RESUMEN
Clouds and blowing snow (BLSN) occur frequently over Antarctica, where it is critical to understand their feedbacks to surface and atmospheric boundary layer processes. Dome C, an elevated East Antarctic station, dominated by lengthy periods of surface longwave (LW) radiative cooling, is selected to reveal cloud and BLSN impacts within a largely stable environment. The sky condition is classified as clear, cloudy, or BLSN, using 3 years of Cloud-Aerosol Lidar and Infrared Pathfinder Satellite Observations satellite data. Co-located and contemporaneous in situ observations are used to investigate the relationship of sky condition with surface and atmospheric boundary layer thermal structure, focusing on seasonal variability. Results show that increased downwelling LW radiation from clouds abate surface radiative cooling losses, contributing to warming during all seasons. An increase of 3°C in the mean surface air temperature is observed during spring, whereas, a more dramatic rise (around 10°C), due to accompanying large-scale subsidence, is observed during fall and winter in association with clouds. For all seasons, the wind speed and wind speed shear are strongest during BLSN events, and the surface-based inversion is weakened by cooling which peaks in a shallow above-surface turbulent layer. The stronger background stability during fall and winter seasons, restricts turbulence and BLSN depths generally to the lowest tens of meters. The Earth's cryosphere is among the most rapidly evolving yet least well-observed regions, and knowledge of clouds and BLSN interactions with the typical stable atmospheric boundary layer can help further understand energy and moisture exchanges.
RESUMEN
The Cloud-Aerosol Transport System (CATS) lidar on board the International Space Station (ISS) operated from 10 February 2015 to 30 October 2017 providing range-resolved vertical backscatter profiles of Earth's atmosphere at 1064 and 532 nm. The CATS instrument design and ISS orbit lead to a higher 1064 nm signal-to-noise ratio than previous space-based lidars, allowing for direct atmospheric calibration of the 1064 nm signals. Nighttime CATS Version 3-00 data were calibrated by scaling the measured data to a model of the expected atmospheric backscatter between 22 and 26 km above mean sea level (AMSL). The CATS atmospheric model is constructed using molecular backscatter profiles derived from Modern-Era Retrospective analysis for Research and Applications, Version 2 (MERRA-2) re-analysis data and aerosol scattering ratios measured by the Cloud-Aerosol Lidar with Orthogonal Polarization (CALIOP). The nighttime normalization altitude region was chosen to simultaneously minimize aerosol loading and variability within the CATS data frame, which extends from 28 km to -2 km AMSL. Daytime CATS Version 3-00 data were calibrated through comparisons with nighttime measurements of the layer integrated attenuated total backscatter (iATB) from strongly scattering, rapidly attenuating opaque cirrus clouds. The CATS nighttime 1064 nm attenuated total backscatter (ATB) uncertainties for clouds and aerosols are primarily related to the uncertainties in the CATS nighttime calibration technique, which are estimated to be ~9%. Median CATS V3-00 1064 nm ATB relative uncertainty at night within cloud and aerosol layers is 7%, slightly lower than these calibration uncertainty estimates. CATS median daytime 1064 nm ATB relative uncertainty is 21% in cloud and aerosol layers, similar to the estimated 16-18% uncertainty in the CATS daytime cirrus cloud calibration transfer technique. Coincident daytime comparisons between CATS and the Cloud Physics Lidar (CPL) during the CATS-CALIPSO Airborne Validation Experiment (CCAVE) project show good agreement in mean ATB profiles for clear-air regions. Eight nighttime comparisons between CATS and the PollyXT ground based lidars also show good agreement in clear-air regions between 3-12 km, with CATS having a mean ATB of 19.7 % lower than PollyXT. Agreement between the two instruments (~7%) is even better within an aerosol layer. Six-month comparisons of nighttime ATB values between CATS and the Cloud-Aerosol Lidar with Orthogonal Polarization (CALIOP) also show that iATB comparisons of opaque cirrus clouds agree to within 19%. Overall, CATS has demonstrated that direct calibration of the 1064 nm channel is possible from a space based lidar using the atmospheric normalization technique.
RESUMEN
Snow grain size is an important parameter for cryosphere studies. As a proof of concept, this paper presents an approach to retrieve this parameter over Greenland, East and West Antarctica ice sheets from surface reflectances observed with the Geoscience Laser Altimeter System (GLAS) onboard the Ice, Cloud, and land Elevation Satellite (ICESat) at 1064 nm. Spaceborne lidar observations overcome many of the disadvantages in passive remote sensing, including difficulties in cloud screening and low sun angle limitations; hence tend to provide more accurate and stable retrievals. Results from the GLAS L2A campaign, which began on 25 September and lasted until 19 November, 2003, show that the mode of the grain size distribution over Greenland is the largest (~300 µm) among the three, West Antarctica is the second (~220 µm) and East Antarctica is the smallest (~190 µm). Snow grain sizes are larger over the coastal regions compared to inland the ice sheets. These results are consistent with previous studies. Applying the broadband snow surface albedo parameterization scheme developed by Garder and Sharp (2010) to the retrieved snow grain size, ice sheet surface albedo is also derived. In the future, more accurate retrievals can be achieved with multiple wavelengths lidar observations.
