A straight-forward fabrication of yuba films with controllable mechanical properties by oil-in-water emulsion model system rather than soymilk.

The traditional process of producing yuba films from soybeans strictly limits the development of its industrial production due to the numerous processes and intricate procedures involved. In this study, a straight-forward and effective strategy was proposed to substitute soymilk with an emulsion made from soybean protein isolate and soybean oil for the formation of yuba films. It was found that the mechanical properties of yuba films formed through this method were controlled by the concentrations of proteins and oils. As the protein concentrations increased, a higher ratio of adsorbed proteins adhered to the surface of oil droplets, which in turn facilitated the recombination of proteins and the formation of larger aggregates during heat incubation. The rheological properties and interfacial adsorption behavior suggested that larger protein aggregates exhibited a greater diffusion rate and were more prone to unfolding and re-crosslinking at the interface through heat induction, resulting in the formation of stronger protein networks. Confocal laser scanning microscope images revealed a notable increase in the density of oil distribution within the yuba films as the oil concentrations in the pre-emulsion rose. Combined with the dense protein network formed at high protein concentrations, the elongation of yuba films was significantly increased.

Structure of yuba films at the air/liquid interface as effected by the interfacial adsorption behavior of protein aggregates.

The effects of adsorption behavior and assembly mechanism of proteins and lipids at the interface on the formation of yuba films were investigated. The thickness of yuba films increased rapidly from nano to micro scale within minutes according to the scanning electron microscopy (SEM) images. The confocal laser scanning microscope (CLSM), SEM images, and sodium dodecyl sulfate-polyacrylamide gel electrophoresis revealed that the formation of protein aggregates (40-100 nm) was an essential requirement for the development of yuba. Meanwhile, a relatively loose spatial structure was formed by protein aggregates under the influence of water vapor. This structure served as the foundation for incorporating lipids. Interfacial adsorption kinetics indicated that increasing the concentration (from 3 to 9 mg/mL) of protein aggregates enhanced the rearrangement rate. This finding demonstrated that the variations of interfacial protein aggregate concentration were a crucial factor leading to the non-linear growth of film thickness.

Effect of phytic acid combined with lactic acid on color and texture deterioration of ready-to-eat shrimps during storage.

To retard the deterioration of texture and color of ready-to-eat (RTE) shrimps during storage, phytic acid (PA) and lactic acid (LA) were used to soak the shrimp prior to cooking. The factors affecting texture (water holding capacity, protein oxidation and degradation, and microstructure) and color (Maillard reaction and lipid oxidation) were determined separately. The free radical and copper ion content were also determined in order to investigate the regulation mechanism of phytic acid and lactic acid on the texture and color of RTE shrimps. It was found that the inhibitor-treated RTE shrimps showed better texture and color properties than the control group, and the compound inhibitor (PA + LA) showed a better inhibition effect than single inhibitor. In addition, PA and LA prevented the oxidation of RTE shrimps by scavenging free radicals and chelating copper ions, which in turn enabled the regulation of color and texture deterioration.