Application of 2D MoS2 Nanoflower for the Removal of Emerging Pollutants from Water.

Two-dimensional (2D) nanomaterial-MoS2 (molybdenum disulfide) has gained interest among researchers, owing to its exceptional mechanical, biological, and physiochemical properties. This paper reports on the removal of organic dyes and an emerging contaminant, Ciprofloxacin, by a 2D MoS2 nanoflower as an adsorbent. The material was prepared by a green hydrothermal technique, and its high Brunauer-Emmett-Teller-specific area of 185.541m2/g contributed to the removal of 96% rhodamine-B dye and 85% Ciprofloxacin. Various characterizations, such as X-ray diffraction, scanning electron microscopy linked with energy-dispersive spectroscopy, and transmission electron microscopy, revealed the nanoflower structure with good crystallinity. The feasibility and efficacy of 2D MoS2 nanoflower as a promising adsorbent candidate for the removal of emerging pollutants was confirmed in-depth in batch investigations, such as the effects of adsorption time, MoS2 dosages, solution pH, and temperature. The adsorption mechanism was further investigated based on thermodynamic calculations, adsorption kinetics, and isotherm modeling. The results confirmed the exothermic nature of the enthalpy-driven adsorption as well as the fast kinetics and physisorption-controlled adsorption process. The recyclability potential of 2D MoS2 exceeds four regeneration recycles. MoS2 nanoflower has been shown to be an effective organic pollutant removal adsorbent in water treatment.

Near Green Synthesis of Porous Graphene from Graphite Using an Encapsulated Ferrate(VI) Oxidant.

Graphene oxide (GO) is a conventional yet vital precursor for the synthesis of porous graphene (PG). Several strong oxidizing agents such as potassium permanganate and perchlorates are typically used for oxidization of graphite. However, they expose toxic reactants/products that harm the environment. Therefore, a greener approach is desperately needed to oxidize and exfoliate graphite. This study reports for the first time on successful oxidation of graphite by ferrate(VI) compounds via an encapsulation approach. By further reducing GO prepared from this near green route with vitamin C, PG anticipated by many highly important and expanding areas such as water treatment could be readily achieved. X-ray diffraction (XRD), Fourier transform infrared (FTIR) and UV-vis spectroscopy, and scanning electronic microscopy (SEM) along with energy-dispersive spectroscopy confirmed the high yield of GO from the oxidation of graphite. Raman spectroscopy, XRD, and TEM confirmed the formation of high-quality few-layered PG from the reduction of as-prepared GO. The above results demonstrated the practicality of using encapsulated ferrate(VI) compounds to realize green oxidation of graphite and resolve the paradox about the oxidation capability of ferrate(VI). To further illustrate its potential for the removal of emerging and crucial contaminants from water, as-prepared PG was further examined against the contaminants of methyl orange (MeO) dye and ibuprofen (IBU). Taken together, the results revealed that more than 90% removal efficiency could be achieved at a high PG dosage against MeO and IBU. This ground-breaking greener approach opens the door to risk-free, extensive graphene environmental applications.

Mechanisms of cholera transmission via environment in India and Bangladesh: state of the science review.

OBJECTIVES: Cholera has a long history in India and Bangladesh, the region where six out of the past seven global pandemics have been seeded. The changing climate and growing population have led to global cholera cases remaining high despite a consistent improvement in the access to clean water and sanitation. We aim to provide a holistic overview of variables influencing environmental cholera transmission within the context of India and Bangladesh, with a focus on the mechanisms by which they act. CONTENT: We identified 56 relevant texts (Bangladesh n = 40, India n = 7, Other n = 5). The results of the review found that cholera transmission is associated with several socio-economic and environmental factors, each associated variable is suggested to have at least one mediating mechanism. Increases in ambient temperature and coastal sea surface temperature support cholera transmission via increases in plankton and a preference of Vibrio cholerae for warmer waters. Increased rainfall can potentially support or reduce transmission via several mechanisms. SUMMARY AND OUTLOOK: Common issues in the literature are co-variance of seasonal factors, limited access to high quality cholera data, high research bias towards research in Dhaka and Matlab (Bangladesh). A specific and detailed understanding of the relationship between SST and cholera incidence remains unclear.

Investigating the environmental costs of utilizing graphene-based adsorbents and pulsed power oxidation for the removal of emerging contaminants from urban wastewater.

Emerging contaminants continue to pose a threat to environmental quality that warrant mitigation. Novel technologies are being investigated that offer promise in their removal, yet it is important that the environmental costs of these treatments do not overshadow their benefits. With sustainability a key priority in global infrastructure development, insights into the environmental impact of new technologies is necessitated. In the present work, the environmental burden of three novel GBM (graphene-based material) filters (porous graphene, graphene oxide-based foam and hybrid combination) are quantified and compared at a flow rate of 1 m3/d by way of life cycle impact assessment with an alternative solution, an AOP-PPT (advanced oxidation process by pulsed power treatment). Initial results demonstrated negligible differences in overall environmental impact between the three GBM filter formats (7.7-7.9 pt), while significant asymmetry was observed with the AOP-PPT that incurred a total impact score of 67.9 pt. This disparity was attributed to the high energy demand of the AOP-PPT that was a key predictor of environmental cost in an India context due to the high proportion of non-renewable energy sourced. The GBM filters were also considered at a range of breakthrough times and contrasted against the AOP-PPT. Results showed that differences between GBM filters were negligible at all breakthrough periods and that multiple breakthroughs a day would be required before the AOP-PPT became environmentally favourable. Finally, due to the AOP-PPT affording inclusive disinfection, the environmental burden of a GBM filter was compared under different scenarios of incorporated disinfection. The total impact of the AOP-PPT achieving full disinfection was found to be 242.5 pt compared to only 26.8 pt for the GBM filter coupled with UV254 (ultraviolet 254 nm) treatment and 13.9 pt when incorporating chlorination/de-chlorination. These findings should support sustainable development goals when combating prevailing emerging contaminants in municipal wastewater.

Performance Evaluation of Porous Graphene as Filter Media for the Removal of Pharmaceutical/Emerging Contaminants from Water and Wastewater.

Graphene and its counterparts have been widely used for the removal of contaminants from (waste)water but with limited success for the removal of pharmaceutical contaminants. Driven by this need, this study reports, for the first time, the removal of pharmaceuticals from real contaminated water samples using porous graphene (PG) as a filter-based column. This work systematically evaluates the performance of PG as a filter medium for the removal of widely consumed pharmaceutical/emerging contaminants (ECs) such as atenolol, carbamazepine, ciprofloxacin, diclofenac, gemfibrozil and ibuprofen. Several factors were investigated in these column studies, including different reactive layer configurations, bed packing heights (5-45 mm), filter sizes (inner diameter 18-40 mm), adsorbent dosages (100-500 mg-PG) and water bodies (distilled water, greywater, and actual effluent wastewater). Sustainable synthesis of PG was carried out followed by its use as a filter medium for the removal of pharmaceuticals at high concentrations (10.5 ± 0.5 mg/L) and trace concentrations (1 mg/L). These findings revealed that the double-layered PG-sand column outperformed a PG single-layered configuration for the removal of most of the ECs. The removal efficiency of ECs from their solutions was improved by increasing PG dosages and filter bed height and size. Although the treatment of mixed pharmaceutical solutions from different water bodies was affected by the negative interference caused by competing water compounds, the treatment of ECs-contaminated greywater was not severely affected. Our findings suggest that PG, as a highly efficient filter medium, could be used for the removal of emerging pharmaceutical contaminants from water and wastewater.

A facile synthesis of porous graphene for efficient water and wastewater treatment.

The use of two-dimensional graphene-based materials in water treatment has recently gained significant attention due to their unique electronic and thermal mobility, high surface area, high mechanical strength, excellent corrosion resistance and tunable surface chemistry. However, the relatively expensive, poor hydrophobicity, low adsorption capacity and recyclability, and complex post-treatment of the most pristine graphene frameworks limit their practical application. Here, we report a facile scalable method to produce highly porous graphene from reduced graphene oxide via thermal treatment without addition of any catalyst or use of any template. Comparing to conventional graphene counterparts, as-prepared porous graphene nanosheets showed evident improvement in hydrophobicity, adsorption capacity, and recyclability, making them ideal candidate materials for water treatment. Superhydrophobic and superoleophilic porous graphene prepared in this work has been demonstrated as effective absorbents for a broad range of ions, oils and organic solvents, exhibiting high selectivity, good recyclability, and excellent absorption capacities > 90%. The synthesis method of porous graphene reported in this paper is easy to implement, low cost and scalable. These attributes could contribute towards efficient and cost-effective water purification and pollution reduction.

Chemical solutions for greywater recycling.

Greywater recycling is now accepted as a sustainable solution to the general increase of the fresh water demand, water shortages and for environment protection. However, the majority of the suggested treatments are biological and such technologies can be affected, especially at small scale, by the variability in strength and flow of the greywater and potential shock loading. This investigation presents the study of alternative processes, coagulation and magnetic ion exchange resin, for the treatment of greywater for reuse. The potential of these processes as well as the influence of parameters such as coagulant or resin dose, pH or contact time were investigated for the treatment of two greywaters of low and high organic strengths. The results obtained revealed that magnetic ion exchange resin and coagulation were suitable treatment solutions for low strength greywater sources. However, they were unable to achieve the required level of treatment for the reuse of medium to high strength greywaters. Consequently, these processes could only be considered as an option for greywater recycling in specific conditions that is to say in case of low organic strength greywater or less stringent standards for reuse.