Zero echo time MRI in shoulder MRI protocols for the diagnosis of rotator cuff calcific tendinopathy improves identification of calcific deposits compared to conventional MR sequences but remains sub-optimal compared to radiographs.

OBJECTIVE: To compare the diagnostic performance of standard MRI and standard MRI + ZTE images for the detection of rotator cuff calcific tendinopathy (RCCT) and to describe the artifacts encountered with ZTE images, using computed radiography (CR) as a reference. METHODS: In a retrospective study, patients with suspicion of rotator cuff tendinopathy who underwent standard MRI + ZTE images after radiography were enrolled between June 2021 and June 2022. Images were independently analyzed for calcific deposit presence and ZTE images artifacts, by two radiologists. Diagnostic performance was calculated individually with MRI + CR as the reference standard. RESULTS: A total of 46 RCCT subjects (27 women; mean age, 55.3 years ± 12.4) and 51 control subjects (27 men; mean age, 45.5 ± 12.9) were evaluated. For both readers, there was an increase in the sensitivity for the identification of calcific deposits of MRI + ZTE compared to MRI (77% (95% CI: 64.5-86.8) and 75.4% (95% CI: 62.7-85.5) versus 57.4% (95% IC: 44.1-70) and 47.5% (95% IC: 34.6-60.7), for R1 and R2, respectively). Specificity was quite similar for both readers and both imaging techniques and ranged from 96.6% (95% IC: 93.3-98.5) to 98.7% (95% IC: 96.3-99.7). Hyperintense joint fluid (62.8% of patients), long head of the biceps tendon (in 60.8%), and subacromial bursa (in 27.8%) on ZTE were considered artifactual. CONCLUSION: The addition of ZTE images to a standard MRI protocol improved MRI diagnostic performance of RCCT, but with a suboptimal detection rate and a relatively high frequency of artifactual soft tissue signal hyperintensity. KEY POINTS: • Adding ZTE images to standard shoulder MRI improves the MR-based detection of rotator cuff calcific tendinopathy, but half of the calcification unseen with standard MRI remained unseen with ZTE MRI. On ZTE images, joint fluid and long head biceps tendon were hyperintense in about 60% of the shoulders, as well as the subacromial bursa in about 30%, without calcific deposit on conventional radiographs. • The detection rate of calcific deposits using ZTE images was dependent on the disease phase. In the calcific stage, it reached 100% in this study but remained at a maximum of 80.7% in the resorptive phase.

Imaging in Hip Arthroplasty Management-Part 1: Templating: Past, Present and Future.

Hip arthroplasty is a frequently used procedure with high success rates. Its main indications are primary or secondary advanced osteoarthritis, due to acute fracture, osteonecrosis of the femoral head, and hip dysplasia. The goals of HA are to reduce pain and restore normal hip biomechanics, allowing a return to the patient's normal activities. To reach those goals, the size of implants must suit, and their positioning must meet, quality criteria, which can be determined by preoperative imaging. Moreover, mechanical complications can be influenced by implant size and position, and could be avoided by precise preoperative templating. Templating used to rely on standard radiographs, but recently the use of EOS® imaging and CT has been growing, given the 3D approach provided by these methods. However, there is no consensus on the optimal imaging work-up, which may have an impact on the outcomes of the procedure. This article reviews the current principles of templating, the various imaging techniques used for it, as well as their advantages and drawbacks, and their expected results.

Elbow Stiffness Imaging: A Practical Diagnostic and Pretherapeutic Approach.

Loss of elbow motion can lead to disability in everyday gestures, recreational activities, and work. Unfortunately, the elbow joint is particularly prone to stiffness because of its complex anatomy and biomechanics. The etiology of elbow stiffness is varied and must be diagnosed accurately in order to allow optimal treatment, which may be challenging for surgeons and physiotherapists. Its treatment can be either conservative, arthroscopic or surgical, with a trend for arthroscopic procedures when conservative treatment fails. There is no consensus on the optimal imaging workup for elbow joint stiffness, which may have an impact on patient management. This article reviews the current classification systems of elbow stiffness and the various imaging techniques used for diagnosis. Report checklists and clarifications on the role of each imaging method, as well as the imaging findings of normal and stiff elbows, are presented, leading to a proposed diagnostic algorithm. The main concern in imaging is to determine the cause of elbow stiffness, as many concomitant abnormalities might be present depending on the clinical scenario.

Comparison of radiographs, tomosynthesis and CT with metal artifact reduction for the detection of hip prosthetic loosening.

OBJECTIVES: To evaluate the diagnostic performance of digital tomosynthesis (DTS) for the diagnosis of hip prosthesis loosening (PL) compared with conventional radiographs and CT with metal artifact reduction (CT-MAR). METHODS: Forty-nine patients with painful hip prosthesis were prospectively included and underwent anteroposterior and lateral radiographs, anteroposterior DTS and CT-MAR of the hip. This study was approved by the local ethics committee, and all patients signed an informed consent form. Images were evaluated independently by two radiologists. Periprosthetic radiolucent lines wider than 2 mm found in two or more Gruen or De Lee and Charnley zones were considered diagnostic of PL. All cases of PL were confirmed surgically. Patients with a stable radiological follow-up for at least 1 year with an alternative cause for the symptoms or with no surgical evidence of PL were considered PL negative. RESULTS: There were 21 cases of PL, 9 unilateral and 12 bilateral. For both the acetabular and femoral sides, DTS had a specificity for PL detection similar to that of conventional radiographs and CT-MAR (98.5-100%, 96.9%-100% and 96.9-95.4% respectively for both readers) and a sensitivity similar to conventional radiographs (39.9-45.4% versus 33.3-51.5% for both readers) but lower than CT-MAR (84.85% for both readers). The interobserver agreement was 0.84 for CT-MAR, 0.53 for DTS and 0.39 for conventional radiographs. CONCLUSION: DTS has a similar diagnostic performance to radiographs for the diagnosis of PL with a better interobserver agreement. The sensitivity however remains lower than that of CT-MAR. KEY POINTS: • Plain radiograph is still the first imaging step when hip prosthesis loosening is suspected. • Interobserver agreement is better with digital tomosynthesis than radiographs. • Sensitivity of CT with state-of-the-art metal artifact reduction is superior to that of digital tomosynthesis.

The Impact of Dose Reduction in Quantitative Kinematic CT of Ankle Joints Using a Full Model-Based Iterative Reconstruction Algorithm: A Cadaveric Study.

OBJECTIVE: The objective of our study was to evaluate the quality and reproducibility of semiautomatic measurements of the ankle in low-dose kinematic CT studies using a full model-based iterative reconstruction (MBIR). MATERIALS AND METHODS: Kinematic CT was performed in five cadaveric ankles at three acquisition dose levels: standard dose (1020 mGy × cm), low dose (10% of the standard dose), and ultra-low-dose (1.5% of the standard dose). All images were reconstructed using a full MBIR algorithm. Two semiautomatic measurements (one distance and one angle) were performed by two readers. Registration error was evaluated. The bone aspect on CT and presence of metallic implants were considered in the analysis. The influence of dose on the measurements obtained, reproducibility, and image quality was assessed. RESULTS: With the standard- and low-dose protocols, registration quality was good (registration error, 0.65-4.72%), measurements were similar (p = 0.9), and reproducibility was excellent (intraclass correlation coefficient [ICC] = 0.881). With the ultra-low-dose protocol, the registration quality was poor, yielding measurements significantly different from the other protocols (p < 0.001) and poor reproducibility (ICC = 0.39). In a specimen with normal bone and no metal implant, the registration error was low (0.61-1.01%), measurements were similar (p > 0.5), and reproducibility was excellent (ICC, 0.885-0.996) for the three dose levels tested. CONCLUSION: Full MBIR allows reliable and reproducible measurements in ankle kinematic CT with a low-dose protocol, but an ultra-low-dose protocol may lead to unreliable results.