Anti-staphylococcal effects of Myracrodruon urundeuva lectins on nonresistant and multidrug resistant isolates.

AIMS: To evaluate the anti-staphylococcal effects of lectins isolated from bark (MuBL), heartwood (MuHL) and leaves (MuLL) of Myracrodruon urundeuva. METHODS AND RESULTS: The lectins were evaluated for: effects on growth, aggregation, haemolytic activity and biofilm-forming ability of Staphylococcus aureus clinical isolates nonresistant (8325-4) and multidrug resistant (LAC USA300); interference with the expression of virulence genes (hla, rnaIII and spa) of the Agr system of S. aureus; and synergistic effect with the antibiotics cefoxitin and cefotaxime. MuBL, MuHL and MuLL reduced growth (minimal inhibitory concentration (MIC): 12·5-50 µg ml-1 ) and viability (minimal bactericidal concentration (MBC): 100 µg ml-1 ) of 8325-4 and LAC USA300 cells. MuLL (at ½MIC and MIC) reduced LAC USA300 agglutination. The lectins did not interfere with haemolytic activity and expression of hla, rnaIII and spa genes. Only MuHL was able to reduce the biofilm production by 8325-4 (50-400 µg ml-1 ) and LAC USA300 (400 µg ml-1 ). CONCLUSION: The M. urundeuva lectins showed antibacterial activity against nonresistant and resistant clinical isolates of S. aureus and synergistic effects with antibiotics in reducing growth and biofilm formation. SIGNIFICANCE AND IMPACT OF THE STUDY: This work reports bioactive molecules capable of acting as anti-staphylococcal agents, since there are increasing reports of multiresistant isolates of this bacterium.

Anti-Candida activity of the water-soluble lectin from Moringa oleifera seeds (WSMoL).

This work reports the effects of the water-soluble lectin from Moringa oleifera seeds (WSMoL) on growth and survival of Candida species. In addition, cellular alterations linked to the antifungal effect were investigated. The minimal inhibitory (MIC) and fungicidal (MFC) concentrations were determined and 24-h growth curves in absence and presence of lectin were established. Flow cytometry was used to evaluate the induction of apoptosis/necrosis, alterations in mitochondrial membrane potential (ΔΨm), and occurrence of lysosomal damage. WSMoL inhibited the growth of C. albicans, C. glabrata, C. krusei and C. parapsilosis with MIC of 20µg/mL. The lowest MFC (20µg/mL) was detected for C. glabrata and the highest (80µg/mL) for C. albicans and C. parapsilosis. The inhibitory effect started from the ninth to nineteenth hour of incubation depending on the fungal species. Incubation with the lectin at the MIC for 24h increased the number of cells undergoing apoptosis and necrosis. Hyperpolarization of the mitochondrial membrane was detected after 12-h treatment, followed by reduction of ΔΨm or depolarization after 24h. No lysosomal damage was detected in treated cells. In conclusion, WSMoL is a fungistatic and fungicide agent against Candida with differential effects depending on the species.

Lectins as antimicrobial agents.

The resistance of micro-organisms to antimicrobial agents has been a challenge to treat animal and human infections, and for environmental control. Lectins are natural proteins and some are potent antimicrobials through binding to carbohydrates on microbial surfaces. Oligomerization state of lectins can influence their biological activity and maximum binding capacity; the association among lectin polypeptide chains can alter the carbohydrate-lectin binding dissociation rate constants. Antimicrobial mechanisms of lectins include the pore formation ability, followed by changes in the cell permeability and latter, indicates interactions with the bacterial cell wall components. In addition, the antifungal activity of lectins is associated with the chitin-binding property, resulting in the disintegration of the cell wall or the arrest of de novo synthesis from the cell wall during fungal development or division. Quorum sensing is a cell-to-cell communication process that allows interspecies and interkingdom signalling which coordinate virulence genes; antiquorum-sensing therapies are described for animal and plant lectins. This review article, among other approaches, evaluates lectins as antimicrobials.

Multi-effect of the water-soluble Moringa oleifera lectin against Serratia marcescens and Bacillus sp.: antibacterial, antibiofilm and anti-adhesive properties.

AIMS: To evaluate the antibiofilm potential of water-soluble Moringa oleifera seed lectin (WSMoL) on Serratia marcescens and Bacillus sp. METHODS AND RESULTS: WSMoL inhibited biofilm formation by S. marcescens at concentrations lower than 2·6 µg ml-1 and impaired bacterial growth at higher concentrations, avoiding biofilm formation. For Bacillus sp., the lectin inhibited bacterial growth at all concentrations. The antibiofilm action of WSMoL is associated with damage to bacterial cells. WSMoL did not disrupt preformed S. marcescens biofilms but was able to damage cells inside them. On the other hand, the lectin reduced the number of cells in Bacillus sp. biofilm treated with it. WSMoL was able to control biofilm formation when immobilized on glass surface (116 µg cm-2 ), damaging S. marcescens cells and avoiding adherence of Bacillus sp. cells on glass. The Bacillus sp. isolate is member of Bacillus subtilis species complex and closely related to species of the conspecific 'amyloliquefaciens' group. CONCLUSION: WSMoL prevented biofilm development by S. marcescens and Bacillus sp. and the antibiofilm effect is also observed when the lectin is immobilized on glass. SIGNIFICANCE AND IMPACT OF THE STUDY: Taking together, our results provide support to the potential use of WSMoL for controlling biofilm formation by bacteria.

Water-soluble Moringa oleifera lectin interferes with growth, survival and cell permeability of corrosive and pathogenic bacteria.

AIMS: This work evaluated the antibacterial activity of a water-soluble Moringa oleifera seed lectin (WSMoL) by evaluating its effect on growth, survival and cell permeability of Bacillus sp., Bacillus cereus, Bacillus pumillus, Bacillus megaterium, Micrococcus sp., Pseudomonas sp., Pseudomonas fluorescens, Pseudomonas stutzeri and Serratia marcescens. In addition, the effect of lectin on membrane integrity of most sensitive species was also evaluated. All the tested bacteria are able to cause biocorrosion and some are also responsible for human infections. METHODS AND RESULTS: WSMoL inhibited the bacterial growth, induced agglutination and promoted the leakage of proteins from cells of all strains. Bactericidal effect was detected against Bacillus sp., B. pumillus, B. megaterium, Ps. fluorescens and Ser. marcescens. The bacteriostatic effect of lectin was evident with only 6 h of incubation. Fluorescence microscopy of Ser. marcescens showed that WSMoL caused loss of cell integrity and indicated an anti-biofilm activity of the lectin. CONCLUSIONS: WSMoL was active against the bacteria by inhibiting growth and affecting cell permeability. The lectin also interfered with membrane integrity of Ser. marcescens, the most sensitive species. SIGNIFICANCE AND IMPACT OF THE STUDY: The study indicates that WSMoL was active against bacteria that cause serious problems in both industrial and health sectors. Also, the study contributes for the 'state-of-art' on antibacterial mechanisms of lectins.

The use of microemulsions to remove chromium from industrial sludge.

In this work microemulsion systems were used to remove chromium from leather tannery sediments. The sludge was treated by a solid-liquid extraction process (acid digestion). The effects of particle size, digestion temperature and digestion time with regards to the efficiency of chromium removal were considered. The raw sludge (3 Mesh) was dried, grounded and sieved. Particles with 3, 14, 65, 100, 200, and 325 Mesh were evaluated. Sludge digestion solutions were prepared using each studied granule size at 25 degrees C, 70 degrees C, and 95 degrees C. Microemulsion extraction experiments to remove chromium III from the acid digestion solution were made according to a Scheffé Net experimental design methodology, using microemulsion systems inside the Winsor II region (System I) and inside the microemulsion region (Winsor IV--System II). A statistical treatment was used to obtain the isoresponse plots. Chromium extraction percentages were up to 73.3% for System I and up to 93.4% for System II.

Evaluation and optimization of chromium removal from tannery effluent by microemulsion in the Morris extractor.

In this research a surfactant derived from a vegetable oil (coconut oil) was used to remove chromium from a tannery effluent. In the extraction process, a Morris extractor was used. Important variables used in assessing the optimization of the process included agitation speed, solvent rate and total flow rate. The experiments were conducted using a 2(3) factorial design. According to the response from the experimental design, the effects of each variable were calculated and the interactions between them determined. Response surface methodology was employed to study the effects of the studied variables. The optimum operational conditions were: agitation speed, 428 rpm; solvent rate, 0.37; total flow rate, 2.0 l h(-1). After extraction process, a re-extraction study was accomplished and the obtained results showed that chromium could be removed from the microemulsion phase by hydrochloric and sulphuric acidic solutions, what allows its reuse in the leather manufacturing process.

Heavy metals extraction by microemulsions.

The objective of this study is the heavy metal extraction by microemulsion, using regional vegetable oils as surfactants. Firstly, the main parameters, which have influence in the microemulsion region, such as: nature of cosurfactant, influence of cosurfactant (C)/surfactant (S) ratio and salinity were studied, with the objective of choosing the best extraction system. The extraction/reextraction process by microemulsion consists of two stages. In the first one, the heavy metal ion present in the aqueous phase is extracted by the microemulsion. In a second step, the reextraction process occurs: the microemulsion phase, rich in metal, is acidified and the metal is recovered in a new aqueous phase, with higher concentration. The used system had the following parameters: surfactant-saponified coconut oil; cosurfactant-n-butanol; oil phase-kerosene; C/S ratio=4; salinity-2% (NaCl); temperature of 27+/-1 degrees C; water phase-aqueous solution that varied according to the heavy metal in study (Cr, Cu, Fe, Mn, Ni and Pb). A methodology of experimental planning was used (Scheffé Net) to study the behavior of the extraction in a chosen domain. The extraction was accomplished in one step and yielded extraction percentage higher than 98% for all metals. In the reextraction HCl-8M was used as reextraction agent and the influence of the pH and time were verified. This work showed the great efficiency of the microemulsion, indicating that it is possible to extract selectively the heavy metals from the aqueous phase.

Removal of chromium from aqueous solutions by diatomite treated with microemulsion.

In order to evaluate the sorption of heavy metals, a crude diatomite was impregnated with a microemulsion which showed remarkable increase in chromium sorption capacity as compared to untreated diatomite. Samples with two different granulometries were investigated, both yielding practically complete adsorption. The adsorption process is pH dependent and the best results for the initial Cr (III) concentration of 1.5 g/L were obtained at pH 2.95. The effect of the concentration of the chromium synthetic solution was also investigated. The adsorption isotherms were obtained (30. 40 and 50 degrees C) and the Freundlich and Langmuir models were used to determine the adsorption capacity of the adsorbent. Following the adsorption step, a desorption process was carried out using several eluant solutions. The best results were obtained using hydrochloric acid (100%) as eluant.