Haze factor of silver nanowires in variable refractive index environment: experimental and simulation approaches.

While silver nanowires (Ag NWs) have been demonstrated as a highly efficient transparent conducting material, they suffer from strong light scattering, which is quantified by a large haze factor (HF) in the optical spectrum. Here we investigate the influence of the dielectric environment on the light scattering of Ag NWs by comparing experimental measurements and simulations. In air, two peaks on the HF spectra are observed experimentally at the wavelength ofλI= 350 nm andλII= 380 nm and are attributed by simulations to the influence of the Ag NWs pentagonal shape on the localized surface plasmon resonance. The relative intensity between the two peaks is found to be dependent on whether the Ag NWs are in contact with the glass substrate or not. The HF behaviour in the near IR region seems to be dominated by Rayleigh scattering following simulations results. Dielectric environments of Ag NWs with various refractive indexes were obtained experimentally by the conformal deposition of different metal oxide coatings using atomic layer deposition, including Al-doped zinc oxide, Al2O3and SiO2coatings. The HF is found to be correlated with the refractive index environment in terms of HF peaks position, intensity and broadening. This trend of HF peaks is supported by a theoretical model to understand the optical mechanism behind this phenomenon.

Tuning the electrical properties of the p-type transparent conducting oxide Cu1-xCr1+xO2 by controlled annealing.

Off-stoichiometric copper chromium oxide delafossite received lately a great interest due to its high p-type electrical conductivity and adequate optical transmittance in the visible range. However, for a suitable integration in active devices such as p-n junctions, transistors or optoelectronic devices, the electronic properties must be efficiently tailored. Here, post-deposition thermal treatment is proven as an adequate approach for finely controlling the electrical properties of this former degenerate semiconducting material. The energetics of the annealing process are investigated using two different approaches, as a function of the annealing temperature and as a function of the annealing time, allowing the accurate determination of the activation energy of the annealing of defects. By using this method, the electrical carrier concentration was varied in the 1021 - 1017 cm-3 range while the recorded changes in the drift mobility covered three orders of magnitude. Moreover, we demonstrate the ability to accurately manipulate the Fermi level of such materials, which is of great importance in controlling the carrier injection and extraction in optoelectronic active layers.

Transient quantum trapping of fast atoms at surfaces.

We report on the experimental observation and theoretical study of the bound state resonances in fast atom diffraction at surfaces. In our studies, the 4He atom beam has been scattered from a high-quality LiF(001) surface at very small grazing incidence angles. In this regime, the reciprocal lattice vector exchange with the surface allows transient trapping of the 0.3-0.5 keV projectiles into the quasistationary states bound by the attractive atom-surface potential well which is only 10 meV deep. Analysis of the linewidths of the calculated and measured resonances reveals that prior to their release, the trapped projectiles preserve their coherence over travel distances along the surface as large as 0.2 µm, while being in average only at some angstroms in front of the last atomic plane.

Heteronanojunctions with atomic size control using a lab-on-chip electrochemical approach with integrated microfluidics.

A versatile tool for electrochemical fabrication of heteronanojunctions with nanocontacts made of a few atoms and nanogaps of molecular spacing is presented. By integrating microfluidic circuitry in a lab-on-chip approach, we keep control of the electrochemical environment in the vicinity of the nanojunction and add new versatility for exchanging and controlling the junction's medium. Nanocontacts made of various materials by successive local controlled depositions are demonstrated, with electrical properties revealing sizes reaching a few atoms only. Investigations on benchmark molecular electronics material, trapped between electrodes, reveal the possibility to create nanogaps of size matching those of molecules. We illustrate the interest of a microfluidic approach by showing that exposure of a fabricated molecular junction to controlled high solvent flows can be used as a reliability criterion for the presence of molecular entities in a gap.