RESUMEN
In a preceding study a new technique to non-invasively measure the bladder volume on the basis of non-linear wave propagation was validated. It was shown that the harmonic level generated at the posterior bladder wall increases for larger bladder volumes. A dedicated transducer is needed to further verify and implement this approach. This transducer must be capable of both transmission of high-pressure waves at fundamental frequency and reception of up to the third harmonic. For this purpose, a multi-layer transducer was constructed using a single element PZT transducer for transmission and a PVDF top-layer for reception. To determine feasibility of the multi-layer concept for bladder volume measurements, and to ensure optimal performance, an equivalent mathematical model on the basis of KLM-circuit modeling was generated. This model was obtained in two subsequent steps. Firstly, the PZT transducer was modeled without PVDF-layer attached by means of matching the model with the measured electrical input impedance. It was validated using pulse-echo measurements. Secondly, the model was extended with the PVDF-layer. The total model was validated by considering the PVDF-layer as a hydrophone on the PZT transducer surface and comparing the measured and simulated PVDF responses on a wave transmitted by the PZT transducer. The obtained results indicated that a valid model for the multi-layer transducer was constructed. The model showed feasibility of the multi-layer concept for bladder volume measurements. It also allowed for further optimization with respect to electrical matching and transmit waveform. Additionally, the model demonstrated the effect of mechanical loading of the PVDF-layer on the PZT transducer.
Asunto(s)
Interpretación de Imagen Asistida por Computador/instrumentación , Imagenología Tridimensional/instrumentación , Modelos Teóricos , Transductores , Ultrasonografía/instrumentación , Vejiga Urinaria/diagnóstico por imagen , Animales , Simulación por Computador , Diseño Asistido por Computadora , Diseño de Equipo , Análisis de Falla de Equipo , Humanos , Interpretación de Imagen Asistida por Computador/métodos , Imagenología Tridimensional/métodos , Reproducibilidad de los Resultados , Sensibilidad y Especificidad , Ultrasonografía/métodosRESUMEN
BACKGROUND: Screening for abdominal aortic aneurysms (AAA) is cost-effective and timely repair improves outcome. Using standard ultrasound (US) an AAA can be accurately diagnosed or ruled-out. However, this requires training and bulk equipment. AIM: To evaluate the diagnostic potential of a new hand-held ultrasound bladder volume indicator (BVI) in the setting of AAA screening. METHODS: In total, 94 patients (66 +/- 14 years, 67 men) referred for atherosclerotic disease were screened for the presence of AAA (diameter > 30 mm using US). All patients underwent both examinations, with US and BVI. Using the BVI, aortic volume was measured at 6 pre-defined points. Maximal diameters (US) and volumes (BVI) were used for analyses. RESULTS: In 54 (57%) patients an AAA was diagnosed using US. The aortic diameter by US correlated closely with aortic volume by BVI (r = 0.87, p < 0.0001). Using a cut-off value of > or = 50 ml for the presence of AAA by BVI, sensitivity, specificity, positive and negative predictive value of BVI in detection of AAA were 94%, 82%, 88% and 92%, respectively. The agreement between the two methods was 89%, kappa 0.78. CONCLUSION: The bladder volume indicator is a promising tool in screening patients for AAA.