000 cycles, [50-250]N load, 1 Hz) followed by a load-to-failure test (v = 1 mm/s). Residual displacement during the cyclic test and stiffness, displacements at physiological loads, ultimate load and corresponding displacement during the load-to-failure test were determined. FINDINGS: No significant differences could be established for any parameter measured in the comparison between the control with the socket tunnel and the oversized fixations with full-length tunnels. INTERPRETATION: ACL femoral fixation achieved in full-length single diameter tunnels by using an enlarged suspension device, both with a fixed or an adjustable loop, provide similar biomechanical properties to the gold-standard fixed-loop device in a socket tunnel. Therefore, its clinical use may be safe.

Staged upper and lower limb lengthening performing bilateral simultaneous surgery of the femur and tibia in achondroplastic patients.

INTRODUCTION: Surgical lengthening and angular correction of the limbs are an option for treating the orthopedic clinical manifestations in patients with achondroplasia. This study assesses a staged limb lengthening protocol, performing simultaneous bilateral lengthening of the femur and tibia (stage I [S1]), and humeral lengthening (stage II [S2]). MATERIALS AND METHODS: Twenty-one achondroplastic patients were included in this study, and 106 segments (34 femurs, 34 tibias and 38 humeri) were lengthened. Achondroplasia patients with a growth curve below the mean of the standard growth curves for achondroplasia were included in S1. The remaining patients were included directly in S2. Variables analyzed included anthropometric measurements, lengthening outcomes, difficulties, and functionality. RESULTS: Of the all patients included in the protocol, 15 patients completed S1 and S2, 4 only completed S2, and 2 only completed S1. Height and limb-trunk ratio before S1 were 107.65 ± 7.14 cm and 1.89 ± 0.10 and after S1 were 126.50 ± 9.19 cm and 1.64 ± 0.09, respectively. Limbs were lengthened 14.43 ± 1.41 cm (femurs and tibias) for S1 and 9.95 ± 0.60 cm for S2 (humeri), with a stage healing index of 18.23 ± 3.54 in S1 and 28.92 ± 4.42 in S2. Correction of lower angular deviations, functional improvement, and a controlled complications rate were achieved in all patients. CONCLUSIONS: The limb lengthening protocol proposed in this study is a suitable treatment for achondroplasia patients to achieve the agreed-upon objectives (limb-trunk ratio, improved functionality, and lower limb alignment). The reproducibility of the procedure and patient safety were upheld.

Arthroscopic Treatment of Concurrent Avulsion Fracture of Anterior and Posterior Cruciate Ligament with Suspension Device.

INTRODUCTION: Simultaneous avulsion fractures of the insertion of both cruciate ligaments of the knee are extremely uncommon lesions and their treatment remains difficult. The purpose of this paper is to show an arthroscopic repair technique of simultaneous tibial avulsion fracture of both cruciate ligaments of the knee such by using an adjustable length suspension device. CASE REPORT: A 25-year-oldmale patient was treated by arthroscopic reduction and fixation of both bony avulsion of cruciate ligaments of the knee with a sliding and adjustable length suspension device (ZipTight, Biomet, Warsaw, IN, USA). There were no post-operative complications appeared. At 18-month follow-up, the patient was conducting normal life, free of symptoms. At clinical examination, Lachman, anterior drawer, pivot shift, posterior drawer, and reverse pivot shift tests were negative. Range of motion was 130° flexion, presenting a slight 5° of extension deficit. The International Knee Documentation Committee score was 83.80 points. Lysholm scale was 85 points. CONCLUSION: The described repair technique is able to provide stable fixation of bone fragments in the face of early fracture consolidation, as well as minimizing potential complications and surgical time.

The role of suture cutout in the failure of meniscal root repair during the early post-operative period: a biomechanical study.

PURPOSE: To assess the role of suture cutout in the mechanics of failure of the repaired posterior meniscal root during the early post-operative period when using sutures of different shape. METHODS: Twenty medial porcine menisci were randomized in two groups depending on the suture shape used to repair the posterior root: thread or tape. The sutured menisci were subjected to cyclic loading (1000 cycles, (10, 30) N) followed by load-to-failure testing. Residual displacements, stiffness, and ultimate failure load were determined. During tests, the tissue-suture interface was recorded using a high-resolution camera. RESULTS: In cyclic tests, cutout progression at the suture insertion points was not observed for any specimen of either group and no differences in residual displacements were found between use of thread or tape. In load-to-failure tests, suture cutout started in all menisci at a load close to the ultimate failure and all specimens failed by suture pullout. Suture tape had a greater ultimate load with no other differences. CONCLUSIONS: In a porcine model of a repaired posterior meniscal root subjected to cyclic loads representative of current rehabilitation protocols in the early post-operative period under restricted loading conditions, suture cutout was not found as a main source of permanent root displacement when using suture thread or tape. Suture cutout progression started at high loading levels close to the ultimate load of the construct. Tape, with a meniscus-suture contact area larger than thread, produced higher ultimate load.

Posterior Cruciate Ligament Reconstruction With Hamstring Tendons Using a Suspensory Device for Tibial Fixation and Interference Screw for Femoral Fixation.

A technique for posterior cruciate ligament reconstruction is presented. Autologous hamstring tendons are selected as a graft. An interference screw is used for femoral fixation. A suspension device is used for tibial fixation to bring the fixation closer to the articular end of the tibial tunnel. Single diameter tunnels of the same diameter as the graft are created in an outside-in direction.