RESUMEN
As the addition of low concentrations of oxygen can favor the initial degradation of benzene, toluene, ethylbenzene, and xylenes (BTEX) compounds, this work verified the applicability of the microaerobic technology to enhance BTEX removal in an anaerobic bioreactor supplemented with high and low co-substrate (ethanol) concentrations. Additionally, structural alterations on the bioreactor microbiota were assessed throughout the experiment. The bioreactor was fed with a synthetic BTEX-contaminated water (~ 3 mg L-1 of each compound) and operated at a hydraulic retention time of 48 h. The addition of low concentrations of oxygen (1.0 mL min-1 of atmospheric air at 27 °C and 1 atm) assured high removal efficiencies (> 80%) for all compounds under microaerobic conditions. In fact, the applicability of this technology showed to be viable to enhance BTEX removal from contaminated waters, especially concerning benzene (with a 30% removal increase), which is a very recalcitrant compound under anaerobic conditions. However, high concentrations of ethanol adversely affected BTEX removal, especially benzene, under anaerobic and microaerobic conditions. Finally, although bacterial community richness decreased at low concentrations of ethanol, in general, the bioreactor microbiota could deal with the different operational conditions and preserved its functionality during the whole experiment.
Asunto(s)
Reactores Biológicos/microbiología , Hidrocarburos Aromáticos/metabolismo , Contaminantes del Agua/metabolismo , Purificación del Agua/métodos , AerobiosisRESUMEN
The objective of this study was to optimize, by employing a central composite rotatable design, and validate an analytical method to detect and quantify monoaromatic compounds (benzene, toluene, ethylbenzene, and xylenes) in waters and wastewaters by using headspace extraction followed by GC coupled with photoionization detection. The extraction parameters optimized were: salinity, sample volume, incubation time, and extraction temperature. The results revealed that the sample volume was the most significant parameter in the extraction process, whereas the salinity effect was negligible, which extends the applicability of the analytical method to waters with different salinities. Finally, the studied method was very selective and, at the optimal extraction conditions (15 mL sample volume, 15 min incubation time, and temperature of 70°C), presented excellent repeatability (<4%), linearity (R > 0.999 for each compound), and sensitivity, since very low LODs (0.13-0.48 µg/L) and LOQs (0.43-1.61 µg/L) were achieved.