Method validation for the determination of 314 pesticide residues using tandem MS systems (GC-MS/MS and LC-MS/MS) in raisins: Focus on risk exposure assessment and respective processing factors in real samples (a pilot survey).

A multi-residue method for the simultaneous analysis of a wide range of pesticides in raisins using liquid and gas chromatography-tandem mass spectrometry (LC-MS/MS and GC-MS/MS) has been validated. Pesticides are extracted from raisins with ethyl acetate, followed by centrifugation. The validation study was in accordance with DG SANTE guidelines. Validation experiments have been performed in both analytical instruments. A total number of 314 pesticides were spiked in raisins of organic farming at two spiking levels for GC-MS/MS (0.025 and 0.1 mg/kg), and at three spiking levels for LC-MS/MS (0.005, 0.05, and 0.1 mg/kg) with 6 replicates at each concentration. The scope of validation included linearity, limits of quantification (LOQ), accuracy, precision, and matrix effects (%) for each pesticide. The validated method was then applied for the analysis of 37 commercial raisin samples purchased from the market. For the evaluation of the results, processing factors (PFs) have been applied to derive the amount of residue in raisins, from the maximum residue levels (MRLs) of grapes, and which in this paper will be referred as to the MRL expressed in raisins. In all conventional samples, pesticides were detected at concentrations above the LOQ. In total, 55 different pesticides were detected. All conventional samples contained multiple pesticides ranging from 2 to 24. On the other hand, samples from organic farming were found to be free of the analysed pesticides. The 13.5% of the examined samples were considered as violations. The exposure assessment for the acute risk of the violating samples indicated that no potential risk derives from the detected and approved in the EU pesticides, while the detection of not approved pesticides in the EU, and the lack of toxicological reference values for certain pesticides raise concerns for the human health, especially for children. The results of the survey study indicate the need to include processed samples, and in particular dry fruits with a high consumption rate such as raisins, in the official controls of pesticide residues in food.

LC-ESI-MS/MS determination of oxyhalides (chlorate, perchlorate and bromate) in food and water samples, and chlorate on household water treatment devices along with perchlorate in plants.

The results of the validation study of the LC-ESI-MS/MS method for the determination of chlorate (ClO3-), perchlorate (ClO4-) and bromate (BrO3-) in water and food samples are summarized. Towards this, 284 samples of drinking water were analysed, out of which the 69% contained chlorate above the limit of quantitation (LOQ) of 0.01 mg/L, with maximum amount of 1.1 mg/L. Only 6 samples were found to be positive with perchlorate at levels <0.01 mg/L. Bromate was detected in 5 drinking water samples at levels above the LOQ, at concentrations up to 0.026 mg/L. For the validation of the method in food, 108 blank samples were spiked with chlorate and perchlorate for the LC-MS/MS analysis at two levels. In total 247 food samples from the market of 19 different commodities including fruits, vegetables, cereals and wine, were analysed. The maximum concentration of chlorate was found at 0.83 mg/kg in a sample of cultivated mushrooms. The number of samples contaminated with perchlorate was also small, with all the determined concentrations below the LOQ of 0.05 mg/kg. Experiments for the chlorate reduction in drinking water, showed that reverse osmosis treatment is effective in particular with newly installed cartridges. Finally, according to the results of the pilot study when chlorinated water is used for the plant irrigation, accumulation of chlorate is observed, especially in the green parts of the plant. Perchlorate was also detected in leafy samples, although it was not present in the irrigation water.