Treated wastewater reuse in micro-irrigation: effect of shear stress on biofilm development kinetics and chemical precipitation.

Treated wastewater in micro-irrigation is a promising approach that could be used to decrease the pressure on good quality water resources. However, the clogging of such systems due to biofilm development and chemical precipitation constitute a constraint with the use of treated wastewater (TWW) and lead to lower irrigation system performance. The objective of this work is to study the development of biofilm and composition of fouling due to TWW under shear stresses of 0.7, 2.2 and 4.4 Pa detected along micro-irrigation systems. For this purpose, a Taylor-Couette reactor (TCR) was specifically calibrated for the cultivation of biofilm. The analysis of fouling composition samples (organic and inorganic) shows that biofilm tends to develop under the highest shear stress value (4.4 Pa). Precipitation of calcium carbonate in the form of calcite was observed in conjunction with biofilm growth using X-ray diffractometry (XRD) and thermogravimetric analysis (TGA). These results can be used to ascertain the origins of chemical and biological clogging of drippers and fouling of pipes related to reclaimed water- irrigation.

Methodology to Evaluate Dripper Sensitivity to Clogging due to Solid Particles: An Assessment.

Emitter clogging is a major problem in microirrigation systems, which may result from the isolated or combined effects of physical, chemical, and biological agents. Clogging caused by suspended solid particles is the most common plugging form of emitters. Water quality and emitter geometry are key aspects in clogging processes. Any suitable test procedure to assess the sensitivity of drippers to clogging should take into account the predominant factors that influence clogging and must reproduce the field conditions. This research set out to assess the performance and suitability of a laboratory clogging test procedure in order to validate a methodology and to provide scientific results that may support the standardization of a clogging test method. The evaluated methodology has been used by the IRSTEA laboratory since 1974 (Platform of Research and experiment on Science and Technology for Irrigation - PReSTI, formerly LERMI) and its contents are currently being discussed by the ISO TC23/SC18 committee. The aim is to define a standardized testing protocol to evaluate the sensitivity of emitters to clogging due to solid particles. Replications analyzing the clogging resistance of four models of emitting pipes were carried out in a laboratory. The clogging test procedure enabled an accurate assessment of the combinations of concentration and size of particles that caused clogging in each model of dripper. However, a significant variability in degree of clogging was identified when the results of replications for each model of dripper were compared. Several requirements, concerns, and improvements related to the clogging test protocol were discussed.

Integrated technological and management solutions for wastewater treatment and efficient agricultural reuse in Egypt, Morocco, and Tunisia.

Mediterranean-African countries (MACs) face a major water crisis. The annual renewable water resources are close to the 500 m3 /capita threshold of absolute water scarcity, and water withdrawals exceed total renewable water resources by 30%. Such a low water availability curbs economic development in agriculture, which accounts for 86% of freshwater consumption. The analysis of the current situation of wastewater treatment, irrigation, and water management in MACs and of the research projects targeted to these countries indicates the need for 1) an enhanced capacity to analyze water stress, 2) the development of water management strategies capable of including wastewater reuse, and 3) development of locally adapted water treatment and irrigation technologies. This analysis shaped the MADFORWATER project (www.madforwater.eu), whose goal is to develop a set of integrated technological and management solutions to enhance wastewater treatment, wastewater reuse for irrigation, and water efficiency in agriculture in Egypt, Morocco, and Tunisia. MADFORWATER develops and adapts technologies for the production of irrigation-quality water from drainage canals and municipal, agro-industrial, and industrial wastewaters and technologies for water efficiency and reuse in agriculture, initially validated at laboratory scale, to 3 hydrological basins in the selected MACs. Selected technologies will be further adapted and validated in 4 demonstration plants of integrated wastewater treatment and reuse. Integrated strategies for wastewater treatment and reuse targeted to the selected basins are developed, and guidelines for the development of integrated water management strategies in other basins of the 3 target MACs will be produced. The social and technical suitability of the developed technologies and nontechnological tools in relation to the local context is evaluated with the participation of MAC stakeholders and partners. Guidelines on economic instruments and policies for the effective implementation of the proposed water management solutions in the target MACs will be developed. Integr Environ Assess Manag 2018;14:447-462. © 2018 The Authors. Integrated Environmental Assessment and Management published by Wiley Periodicals, Inc. on behalf of Society of Environmental Toxicology & Chemistry (SETAC).