Photoelectrocatalytic degradation of oxalic acid using WO3 and stratified WO3/TiO2 photocatalysts under sunlight illumination.

The WO3 and stratified WO3/TiO2 thin films are successfully prepared by the spray pyrolysis method. The structural, morphological, compositional and photoelectrocatalytic properties of WO3 and stratified WO3/TiO2 thin films are studied. XRD analysis confirms that films are polycrystalline with monoclinic and tetragonal crystal structures for WO3 and TiO2 respectively. The SEM images clearly show 3D sheeted porous structure of the as-prepared TiO2 forms on WO3 in stratified WO3/TiO2 samples. The synthesized photoelectrodes was used as catalyst for photoelectrocatalytic degradation of oxalic acid in aqueous medium. The rate constant (k) was evaluated as a function of the initial concentration of species. A significant decrease in concentrations of organic species was observed from COD analysis. The photoelectrocatalytic degradation effect is relatively higher in the case of the stratified WO3/TiO2 than WO3 thin film photoelectrode in the degradation of oxalic acid and 83% removal efficiency of oxalic acid is obtained after 180min. Based on the obtained experimental data, the possible photoelectrocatalytic reaction mechanism was proposed. The photoelectrocatalytic experimental results indicate that stratified WO3/TiO2 photoelectrode is the promising material for removing of water pollutants.

Photoelectrocatalytic degradation of benzoic acid using Au doped TiO2 thin films.

Highly transparent pure and Au doped TiO2 thin films are successfully deposited by using simple chemical spray pyrolysis technique. The effect of Au doping onto the structural and physicochemical properties has been investigated. The PEC study shows that, both short circuit current (Isc) and open circuit voltage (Voc) are (Isc=1.81mA and Voc=890mV) relatively higher at 3at.% Au doping percentage. XRD study shows that the films are nanocrystalline in nature with tetragonal crystal structure. FESEM images show that the film surface covered with a smooth, uniform, compact and rice shaped nanoparticles. The Au doped thin films exhibit indirect band gap, decreases from 3.23 to 3.09eV with increase in Au doping. The chemical composition and valence states of pure and Au doped TiO2 films are studied by using X-ray photoelectron spectroscopy. The photocatalytic degradation effect is 49% higher in case 3at.% Au doped TiO2 than the pure TiO2 thin film photoelectrodes in the degradation of benzoic acid. It is revealed that Au doped TiO2 can be reused for five cycles of experiments without a requirement of post-treatment while the degradation efficiency was retained.

Fabrication of ZnFe2O4 films and its application in photoelectrocatalytic degradation of salicylic acid.

ZnFe2O4 thin films are successfully deposited onto bare and fluorine doped tin oxide (FTO) coated quartz substrate using the spray pyrolysis method. The structure and morphology of ZnFe2O4 photoelectrodes were studied by X-ray diffraction (XRD) and atomic force microscopy (AFM). The X-ray diffraction pattern confirms the polycrystalline nature of films with a spinel cubic crystal structure. The AFM micrographs shows the granular nature of the films. The dielectric constant and dielectric loss shows dispersion behavior as a function of frequency measured in the range from 20Hz to 1MHz. Photoelectrocatalysis degradation of salicylic acid using ZnFe2O4 photoelectrode under sunlight illumination has been investigated. The result shows that the degradation percentage of salicylic acid on ZnFe2O4 photoelectrodes is reached 49% under neutral conditions after 320min illumination. The decrease in values of COD from 19.4mg/L to 6.4mg/L indicates there is mineralization of salicylic acid with time.

Enhanced photocatalytic activity of sprayed Au doped ferric oxide thin films for salicylic acid degradation in aqueous medium.

Various doping percentage of Au were successfully introduced into the Fe2O3 photocatalysts via a spray pyrolysis method different. The effect of Au doping on photoelectrochemical, structural, optical and morphological properties of these deposited thin films is studied. The PEC characterization shows that, the photocurrent increases gradually with increasing Au content initially up to 2at.% indicating the maximum values of short circuit current (Isc) and open circuit voltage (Voc) are (Isc=90µA and Voc=220.5mV) and then decreases after exceeding the optimal Au doping content. Therefore, the photocurrent of Au doped Fe2O3 photocatalysts can be adjusted by the Au content. Deposited films are polycrystalline with a rhombohedral crystal structure having (104) preferred orientation. SEM and AFM images show deposited thin films are compact and uniform. The photocatalytic activities of the Fe2O3 and Au:Fe2O3 photocatalyst were evaluated by photoelectrocatalytic degradation of salicylic acid under sunlight irradiation. The results show that the Au:Fe2O3 thin film photocatalyst exhibited about 45% more degradation of pollutants than the pure Fe2O3. Thus, in Au doped Fe2O3 photocatalysts, the interaction between Au and Fe2O3 reduces the recombination of photogenerated charge carriers and improve the photocatalytic activity.

Oxidative degradation of industrial wastewater using spray deposited TiO2/Au:Fe2O3 bilayered thin films.

The Fe2O3, Au:Fe2O3, TiO2/Fe2O3 and TiO2/Au:Fe2O3 thin films are successfully prepared by the spray pyrolysis technique at an optimised substrate temperature of 400 °C and 470 °C, respectively onto amorphous and F:SnO2 coated glass substrates. The effect of TiO2 layer onto photoelectrochemical (PEC), structural, optical and morphological properties of Fe2O3, Au:Fe2O3, TiO2/Fe2O3 and TiO2/Au:Fe2O3 thin films is studied. The PEC characterization shows that, maximum values of short circuit current (Isc) and open circuit voltage (Voc) are (Isc = 185 µA and Voc = 450 mV) are at 38 nm thickness of TiO2. Deposited films are polycrystalline with a rhombohedral and anatase crystal structure having (104) preferred orientation. SEM and AFM images show deposited thin films are compact and uniform with seed like grains. The photocatalytic activities of the large surface area (64 cm(2)) TiO2/Au:Fe2O3 thin film photocatalysts were evaluated by photoelectrocatalytic degradation of industrial wastewater under sunlight light irradiation. The results show that the TiO2/Au:Fe2O3 thin film photocatalyst exhibited about 87% and 94% degradation of pollutant in sugarcane and textile industrial wastewater, respectively. The significant reduction in COD and BOD values from 95 mg/L to 13 mg/L and 75 mg/L to 11 mg/L, respectively was also observed.

Visible light catalysis of rhodamine B using nanostructured Fe(2)O(3), TiO(2) and TiO(2)/Fe(2)O(3) thin films.

The Fe(2)O(3), TiO(2) and TiO(2)/Fe(2)O(3) composite films are deposited using spray pyrolysis method onto glass and FTO coated substrates. The structural, morphological, optical and photocatalytic properties of Fe(2)O(3), TiO(2) and TiO(2)/Fe(2)O(3) thin films are studied. XRD analysis confirms that films are polycrystalline with rhombohedral and tetragonal crystal structures for Fe2O3 and TiO(2) respectively. The photocatalytic activity was tested for the degradation of Rhrodamine B (Rh B) in aqueous medium. The rate constant (-k) was evaluated as a function of the initial concentration of species. Substantial reduction in concentrations of organic species was observed from COD and TOC analysis. Photocatalytic degradation effect is relatively higher in case of the TiO(2)/Fe(2)O(3) than TiO(2) and Fe(2)O(3) thin film photoelectrodes in the degradation of Rh B and 98% removal efficiency of Rh B is obtained after 20min. The photocatalytic experimental results indicate that TiO(2)/α-Fe(2)O(3) photoelectrode is promising material for removing of water pollutants.

Photoelectrocatalytic decolorization and degradation of textile effluent using ZnO thin films.

Zinc oxide (ZnO) thin films have been successfully deposited onto fluorine doped tin oxide coated glass at substrate temperature of 400 °C and used as electrode in photoelectrocatalytic reactor. The untreated textile effluent was circulated through photoelectrocatalytic reactor under UVA illumination for the decolorization and degradation. Textile effluent was decolorized by 93% within 3h at room temperature with significant reduction in COD (69%). High performance liquid chromatography (HPLC) and Fourier transform infrared spectroscopy (FTIR) analysis of samples before and after decolorization confirmed the degradation of dyes molecules from textile effluent into simpler oxidizable products. Phytotoxicity study revealed reduction in toxic nature of textile effluent after treatment.