RESUMEN
Intermetallic compounds offer unique opportunities for atom-by-atom manipulation of catalytic ensembles through precise stoichiometric control. The (Pd, M, Zn) γ-brass phase enables the controlled synthesis of Pd-M-Pd catalytic sites (M = Zn, Pd, Cu, Ag and Au) isolated in an inert Zn matrix. These multi-atom heteronuclear active sites are catalytically distinct from Pd single atoms and fully coordinated Pd. Here we quantify the unexpectedly large effect that active-site composition (that is, identity of the M atom in Pd-M-Pd sites) has on ethylene selectivity during acetylene semihydrogenation. Subtle stoichiometric control demonstrates that Pd-Pd-Pd sites are active for ethylene hydrogenation, whereas Pd-Zn-Pd sites show no measurable ethylene-to-ethane conversion. Agreement between experimental and density-functional-theory-predicted activities and selectivities demonstrates precise control of Pd-M-Pd active-site composition. This work demonstrates that the diversity and well-defined structure of intermetallics can be used to design active sites assembled with atomic-level precision.
Asunto(s)
Aleaciones , Paladio , Aleaciones/química , Dominio Catalítico , Etilenos , Hidrogenación , Paladio/químicaRESUMEN
Undercoordinated, bridging O-atoms (Obr) are highly active as H-acceptors in alkane dehydrogenation on IrO2(110) surfaces but transform to HObrgroups that are inactive toward hydrocarbons. The low C-H activity and high stability of the HObrgroups cause the kinetics and product selectivity during CH4oxidation on IrO2(110) to depend sensitively on the availability of Obratoms prior to the onset of product desorption. From temperature programmed reaction spectroscopy (TPRS) and kinetic simulations, we identified two Obr-coverage regimes that distinguish the kinetics and product formation during CH4oxidation on IrO2(110). Under excess Obrconditions, when the initial Obrcoverage is greater than that needed to oxidize all the CH4to CO2and HObrgroups, complete CH4oxidation is dominant and produces CO2in a single TPRS peak between 450 and 500 K. However, under Obr-limited conditions, nearly all the initial Obratoms are deactivated by conversion to HObror abstracted after only a fraction of the initially adsorbed CH4oxidizes to CO2and CO below 500 K. Thereafter, some of the excess CHxgroups abstract H and desorb as CH4above â¼500 K while the remainder oxidize to CO2and CO at a rate that is controlled by the rate at which Obratoms are regenerated from HObrduring the formation of CH4and H2O products. We also show that chemisorbed O-atoms ('on-top O') on IrO2(110) enhance CO2production below 500 K by efficiently abstracting H from Obratoms and thereby increasing the coverage of Obratoms available to completely oxidize CHxgroups at low temperature. Our results provide new insights for understanding factors which govern the kinetics and selectivity during CH4oxidation on IrO2(110) surfaces.
RESUMEN
Copper-exchanged zeolites can continuously and selectively catalyze the partial oxidation of methane to methanol using only oxygen and water at low temperatures, but the genesis and nature of the active sites are currently unknown. Herein, we demonstrate that this reaction is catalyzed by a [Cu-O-Cu]2+ motif that forms via a hypothesized proton-aided diffusion of hydrated Cu ions within the cages of SSZ-13 zeolites. While various Cu configurations may be present and active for methane oxidation, a dimeric Cu motif is the primary active site for selective partial methane oxidation. Mechanistically, CH4 activation proceeds via rate-determining C-H scission to form a surface-bound C1 intermediate that can either be desorbed as methanol in the presence of H2O/H+ or completely oxidized to CO2 by gas-phase O2. High partial oxidation selectivity can be obtained with (i) high methane and water partial pressures and (ii) maximizing Cu dimer formation by using zeolites with high Al content and low Cu loadings.
Asunto(s)
Cobre/química , Metano/química , Metanol/química , Zeolitas/química , Catálisis , Difusión , Dimerización , Oxidación-Reducción , Espectrofotometría Ultravioleta , Espectroscopía Infrarroja por Transformada de Fourier , Agua/química , Espectroscopía de Absorción de Rayos XRESUMEN
Surface segregation in bimetallic nanoparticles (NPs) is critically important for their catalytic activity because the activity is largely determined by the surface composition. Little, however, is known about the atomic scale mechanisms and kinetics of surface segregation. One reason is that it is hard to resolve atomic rearrangements experimentally. It is also difficult to model surface segregation at the atomic scale because the atomic rearrangements can take place on time scales of seconds or minutes - much longer than can be modeled with molecular dynamics. Here we use the adaptive kinetic Monte Carlo (AKMC) method to model the segregation dynamics in PdAu NPs over experimentally relevant time scales, and reveal the origin of kinetic stability of the core@shell and random alloy NPs at the atomic level. Our focus on PdAu NPs is motivated by experimental work showing that both core@shell and random alloy PdAu NPs with diameters of less than 2 nm are stable, indicating that one of these structures must be metastable and kinetically trapped. Our simulations show that both the Au@Pd and the PdAu random alloy NPs are metastable and kinetically trapped below 400 K over time scales of hours. These AKMC simulations provide insight into the energy landscape of the two NP structures, and the diffusion mechanisms that lead to segregation. In the core-shell NP, surface segregation occurs primarily on the (100) facet through both a vacancy-mediated and a concerted mechanism. The system becomes kinetically trapped when all corner sites in the core of the NP are occupied by Pd atoms. Higher energy barriers are required for further segregation, so that the metastable NP has a partially alloyed shell. In contrast, surface segregation in the random alloy PdAu NP is suppressed because the random alloy NP has reduced strain as compared to the Au@Pd NP, and the segregation mechanisms in the alloy require more elastic energy for exchange of Pd and Au and between the surface and subsurface.
RESUMEN
Catalytic methane oxidation using N2 O was investigated at 300 °C over Fe-ZSM-5. This reaction rapidly produces coke (retained organic species), and causes catalyst fouling. The introduction of water into the feed-stream resulted in a significant decrease in the coke selectivity and an increase in the selectivity to the desired product, methanol, from ca. 1 % up to 16 %. A detailed investigation was carried out to determine the fundamental effect of water on the reaction pathway and catalyst stability. The delplot technique was utilised to identify primary and secondary reaction products. This kinetic study suggests that observed gas phase products (CO, CO2 , CH3 OH, C2 H4 and C2 H6 ) form as primary products whilst coke is a secondary product. Dimethyl ether was not detected, however we consider that the formation of C2 products are likely to be due to an initial condensation of methanol within the pores of the zeolite and hence considered pseudo-primary products. According to a second order delplot analysis, coke is considered a secondary product and its formation correlates with CH3 OH formation. Control experiments in the absence of methane revealed that the rate of N2 O decomposition is similar to that of the full reaction mixture, indicating that the loss of active alpha-oxygen sites is the likely cause of the decrease in activity observed and water does not inhibit this process.
RESUMEN
We report the structural evolution of Pd-Zn alloys in a 3.6% Pd-12% Zn/Al2O3 catalyst which is selective for propane dehydrogenation. High signal-to-noise, in situ synchrotron X-ray diffraction (XRD) was used quantitatively, in addition to in situ diffuse-reflectance infrared Fourier transform spectroscopy (DRIFTS) and extended X-ray absorption fine structure (EXAFS) to follow the structural changes in the catalyst as a function of reduction temperature. XRD in conjunction with DRIFTS of adsorbed CO indicated that the ß1-PdZn intermetallic alloy structure formed at reduction temperatures as low as 230 °C, likely first at the surface, but did not form extensively throughout the bulk until 500 °C which was supported by in situ EXAFS. DRIFTS results suggested there was little change in the surfaces of the nanoparticles above 325 °C. The intermetallic alloy which formed was Pd-rich at all temperatures but became less Pd-rich with increasing reduction temperature as more Zn incorporated into the structure. In addition to the ß1-PdZn alloy, a solid solution phase with face-center cubic structure (α-PdZn) was present in the catalyst, also becoming more Zn-rich with increasing reduction temperature.
RESUMEN
Oxide formation on palladium surfaces impacts the activity and selectivity of Pd-based catalysts, which are widely employed under oxygen rich operating conditions. To investigate oxidation processes over Pd catalysts at time and length scales inaccessible to quantum based computational methods, we have developed a Pd∕O interaction potential for the ReaxFF reactive force field. The parameters of the ReaxFF potential were fit against an extensive set of quantum data for both bulk and surface properties. Using the resulting potential, we conducted molecular dynamics simulations of oxide formation on Pd(111), Pd(110), and Pd(100) surfaces. The results demonstrate good agreement with previous experimental observations; oxygen diffusion from the surface to the subsurface occurs faster on the Pd(110) surface than on the Pd(111) and Pd(100) surfaces under comparable conditions at high temperatures and pressures. Additionally, we developed a ReaxFF-based hybrid grand canonical Monte Carlo∕molecular dynamics (GC-MC∕MD) approach to assess the thermodynamic stability of oxide formations. This method is used to derive a theoretical phase diagram for the oxidation of Pd935 clusters in temperatures ranging from 300 K to 1300 K and oxygen pressures ranging from 10(-14) atm to 1 atm. We observe good agreement between experiment and ReaxFF, which validates the Pd∕O interaction potential and demonstrates the feasibility of the hybrid GC-MC∕MD method for deriving theoretical phase diagrams. This GC-MC∕MD method is novel to ReaxFF, and is well suited to studies of supported-metal-oxide catalysts, where the extent of oxidation in metal clusters can significantly influence catalytic activity, selectivity, and stability.
RESUMEN
Manganese complexes of 1,4,7-trimethyl-1,4,7-triazacyclononane (tmtacn) are highly active and selective alkene oxidation catalysts with aqueous H(2)O(2). Here, carboxylic acid-functionalized SiO(2) simultaneously immobilizes and activates these complexes under oxidation reaction conditions. H(2)O(2) and the functionalized support are both necessary to transform the inactive [(tmtacn)Mn(IV)(µ-O)(3)Mn(IV)(tmtacn)](2+) into the active, dicarboxylate-bridged [(tmtacn)Mn(III)(µ-O)(µ-RCOO)(2)Mn(III)(tmtacn)](2+). This transformation is assigned on the basis of comparison of diffuse reflectance UV-visible spectra to known soluble models, assignment of oxidation state by Mn K-edge X-ray absorption near-edge spectroscopy, the dependence of rates on the acid/Mn ratios, and comparison of the surface structures derived from density functional theory with extended X-ray absorption fine structure. Productivity in cis-cyclooctene oxidation to epoxide and cis-diol with 2-10 equiv of solid cocatalytic supports is superior to that obtained with analogous soluble valeric acid cocatalysts, which require 1000-fold excess to reach similar levels at comparable times. Cyclooctene oxidation rates are near first order in H(2)O(2) and near zero order in all other species, including H(2)O. These observations are consistent with a mechanism of substrate oxidation following rate-limiting H(2)O(2) activation on the hydrated, supported complex. This general mechanism and the observed alkene oxidation activation energy of 38 ± 6 kJ/mol are comparable to H(2)O(2) activation by related soluble catalysts. Undesired decomposition of H(2)O(2) is not a limiting factor for these solid catalysts, and as such, productivity remains high up to 25 °C and initial H(2)O(2) concentration of 0.5 M, increasing reactor throughput. These results show that immobilized carboxylic acids can be utilized and understood like traditional carboxylic acids to activate non-heme oxidation catalysts while enabling higher throughput and providing the separation and handling benefits of a solid catalyst.
RESUMEN
The turn-over-rate (TOR) for the water gas shift (WGS) reaction at 200 degrees C, 7% CO, 9% CO(2), 22% H(2)O, 37% H(2) and balance Ar, of 1.4 nm Au/Al(2)O(3) is approximately 20 times higher than that of 1.6 nm Pt/Al(2)O(3). Operando EXAFS experiments at both the Au and Pt L(3) edges reveal that under reaction conditions, the catalysts are fully metallic. In the absence of adsorbates, the metal-metal bond distances of Pt and Au catalysts are 0.07 A and 0.13 A smaller than those of bulk Pt and Au foils, respectively. Adsorption of H(2) or CO on the Pt catalysts leads to significantly longer Pt-Pt bond distances; while there is little change in Au-Au bond distance with adsorbates. Adsorption of CO, H(2) and H(2)O leads to changes in the XANES spectra that can be used to determine the surface coverage of each adsorbate under reaction conditions. During WGS, the coverage of CO, H(2)O, and H(2) are obtained by the linear combination fitting of the difference XANES, or DeltaXANES, spectra. Pt catalysts adsorb CO, H(2), and H(2)O more strongly than the Au, in agreement with the lower CO reaction order and higher reaction temperatures.
RESUMEN
Bulk gold has long been regarded as a noble metal, having very low chemical and catalytic activity. However, metal oxide-supported gold particles, particularly those that are less than 5 nm in diameter, have been found to have remarkable catalytic properties. In this study we show that impinging gas-phase CO molecules react readily with oxygen adatoms preadsorbed on Au/TiO(2)(110) to produce CO(2) even under conditions in which the sample is cryogenically cooled. Gold particle size seems to have little effect on the CO oxidation reaction when oxygen adatoms are preadsorbed. We also show that as the oxygen adatom coverage increases, the rate of CO oxidation decreases on Au/TiO(2) at cryogenic temperatures.