Inactivation of food spoilage fungi by ultra violet (UVC) irradiation.

The effect of ultraviolet irradiation (254 nm, UVC) on Aspergillus flavus, Aspergillus niger, Penicillium corylophilum and Eurotium rubrum was investigated using three different exposure techniques. Survival was determined for spores suspended in liquid medium after 1, 2 and 3 min UVC exposure at 4644 J/m(2)/min. The same UVC dose was applied to spores on the surface of agar plates for 5, 10, 15, 30, 60 and 120 s. Spores of A. niger were dried onto a membrane filter, then exposed to UVC treatment. In the liquid medium, treatments from 1-3 min significantly (P<0.001) reduce the number of viable spores. On the surface of agar plates, after a 15 s exposure, a 80-99% reduction of viable spores was observed for all species except A. niger, for which the reduction was only 62%. For spores dried onto filter membranes, a 3.5 log(10) reduction was achieved for A. niger after 180 s exposure. These observations suggest that UVC irradiation can effectively inactivate spores of A. flavus, P. corylophilum, E. rubrum and A. niger but the efficacy of UVC radiation against fungal spores varies significantly according to methods of exposure to the irradiation, and among genera.

Microbiology of wheat and flour milling in Australia.

A survey was undertaken to determine the microbiological status of Australian wheat and the distribution of microorganisms in the flour milling fractions and end products. A total of 650 milling process and end product samples was obtained from nine flour mills located in New South Wales (4), Queensland (2), Victoria (2) and Western Australia (1) during the 1997-1998 and 1998-1999 wheat seasons. Most frequent (modal) counts in wheat and flour were, respectively, as follows: aerobic mesophilic plate count, 10(5) and 10(2) colony forming units/gram (cfu/g); coliforms, 10 and 1 most probable number/gram (MPN/g); Bacillus spp., 10(4) and 10(2) cfu/g; B. cereus, 1 and 0.1 MPN/g; mesophilic aerobic spores, 10 and 1 cfu/g; aerobic thermophiles, both 10 cfu/g; yeasts, 10(3) and 10(2) cfu/g, and moulds, 10(3) and 10(2) cfu/g. Bacillus spp., coliforms, yeasts and moulds were the most frequently detected microorganisms throughout the survey. The most common moulds isolated were Aspergillus, Penicillium, Cladosporium and Eurotium spp. Environmental serovars of Salmonella were isolated from two samples. Escherichia coli and B. cereus were present at very low levels, a majority of positive samples being at the minimum level of detection (3 and 0.3 MPN/g, respectively). As wheat grain layers are separated, surface-adhering contaminants are concentrated in end product bran, wheat germ and pollard, which comprise the outer layers of the grain. Consequently, the inner endosperm fraction contains lower microbial counts, and flour is the cleanest end product of the milling process. Higher microbiological counts midstream in the milling process indicate that equipment contamination may contribute to microbiological contamination; however, the microbiological quality of incoming wheat has a strong influence on the ultimate quality of milling end products.