RESUMEN
The purpose of this study was to compare characteristics and performances between single-phase (SP) and high-frequency (HF) generators for x-ray units dedicated to veterinary radiology practice. A 30-kW SP and a 30-kW high HF generator connected to a rotating anode x-ray tube were used for the study. Source-film distance, screen/film combination, and film processing were kept the same during the experiment. The mAs value yielding a similar film optical density of a stair step phantom, as assessed by a densitometer and a similar dose, as assessed by a solid state detector, was estimated for different kVp values. The ratio of the mAs used with the SP generator to the equivalent mAs used with the HF generator to produce similar film density or radiation dose was calculated. Subject contrast was measured for different kVp values as the relative difference in film optical density between two steps of the phantom. The waveform of the tube current was recorded for the two generators using an oscilloscope. Motion artifact was produced on a lateral radiograph of a canine tarsus using the two generators. Reproducibility was assessed by comparing the variances of film density measurements made on the central step of the phantom on 10 consecutive images produced with the two generators. mAs ratios (SP/HF) to obtain similar film optical density ranged from 2 (for 90kVp) to 2.5 (for 70 kVp), and mAs ratios to obtain similar radiation dose ranged from 1.2 (for 100 kVp) to 1.4 (for 70 kVp). Image contrast was slightly higher for the SP than for the HF generator. Current waveform for the SP generator was half-sinusoidal and it was almost continuous for the HF generator. Motion artifact appeared as blur for the HF generator and as several regularly placed images of the subject for the SP generator. Reproducibility was significantly better for the HF than for the SP generator (P = 0.047). It was concluded that the HF generator was approximately two times more efficient, had a better reproducibility, and produced images with a lower contrast than the SP generator. Motion artifact appears differently due to different current waveform.