RESUMEN
A new theory suggests that flammable gases generated by heated vegetation, in particular the volatile organic compounds (VOC) common to Mediterranean plants, may, under certain topographic and wind conditions, accumulate in locations where, after the arrival of the ignition source, they rapidly burst into flames as explosions. Hence, there is a need for the development of a system that can monitor the development of these compounds. In this work, a sensor's array is proposed as a method for monitoring the amount of eucalyptol and α-pinene, the major VOC compounds of the Eucalyptus and Pine trees. The detection of the target compounds was assessed using the impedance spectroscopy response of thin films. Combinations of layers of polyelectrolytes, such as poly(allylamine hydrochloride) (PAH), polyethyleneimine (PEI), poly(sodium 4-sytrenesulfonate) (PSS) graphene oxide (GO), and non/functionalized multiwall nanotubes (MWCNT-COOH or MWCNT), namely, PAH/GO, PEI/PSS, PEI/GO, PAH/MWCNT, PAH/MWCNT-COOH, films, and TiO2 and ZnO sputtered films, were deposited onto ceramic supports coated with gold interdigitated electrodes. The results showed that concentrations of the target VOCs, within the range of 68 to 999 ppmv, can be easily distinguished by analyzing the impedance spectra, particularly in the case of the ZnO- and PAH/GO-film-based sensors, which showed the best results in the detection of the target compounds. Through principal component analysis (PCA), the best set of features attained for the ZnO and PAH/GO based sensor devices revealed a linear trend of the PCA's first principal component with the concentration within the range 109 and 807 ppmv. Thus, the values of sensitivity to eucalyptol and α-pinene concentrations, which were (2.2 ± 0.3) × 10-4 and (5.0 ± 0.7) × 10-5 per decade, respectively, as well as resolutions of 118 and 136 ppbv, respectively, were identified.
Asunto(s)
Compuestos Orgánicos Volátiles , Incendios Forestales , Óxido de Zinc , Electrodos , Eucaliptol , Polietileneimina/química , Compuestos Orgánicos Volátiles/análisisRESUMEN
The current water-scarcity crisis that is being felt in Europe, namely in the southern region, has leveraged the development and implementation of national and regional water management plans. These policies aim to promote efficient wastewater reuse in industrial and urban sectors. Thus, stakeholders are now seeking strategies to enhance the sustainability of their wastewater treatment processes. The present work details the evaluation of the wastewater treatment methods used at an Air Force Base located in Portugal. In addition, this study also intended to determine how wastewater reuse can be implemented and add value to the environmental protection mission of the military airbase. Hence, an assessment of wastewater treatment practices was carried out, considering primary and secondary treatments. The chemical, physical, and biological indicators of samples collected over two consecutive years were analyzed to determine trends and fluctuations. The results revealed that the overall effectiveness of nutrient removal is low due to the oversized nature of the treatment plant, the age of the facility, and the composition of the wastewater. The effluent produced meets standards for non-potable reuse and could be used on base for aircraft maintenance and the cleaning of facilities. Nonetheless, the effectiveness of the plant could be improved by implementing a more advanced tertiary wastewater treatment to decrease the concentration of undesired compounds (e.g., total nitrogen), enabling the reuse of water in a broader range of activities.
Asunto(s)
Personal Militar , Purificación del Agua , Humanos , Aguas Residuales/química , Eliminación de Residuos Líquidos/métodos , Portugal , Purificación del Agua/métodos , Nitrógeno , AguaRESUMEN
Antibiotics represent a class of pharmaceuticals used to treat bacterial infections. However, the ever-growing use of antibiotics in agriculture and human and veterinary medicine has led to great concern regarding the outbreak of microbe strains resistant to antimicrobial drugs. Azithromycin, clarithromycin, and erythromycin are macrolides, a group of molecules with a broad spectrum of antibiotic properties, included in the second EU watchlist of emerging pollutants which emphasizes the importance of understanding their occurrence, fate, and monitoring in aquatic environments. Thus, the aim of this study was to develop sensors based on nanostructured thin films deposited on ceramic substrates with gold interdigitated electrodes, to detect azithromycin, clarithromycin, and erythromycin in water matrices (mineral and river water). Impedance spectroscopy was employed as the transducing method for the devices' electrical signal, producing multivariate datasets which were subsequently analyzed by principal component analysis (PCA). The PCA plots for mineral water demonstrated that ZnO- and TiO2-based sensors produced by DC magnetron sputtering either with 50% or 100% O2 in the sputtering chamber, were able to detect the three macrolides in concentrations between 10-15 M and 10-5 M. In river water, the PCA discrimination presented patterns and trends, between non-doped and doped, and sorting the different concentrations of azithromycin, clarithromycin, and erythromycin. Considering both matrices, by applying the e-tongue concept, sensitivity values of 4.8 ± 0.3, 4.6 ± 0.3, and 4.5 ± 0.3 per decade to azithromycin, clarithromycin, and erythromycin concentration, respectively, were achieved. In all cases, a resolution of 1 × 10-16 M was found near the 10-15 M concentration, the lowest antibiotic concentration measured.
RESUMEN
Triclosan (TCS) is a bacteriostatic used in household items that promotes antimicrobial resistance and endocrine disruption effects both to humans and biota, raising health concerns. In this sense, new devices for its continuous monitoring in complex matrices are needed. In this work, sensors, based on polyelectrolyte layer-by-layer (LbL) films prepared onto gold interdigitated electrodes (IDE), were studied. An electronic tongue array, composed of (polyethyleneimine (PEI)/polysodium 4-styrenesulfonate (PSS))5 and (poly(allylamine hydrochloride/graphene oxide)5 LbL films together with gold IDE without coating were used to detect TCS concentrations (10-15-10-5 M). Electrical impedance spectroscopy was used as means of transduction and the obtained data was analyzed by principal component analysis (PCA). The electronic tongue was tested in deionized water, mineral water and wastewater matrices showing its ability to (1) distinguish between TCS doped and non-doped solutions and (2) sort out the TCS range of concentrations. Regarding film stability, strong polyelectrolytes, as (PEI/PSS)n, presented more firmness and no significant desorption when immersed in wastewater. Finally, the PCA data of gold IDE and (PEI/PSS)5 sensors, for the mineral water and wastewater matrices, respectively, showed the ability to distinguish both matrices. A sensitivity value of 0.19 ± 0.02 per decade to TCS concentration and a resolution of 0.13 pM were found through the PCA second principal component.
RESUMEN
Degradation technologies applied to emerging organic contaminants from human activities are one of the major water challenges in the contamination legacy. Triclosan is an emerging contaminant, commonly used as antibacterial agent in personal care products. Triclosan is stable, lipophilic and it is proved to have ecotoxicologic effects in organics. This induces great concern since its elimination in wastewater treatment plants is not efficient and its by-products (e.g. methyl-triclosan, 2,4-dichlorophenol or 2,4,6-trichlorophenol) are even more hazardous to several environmental compartments. This work provides understanding of two different electrochemical reactors for the degradation of triclosan and its derivative by-products in effluent. A batch reactor and a flow reactor (mimicking a secondary settling tank in a wastewater treatment plant) were tested with two different working anodes: Ti/MMO and Nb/BDD. The degradation efficiency and kinetics were evaluated to find the best combination of current density, electrodes and set-up design. For both reactors the best electrode combination was achieved with Ti/MMO as anode. The batch reactor at 7 mA/cm2 during 4 h attained degradation rates below the detection limit for triclosan and 2,4,6-trichlorophenol and, 94% and 43% for 2,4-dichlorophenol and methyl triclosan, respectively. The flow reactor obtained, in approximately 1 h, degradation efficiencies between 41% and 87% for the four contaminants. This study suggests an alternative technology for emerging organic contaminants degradation, since the combination of a low current density with the flow and matrix induced disturbance increases and speeds up the compounds' elimination in a real environmental matrix.
Asunto(s)
Técnicas Electroquímicas/instrumentación , Compuestos Orgánicos/química , Triclosán/química , Aguas Residuales/química , Contaminantes Químicos del Agua/análisis , Electrodos , Humanos , Cinética , Fenoles/química , Triclosán/análogos & derivadosRESUMEN
Triclosan, which is a bacteriostatic used in household items, has raised health concerns, because it might lead to antimicrobial resistance and endocrine disorders in organisms. The detection, identification, and monitoring of triclosan and its by-products (methyl triclosan, 2,4-Dichlorophenol and 2,4,6-Trichlorophenol) are a growing need in order to update current water treatments and enable the continuous supervision of the contamination plume. This work presents a customized electronic tongue prototype coupled to an electrochemical flow reactor, which aims to access the monitoring of triclosan and its derivative by-products in a real secondary effluent. An electronic tongue device, based on impedance measurements and polyethylenimine/poly(sodium 4-styrenesulfonate) layer-by-layer and TiO2, ZnO and TiO2/ZnO sputtering thin films, was developed and tested to track analyte degradation and allow for analyte detection and semi-quantification. A degradation pathway trend was observable by means of principal component analysis, being the sample separation, according to sampling time, explained by 77% the total variance in the first two components. A semi-quantitative electronic tongue was attained for triclosan and methyl-triclosan. For 2,4-Dichlorophenol and 2,4,6-Trichlorophenol, the best results were achieved with only a single sensor. Finally, working as multi-analyte quantification devices, the electronic tongues could provide information regarding the degradation kinetic and concentrations ranges in a dynamic removal treatment.
Asunto(s)
Técnicas Electroquímicas/métodos , Contaminación de Alimentos/análisis , Clorofenoles/análisis , Clorofenoles/aislamiento & purificación , Técnicas Electroquímicas/instrumentación , Nariz Electrónica , Polietileneimina/química , Polímeros/química , Análisis de Componente Principal , Extracción en Fase Sólida , Ácidos Sulfónicos/química , Titanio/química , Triclosán/análisis , Triclosán/aislamiento & purificación , Óxido de Zinc/químicaRESUMEN
Thoracoabdominal aortic disease (aneurysm or dissection) has increased in recent decades. Surgery is the curative treatment but is associated to high perioperative morbidity and mortality risks. Paraplegia is one of the most severe complications, whose incidence has decreased significantly with the implementation of spinal cord protection strategies. No single method or combination of methods has proven to be fully effective in preventing paraplegia. This review is intended to analyse the scientific evidence available on the role of intraoperative monitoring with motor evoked potentials in the neurological outcome of patients undergoing thoracoabdominal aortic surgery. An online search (PubMed) was conducted. Relevant references were selected and reviewed. Intraoperative monitoring with motor evoked potentials (MEP) allows early detection of ischemic events and a targeted intervention to prevent the development of spinal cord injury, significantly reducing the incidence of postoperative paraplegia. MEP monitoring may undergo several intraoperative interferences which may compromise their interpretation. Neuromuscular blockade is the main limiting factor of anesthetic origin. It is essential to strike a balance between monitoring conditions and surgical and anesthetic needs as well as to evaluate the risks and benefits of the technique for each patient. MEP monitoring improves neurological outcome when integrated in a multidisciplinary strategy which must include multiple protective mechanisms that should be tailored to each hospital reality.