Stomatal ozone uptake of a Quercus serrata stand based on sap flow measurements with calibrated thermal dissipation sensors.

The amount of ozone absorbed by the tree leaves is a critical factor determining the ozone effects on forest trees. Stomatal ozone uptake of a forest canopy can be estimated from the ozone concentration and canopy conductance (gc) determined by the sap-flow-based method. This method measures sap flow as a metric of crown transpiration and then derives gc. The thermal dissipation method (TDM) has been used to measure sap flow in most studies adopting this approach. However, recent studies have indicated that TDM may underestimate sap flow, especially in ring-porous tree species. In the present study, the accumulated stomatal ozone uptake (AFST) of a stand of Quercus serrata, a typical ring-porous tree species in Japan, was estimated by measuring sap flow using species-specific calibrated TDM sensors. Laboratory calibration of the TDM sensors revealed that the parameters (α and ß) in an equation converting outputs from the sensors (K) to sap flux density (Fd) were substantially larger for Q. serrata than those originally proposed by Granier (1987). The Fd measured in the Q. serrata stand using calibrated TDM sensors were significantly larger than those obtained using non-calibrated sensors. The diurnal average of gc and daytime AFST (10.4 mm s-1 and 10.96 mmol O3 m-2 month-1) of the Q. serrata stand estimated by using calibrated TDM sensors in August 2020 were similar to those of forests dominated by Quercus species estimated by micrometeorological measurements in previous studies. In contrast, the gc and daytime AFST of the Q. serrata stand estimated by non-calibrated TDM sensors were remarkably lower than those estimated by micrometeorological measurements in previous studies, indicating severe underestimation. Therefore, it is strongly recommended that sap flow sensors are species-specifically calibrated when estimating the canopy conductance and ozone uptake of forests dominated by ring-porous trees based on sap flow measurements using TDM.

Trends of sulfur and nitrogen deposition from 2003 to 2017 in Japanese remote areas.

Emissions of sulfur (S) and nitrogen (N) compounds in East Asia has drastically changed over the last two decades. To assess the influence of the drastic changes in air pollution on ecosystems in Japan, we investigated the trends of S and N deposition during 2003-2017 at remote sites of Acid Deposition Monitoring Network in East Asia (EANET). We measured wet deposition and inferentially estimated dry deposition of S and N using monitoring data from 2003 to 2017 at eight sites. We estimated dry deposition using the inferential method with an updated parameterization for gaseous surface resistance. The linear regression method and nonparametric Mann-Kendall test was used to analyze the temporal trends based on the monthly data sets. High S and N deposition amounts over 10 kg ha-1 year-1 were frequently found at most sites. There were significant increase trends in N deposition to S deposition (N/S) ratio at all sites throughout the 15-year period. Some trends were significantly found when the 15-year period was divided into three: 2003-2007, 2008-2012, and 2013-2017. S deposition had significantly decreased over a wide area in Japan, especially at Sado-seki, Happo, Oki, Hedo, and Ogasawara, in 2013-2017. Significant decreases in oxidized N deposition at Sado-seki and Oki were also found in 2013-2017. Because of almost flat N deposition mainly contributed by reduced N deposition, the N/S ratio clearly increased. These trends were associated with the recent reductions in SO2 and NOx emissions in China. The NOx emission reduction of China has not caught up with that of SO2, and NH3 emissions have not been reduced. This caused the significant increases in the N/S ratio not only in 2013-2017 but also in 2003-2017.

Disentangling the contribution of the transboundary out-flow from the Asian continent to Tokyo, Japan.

We assessed the contribution of transboundary air pollutants (TAPs) transported from China to Tokyo using the Pb(0.5

Nitrogen burden from atmospheric deposition in East Asian oceans in 2010 based on high-resolution regional numerical modeling.

East Asian oceans are possibly affected by a high nitrogen (N) burden because of the intense anthropogenic emissions in this region. Based on high-resolution regional chemical transport modeling with horizontal grid scales of 36 and 12 km, we investigated the N burden into East Asian oceans via atmospheric deposition in 2010. We found a high N burden of 2-9 kg N ha-1 yr-1 over the Yellow Sea, East China Sea (ECS), and Sea of Japan. Emissions over East Asia were dominated by ammonia (NH3) over land and nitrogen oxides (NOx) over oceans, and N deposition was dominated by reduced N over most land and open ocean, whereas it was dominated by oxidized N over marginal seas and desert areas. The verified numerical modeling identified that the following processes were quantitatively important over East Asian oceans: the dry deposition of nitric acid (HNO3), NH3, and coarse-mode (aerodynamic diameter greater than 2.5 µm) NO3-, and wet deposition of fine-mode (aerodynamic diameter less than 2.5 µm) NO3- and NH4+. The relative importance of the dry deposition of coarse-mode NO3- was higher over open ocean. The estimated N deposition to the whole ECS was 390 Gg N yr-1; this is comparable to the discharge from the Yangtze River to the ECS, indicating the significant contribution of atmospheric deposition. Based on the high-resolution modeling over the ECS, a tendency of high deposition in the western ECS and low deposition in the eastern ECS was found, and a variety of deposition processes were estimated. The dry deposition of coarse-mode NO3- and wet deposition of fine-mode NH4+ were the main factors, and the wet deposition of fine-mode NO3- over the northeastern ECS and wet deposition of coarse-mode NO3- over the southeastern ECS were also found to be significant processes determining N deposition over the ECS.

Aerosol Liquid Water Promotes the Formation of Water-Soluble Organic Nitrogen in Submicrometer Aerosols in a Suburban Forest.

Water-soluble organic nitrogen (WSON) affects the formation, chemical transformations, hygroscopicity, and acidity of organic aerosols as well as biogeochemical cycles of nitrogen. However, large uncertainties exist in the origins and formation processes of WSON. Submicrometer aerosol particles were collected at a suburban forest site in Tokyo in summer 2015 to investigate the relative impacts of anthropogenic and biogenic sources on WSON formations and their linkages with aerosol liquid water (ALW). The concentrations of WSON (ave. 225 ± 100 ngN m-3) and ALW exhibited peaks during nighttime, which showed a significant positive correlation, suggesting that ALW significantly contributed to WSON formation. Further, the thermodynamic predictions by ISORROPIA-II suggest that ALW was primarily driven by anthropogenic sulfate. Our analysis, including positive matrix factorization, suggests that aqueous-phase reactions of ammonium and reactive nitrogen with biogenic volatile organic compounds (VOCs) play a key role in WSON formation in submicrometer particles, which is particularly significant in nighttime, at the suburban forest site. The formation of WSON associated with biogenic VOCs and ALW was partly supported by the molecular characterization of WSON. The overall result suggests that ALW is an important driver for the formation of aerosol WSON through a combination of anthropogenic and biogenic sources.

Cacao bean husk: an applicable bedding material in dairy free-stall barns.

OBJECTIVE: The objectives of the study were to assess the effect of cacao bean husk as bedding material in free-stall barn on the behavior, productivity, and udder health of dairy cattle, and on the ammonia concentrations in the barn. METHODS: Four different stall surfaces (no bedding, cacao bean husk, sawdust, and chopped wheat straw) were each continuously tested for a period of 1 week to determine their effects on nine lactating Holstein cows housed in the free-stall barn with rubber matting. The lying time and the milk yield were measured between d 4 and d 7. Blood samples for plasma cortisol concentration and teat swabs for bacterial counts were obtained prior to morning milking on d 7. The time-averaged gas-phase ammonia concentrations in the barn were measured between d 2 and d 7. RESULTS: The cows spent approximately 2 h more per day lying in the stalls when bedding was available than without bedding. The milk yield increased in the experimental periods when cows had access to bedding materials as compared to the period without bedding. The lying time was positively correlated with the milk yield. Bacterial counts on the teat ends recorded for cows housed on cacao bean husk were significantly lower than those recorded for cows housed without bedding. Ammonia concentration under cacao bean husk bedding decreased by 6%, 15%, and 21% as compared to no bedding, sawdust, and chopped wheat straw, respectively. The cortisol concentration was lowest in the period when cacao bean husk bedding was used. We observed a positive correlation between the ammonia concentrations in the barn and the plasma cortisol concentrations. CONCLUSION: Cacao bean husk is a potential alternative of conventional bedding material, such as sawdust or chopped wheat straw, with beneficial effects on udder health and ammonia concentrations in the barns.

[Investigation of a CT value electron density conversion method in radiotherapy planning CT].

To obtain heterogeneous corrections, it is necessary to convert computed tomography (CT) values into electron density. However, differences in the current conversion tables of the method of acquisition for each institution are not clear. Therefore, we sent a questionnaire survey to 200 radiotherapy institutions in the Kanto area regarding heterogeneous correction data acquisition. When these conversion tables were created, many institutions used phantoms for conversion, and 85% of institutions borrowed them from the factories. On the other hand, some institutions used the factory values as the other conversion method. In the conversion tables of the various institutions, we recognized large differences between institutions, in that relative electronic density (Rel.ED) was greater than 1.0. When we assumed the CT value of bone to be 793 HU, the mean relative electron density at 120 kV was 1.46+/-0.09, with a minimum of 1.36 and maximum of 1.82. We have recognized the need to create guidelines detailing these methods of evaluation.