RESUMEN
With the aim of demonstrating phase coexistence of two magnetic phases in an intermediate annealing regime and obtaining highly coercive FePt nanocomposite magnets, two alloys of slightly off-equiatomic composition of a binary Fe-Pt system were prepared by dynamic rotation switching and ball milling. The alloys, with a composition Fe53Pt47 and Fe55Pt45, were subsequently annealed at 400 °C and 550 °C and structurally and magnetically characterized by means of X-ray diffraction, 57Fe Mössbauer spectrometry and Superconducting Quantum Interference Device (SQUID) magnetometry measurements. Gradual disorder-order phase transformation and temperature-dependent evolution of the phase structure were monitored using X-ray diffraction of synchrotron radiation. It was shown that for annealing temperatures as low as 400 °C, a predominant, highly ordered L10 phase is formed in both alloys, coexisting with a cubic L12 soft magnetic FePt phase. The coexistence of the two phases is evidenced through all the investigating techniques that we employed. SQUID magnetometry hysteresis loops of samples annealed at 400 °C exhibit inflection points that witness the coexistence of the soft and hard magnetic phases and high values of coercivity and remanence are obtained. For the samples annealed at 500 °C, the hysteresis loops are continuous, without inflection points, witnessing complete exchange coupling of the hard and soft magnetic phases and further enhancement of the coercive field. Maximum energy products comparable with values of current permanent magnets are found for both samples for annealing temperatures as low as 500 °C. These findings demonstrate an interesting method to obtain rare earth-free permanent nanocomposite magnets with hard-soft exchange-coupled magnetic phases.
RESUMEN
The probabilities of locating peaks with a high relative peak-area uncertainty were determined empirically with nine types of peak-location software used in laboratories engaged in gamma-ray spectrometry measurements. It was found that it is not possible to locate peaks with a probability of 0.95, when they have a relative peak-area uncertainty in excess of 50%. Locating peaks at these relatively high peak-area uncertainties with a probability greater than 0.95 is only possible in the library-driven mode, where the peak positions are supposed a-priori. The deficiencies of the library-driven mode and the possibilities to improve the probabilities of locating peaks are briefly discussed.
RESUMEN
A method is presented for calculating the expected number of counts in peaks that have a large relative peak-area uncertainty and appear in measured gamma-ray spectra. The method was applied to calculations of the correction factors for peaks occurring in the spectra of radon daughters. It was shown that the factors used for correcting the calculated peak areas to their expected values decrease with an increasing relative peak-area uncertainty. The accuracy of taking the systematic influence inducing the correction factors into account is given by the dispersion of the correction factors corresponding to specific peaks. It was shown that the highest accuracy is obtained in the peak analyses with the GammaVision and Gamma-W software.
RESUMEN
To investigate the suitability of three lichen species (Cetraria islandica, Evernia prunastri, and Ramalina farinacea) as transplants to trace-element air biomonitoring, they were exposed on substratum-free supports, from July 1996 until July 1997, in three European countries with different climates (Germany, Italy, Romania), at six sites with different types of air pollutants (two in each country). After 2, 4, 6, and 12 months of exposure, some portions of thallus were collected, prepared, and measured by instrumental neutron activation analysis (INAA) at the Institute of Physics and Nuclear Engineering in Bucharest and by energy dispersive X-ray fluorescence analysis (EDXRFA) at the University of Hohenheim in Stuttgart. Fifteen environmentally relevant elements: As, Br, Ca, Co, Cr, Cu, Fe, K, Mn, Ni, Pb, S, Sb, V, and Zn were determined. The analytical results were compared statistically. To study the distribution of the trace-elements between the lichens and the lichen throughfall water inside a virtual column, the throughfall water was collected under the lichen transplants during 6 and 12 months. The dried residues were analysed by INAA at Bucharest. The accumulating capacity for all investigated species is evident. For a comparative evaluation, the initial element contents, the "accumulation factors" relative to the bulk deposition, the interspecies "calibration factors", and the "retention efficiencies", defined as ratios of the lichen enrichment to the sum of this enrichment and the content in the lichen throughfall water, were considered. These criteria attest the best suitability for Evernia prunastri, followed by Ramalina farinacea and Cetraria islandica.
Asunto(s)
Contaminantes Atmosféricos/análisis , Monitoreo del Ambiente/métodos , Líquenes/química , Metales Pesados/análisis , Calibración , Valores de ReferenciaRESUMEN
Thorium content in zircon sand, thorium ore and a thorium liquid sample (EU Laboratories Network Intercomparison), as well as in some Romanian building materials: sand, wood, tufa, asbestos-cement. cement mill dust, coal fly ash, bricks, and tile (28 samples) was deterimined by gamma ray spectrometry. For the building materials, 226Ra, 40K and 137Cs specific activities were also measured. The results were compared with the Romanian legal norms concerning the highest admissible levels for 232Th, 226Ra. and 40K radioactivity. and to Th, U, and K concentration values previously determined in our laboratory on similar types of samples.