RESUMEN
The study compares three variants of focus sensors designed for the optical topography measurement of rough surface specimens with submicron accuracy. We present a theoretical analysis of the focus sensor principles and the experimental measurements with a single point laser probe. A low coherent illumination beam was provided by a monochromatic laser source and a rotating diffuser, which reduced the speckles generated by the rough surface. The reflected beam was modulated by three specific optical elements (axicon, double wedge prism, four spherical lenses) realized by a spatial light modulator. A digital camera detected the output intensity patterns that were evaluated by the intensity centroid method. The results showed a good coincidence of the surface profiles obtained by the three sensor variants with the root-mean-square deviations below one micron. We discuss the results obtained for several specimens with various surface roughness and compare the differences between the three focus sensor variants.
RESUMEN
In this contribution, we investigate the properties of antireflective coatings on iodine-filled absorption cell windows. These coatings are subject to high temperatures during the cell production process and are in direct contact with the absorption medium, which influences their optical performance. We tested the thermal resistance of TiO2- and Ta2O5- based coatings produced using conventional electron beam evaporation (e-beam) and ion-assisted deposition (PIAD). We prepared a set of iodine-filled absorption cells that were used to test the coatings' resistance to iodine vapors. We show that the choice of coating materials, coating methods, and a well-chosen bakeout procedure can mitigate any unwanted effects, such as temperature-induced spectral shifts and optical losses inhomogeneities or settling of the absorption medium in the coating.
RESUMEN
Recently, increasing attention has been devoted to mastering a new technique of optical delivery of micro-objects tractor-beam'1, 2, 3, 4, 5, 6, 7, 8, 9. Such beams have uniform intensity profiles along their propagation direction and can exert a negative force that, in contrast to the familiar pushing force associated with radiation pressure, pulls the scatterer toward the light source. It was experimentally observed that under certain circumstances, the pulling force can be significantly enhanced6 if a non-spherical scatterer, for example, a linear chain of optically bound objects10, 11, 12, is optically transported. Here we demonstrate that motion of two optically bound objects in a tractor beam strongly depends on theirs mutual distance and spatial orientation. Such configuration-dependent optical forces add extra flexibility to our ability to control matter with light. Understanding these interactions opens the door to new applications involving the formation, sorting or delivery of colloidal self-organized structures.
RESUMEN
We present a design of a nanometrology measuring setup which is a part of the national standard instrumentation for nanometrology operated by the Czech Metrology Institute (CMI) in Brno, Czech Republic. The system employs a full six-axis interferometric position measurement of the sample holder consisting of six independent interferometers. Here we report on description of alignment issues and accurate adjustment of orthogonality of the measuring axes. Consequently, suppression of cosine errors and reduction of sensitivity to Abbe offset is achieved through full control in all six degrees of freedom. Due to the geometric configuration including a wide basis of the two units measuring in y-direction and the three measuring in z-direction the angle resolution of the whole setup is minimize to tens of nanoradians. Moreover, the servo-control of all six degrees of freedom allows to keep guidance errors below 100 nrad. This small range system is based on a commercial nanopositioning stage driven by piezoelectric transducers with the range (200 × 200 × 10) µm. Thermally compensated miniature interferometric units with fiber-optic light delivery and integrated homodyne detection system were developed especially for this system and serve as sensors for othogonality alignment.