RESUMEN
Superelastic NiTi alloy and 304 stainless steel (304 SS) were joined with a Cu interlayer by ultrasonic spot welding (USW) using different welding energy inputs. The surface morphology, interfacial microstructure, mechanical properties, and fracture mechanisms of the dissimilar NiTi/304 SS USWed joints were studied. The results showed that the surface oxidation intensified with increasing ultrasonic welding energy due to mutual rubbing between tools and sheets. The weld interface microstructure exhibited voids or unbonded zones at low energy inputs, while an intimate contact was established at the joining interface when applying a higher energy input of 750 J. With increasing energy input to 750 J, the weld interface shows two interfaces due to the behavior of plastic flow of Cu interlayer. The lap-shear load of the joints first increased, achieving a maximum value of â¼690 N at an energy input of 750 J, and then decreased with further increase in welding energy. Interfacial failure was observed at NiTi/Cu interface at all energy inputs, and no intermetallic compounds were found on the fracture surfaces of both the NiTi/Cu and Cu/304 SS interfaces.
RESUMEN
The surface of Q235 low carbon steel was modified by the metal inert-gas welding (MIG) method; a 304 stainless steel surfacing layer was fabricated to improve the properties of Q235 low carbon steel. For practical industry application, keyhole tungsten inter gas (K-TIG) welding was used to weld the surface-modified plates. The microstructure, elemental distribution, micro-hardness, and corrosion resistance of the surface-modified plates and the welded joints were analyzed. The corrosion tests of welded joints and surface-modified plates were carried out with the electrochemical method and hydrochloric acid immersion method, respectively, and surface morphology after corrosion was studied. The results show that the surface-modified plates and their welded joints were defect-free. The microstructure of the surfacing layer consisted of austenite, martensite, and ferrite; and the microstructure of the weld consisted mainly of martensite. The hardness and corrosion resistance of the surfacing layer was superior to that that of low carbon steel. The micro-hardness of the weld is higher than that of the stainless steel surfacing layer and the base material. The corrosion resistance of the surfacing layer is the best, and the corrosion resistance of the welding seam is better than that of the base material.