Fe3O4@nitrogen-doped carbon core-double shell nanotubes as a novel and efficient nanosorbent for ultrasonic assisted dispersive magnetic solid phase extraction of heterocyclic pesticides from environmental soil and water samples.

Fe3O4@nitrogen-doped carbon core-double shell nanotubes (Fe3O4@N-C C-DSNTs) were successfully synthesized and applied as a novel nanosorbent in ultrasonic assisted dispersive magnetic solid phase extraction (UA-DMSPE) of tribenuron-methyl, fenpyroximate, and iprodione. Subsequently, corona discharge ion mobility spectrometry (CD-IMS) was employed for the detection of the extracted analytes. Effective parameters on the extraction recovery percentage (ER%) were systematically investigated and optimized. Under optimal conditions, UA-DMSPE-CD-IMS demonstrated remarkable linearity in different ranges within 1.0 - 700 ng mL-1 with correlation coefficients exceeding 0.993, repeatability values below 6.9%, limits of detection ranging from 0.30 to 0.90 ng mL-1, high preconcentration factors (418 - 435), and ER% values (83 - 87%). The potential of the proposed method was further demonstrated by effectively determining the targeted pesticides in various environmental soil and water samples, exhibiting relative recoveries in the range 92.1 - 102%.

Direct synthesis of nitrogen-doped graphene on platinum wire as a new fiber coating method for the solid-phase microextraction of BXes in water samples: Comparison of headspace and cold-fiber headspace modes.

In this work, a new solid-phase microextraction fiber was prepared based on nitrogen-doped graphene (N-doped G). Moreover, a new strategy was proposed to solve problems dealt in direct coating of N-doped G. For this purpose, first, Graphene oxide (GO) was coated on Pt wire by electrophoretic deposition method. Then, chemical reduction of coated GO to N-doped G was accomplished by hydrazine and NH3. The prepared fiber showed good mechanical and thermal stabilities. The obtained fiber was used in two different modes (conventional headspace solid-phase microextraction and cold-fiber headspace solid-phase microextraction (CF-HS-SPME)). Both modes were optimized and applied for the extraction of benzene and xylenes from different aqueous samples. All effective parameters including extraction time, salt content, stirring rate, and desorption time were optimized. The optimized CF-HS-SPME combined with GC-FID showed good limit of detections (LODs) (0.3-2.3 µg/L), limit of quantifications (LOQs) (1.0-7.0 µg/L) and linear ranges (1.0-5000 µg/L). The developed method was applied for the analysis of benzene and xylenes in rainwater and some wastewater samples.

Application of a new fiber coating based on electrochemically reduced graphene oxide for the cold-fiber headspace solid-phase microextraction of tricyclic antidepressants.

A new fiber based on the electrochemical reduction of graphene oxide was prepared on a copper wire for solid-phase microextraction (SPME) applications. The prepared fiber was used for the SPME and gas chromatographic analysis of tricyclic antidepressants (TCADs), including amitriptyline, trimipramine, and clomipramine. The feasibility of direct-immersion and headspace modes of SPME for the determination of TCADs was studied. The effects of four parameters including pH, salt content, extraction temperature with and without cooling the fiber, and extraction time were investigated. The comparison showed that headspace cold fiber SPME results in the best outcome for the extraction of TCADs. Under the optimized conditions of this mode, the calibration curves were linear between 2.0 and 500 ng/mL and the detection limits were between 0.30 and 0.53 ng/mL. The intraday and interday RSDs obtained at 20 ng/mL (n = 5), using a single fiber, were 5.5-9.0 and 7.5-9.8, respectively. The fiber to fiber repeatability (n = 4), expressed as the RSD, was between 12.8 and 13.2% at a 20 ng/mL concentration level. The method was successfully applied to the analysis of TCADs in plasma samples showing recoveries from 73 to 96%.

One-pot synthesis of 1,2,3-triazole linked dihydropyrimidinones via Huisgen 1,3-dipolar/Biginelli cycloaddition.

The combination of the Biginelli reaction with click chemistry has been used for the one-pot synthesis of 1,2,3-triazole linked dihydropyrimidinones from azides, aromatic aldehydes containing a propargyl ether group, urea, and 1,3-dicarbonyl compounds using Cu(OAc)(2)/sodium ascorbate as catalyst in acetic acid under mild reaction conditions.