Subwavelength photocathodes via metal-assisted chemical etching of GaAs for solar hydrogen generation.

MacEtch allows subwavelength-structured (SWS) texturing on the GaAs surface without compromising crystallinity. The current density increases greatly, which is directly due to the reduction in the reflectance. Photons absorbed under reduced light reflectance are less affected by the charge recombination arising from crystal defects. The catalytic metal remaining after MacEtch serves as a catalyst for water splitting and increases the open-circuit potentials of the SWS GaAs photocathodes. The SWS GaAs not only amplifies the absorption of light, but also improves the collection of deeply generated photons at long wavelengths. The solar-weighted reflectance (SWR) of SWS GaAs is 6.6%, which was much lower than the 39.0% of bare GaAs. The light-limited photocurrent density (LLPC) increased by approximately 90% and the tafel slope improved as etching progressed. The external quantum efficiency was as high as 80%, especially at long wavelengths, after MacEtch. SWS GaAs photocathodes fabricated using MacEtch significantly reduce reflectance and recombination loss, thereby improving the key performance of PEC for hydrogen production. This technology can fully utilize the high absorption rate and carrier mobility of GaAs and is applicable to various photoelectric conversion device performance enhancements.

Three-Dimensional Flexible All-Organic Conductors for Multifunctional Wearable Applications.

Wearable textile electrodes based on π-conjugated polymers are appealing alternatives to carbon fabrics, conductive yarns, or metal wires because of their design flexibility, low cost, flexibility, and high throughput. This provides the benefits of both electronics and textiles. Herein, a general and new method has been developed to produce tailorable, wearable energy devices that are based on three-dimensional (3D) poly(3,4-ethylenedioxythiophene) (PEDOT)-coated textile conductors. To obtain the desired electrode materials, both facile solution-dropping polymerization methods are used to fabricate a 3D flexible PEDOT conductor on a cotton textile (PEDOT/textile). PEDOT/textile shows a very low sheet resistance of 4.6-4.9 Ω·sq-1. Here, we employ the example of this 3D network-like structure and the excellent electrical conductivities under the large deformation of PEDOT/textiles to show that wearable and portable heaters have immense potential. A flexible textile heater with a large area (8 × 7.8 cm2) reached a saturation temperature of ∼83.9 °C when a bias of 7 V was applied for ∼70 s due to the good electrical conductivity of PEDOT. To demonstrate the performance of all-solid-state supercapacitors, nano-ascidian-like PEDOT (PEDOT-NA) arrays were prepared via a simple vapor-phase polymerization of 3,4-ethylenedioxythiophene on PEDOT/textile to increase both the surface area and the number of ion diffusion paths. The PEDOT-NA arrays on PEDOT/textile showed outstanding performance with an areal capacitance of 563.3 mF·cm-2 at 0.4 mA·cm-2 and extraordinary mechanical flexibility. The maximum volumetric power density and energy density of the nanostructured PEDOT on the textile were 1.75 W·cm-3 and 0.0812 Wh·cm-3, respectively. It is expected that the wearable nanostructured conducting polymers will have advantages when used as structures for smart textronics and energy conversion/storage.

Three-Dimensional Hierarchically Mesoporous ZnCo2 O4 Nanowires Grown on Graphene/Sponge Foam for High-Performance, Flexible, All-Solid-State Supercapacitors.

To achieve high energy storage on three-dimensional (3D) structures at low cost, materials with high power and long cycle life characteristics have to be developed. We synthesized ZnCo2 O4 /reduced graphene oxide (rGO) binary composites in commercial sponges. ZnCo2 O4 nanosheets were grown on the surface of GO/sponge through a hydrothermal reaction. The resulting flexible, free-standing ZnCo2 O4 /rGO/sponge electrodes were used as the electrodes in a symmetric supercapacitor. ZnCo2 O4 /rGO/sponge electrodes have a large specific capacitance of 1116.6 F g-1 at a scan rate of 2 mV s-1 in aqueous electrolyte. The all-solid-state flexible supercapacitor is assembled based on ZnCo2 O4 /rGO/sponge electrodes, which show excellent electrochemical performances with a specific capacitance of 143 F g-1 at a current density of 1 A g-1 . The as-fabricated supercapacitor also exhibits excellent cycling stability (93.4 % capacitance retention after 5000 cycles) and exceptional mechanical flexibility. These results demonstrate the potential of ZnCo2 O4 /rGO/sponge as an electrode in flexible, high-performance supercapacitors.

Lateral photovoltaic effect in flexible free-standing reduced graphene oxide film for self-powered position-sensitive detection.

Lightweight, simple and flexible self-powered photodetectors are urgently required for the development and application of advanced optical systems for the future of wearable electronic technology. Here, using a low-temperature reduction process, we report a chemical approach for producing freestanding monolithic reduced graphene oxide papers with different gradients of the carbon/oxygen concentration ratio. We also demonstrate a novel type of freestanding monolithic reduced graphene oxide self-powered photodetector based on a symmetrical metal-semiconductor-metal structure. Upon illumination by a 633-nm continuous wave laser, the lateral photovoltage is observed to vary linfearly with the laser position between two electrodes on the reduced graphene oxide surface. This result may suggest that the lateral photovoltaic effect in the reduced graphene oxide film originates from the built-in electric field by the combination of both the photothermal electric effect and the gradient of the oxygen-to-carbon composition. These results represent substantial progress toward novel, chemically synthesized graphene-based photosensors and suggest one-step integration of graphene-based optoelectronics in the future.

Highly water-soluble multi-walled carbon nanotubes amine-functionalized by supercritical water oxidation.

Multi-walled carbon nanotubes (MWNTs) have been amine-functionalized by eco-friendly supercritical water oxidation. The facilely functionalized MWNTs have high solubility (~84 mg L(-1)) in water and 78% transmittance at 30-fold dilution. The Tyndall effect is also shown for several liquids.

Highly qualified reduced graphene oxides: the best chemical reduction.

We report new step-by-step reduction methods by alternating two different reducing reagents with the order of hydrazine with NH(3) (NH)/HI in acetic acid (HI) and the reverse order (HI/NH) to understand nitrogen incorporation and removal or reduction for providing highly qualified reduced graphene oxides (rGOs).

Reduced graphene oxide by chemical graphitization.

Reduced graphene oxides (RG-Os) have attracted considerable interest, given their potential applications in electronic and optoelectronic devices and circuits. However, very little is known regarding the chemically induced reduction method of graphene oxide (G-O) in both solution and gas phases, with the exception of the hydrazine-reducing agent, even though it is essential to use the vapour phase for the patterning of hydrophilic G-Os on prepatterned substrates and in situ reduction to hydrophobic RG-Os. In this paper, we report a novel reducing agent system (hydriodic acid with acetic acid (HI-AcOH)) that allows for an efficient, one-pot reduction of a solution-phased RG-O powder and vapour-phased RG-O (VRG-O) paper and thin film. The reducing agent system provided highly qualified RG-Os by mass production, resulting in highly conducting RG-O(HI-AcOH). Moreover, VRG-O(HI-AcOH) paper and thin films were prepared at low temperatures (40 °C) and were found to be applicable to flexible devices. This one-pot method is expected to advance research on highly conducting graphene platelets.

[A case of limited Wegener's granulomatosis with gastroenteritis and mesenteric lymphadenopathy].

Wegener's granulomatosis (WG) is a disease characterized by a granulomatous necrotizing vasculitis of small vessels. Although any organ systems can be involved, gastrointestinal involvement in WG is notably uncommon. We present a case of 67-year-old man who was admitted with abdominal pain and diarrhea lasting for 3 weeks. Colonoscopy and abdominal CT scan revealed vasculitis and multiple mesenteric lymphadenopathy. Jejunum and mesenteric lymph nodes biopsies confirmed limited form of WG. The present case indicates that WG might involve only gastrointestinal tract and the histological confirmation is important for diagnosis.

Temperature dependence on the grating formation in a low-Tg polymeric photorefractive composite.

We investigated a dependence of the grating formation on the temperature in polymeric photorefractive (PR) composite, in terms of magnitude and buildup speed of the PR grating. For polymeric PR materials, the temperature is one of the most important factors together with the external electric field because it is closely related on photocharge generation efficiency, mobility of generated carrier, electro-optic coefficient tensor, and so on. Above the glass transition temperature, the diffraction efficiency of degenerate four-wave mixing decreased with increasing the temperature; it can be explained with the magnitude of space-charge field and the electro-optic behavior at different temperatures. The space-charge field decreased linearly with increasing temperature due to a decrease in the photocharge generation efficiency and an increase in the hole detrapping by the high dark conductivity. Also as we expected, the PR grating buildup speed, which is strongly dependent on the photoconductivity, steeply decreased with increasing the temperature, and its tendency was similar to the temperature dependence of the phase shift.

Dependence of the Bragg condition on an external electric field for a polymeric photorefractive material.

We investigated the effect of an applied electric field on the Bragg condition of degenerate four-wave mixing a polymeric photorefractive material with a low glass-transition temperatue. For a polymeric photorefractive material the application of an external electric field is necessary for photorefractivity leads to birefringence of the material by poling of the nonlinear optical chromophore. Because the propagation vectors of the pumping and reading beams inside the material are influenced by the refractive index of the material, the Bragg condition depends on the magnitude of the external field. Using an oriented gas model and the-coupled-mode theory, we numerically analyzed the Bragg-mismatch effect that causes a reduction in diffraction efficiency as a function of an external field. We present the boundary conditions for sample thickness and grating spacing for which the Bragg-mismatch effect must be taken into account.