An efficient removal approach for degradation of metformin from aqueous solutions with sulfate radicals.

Metformin consumption for diabetes treatment is increasing, leading to its presence in wastewater treatment plants where conventional methods cannot remove it. Therefore, this work aims to analyze the performance of advanced oxidation processes using sulfate radicals in the degradation of metformin from water. Experiments were performed in a photoreactor provided with a low-pressure Hg lamp, using K2S2O8 as oxidant and varying the initial metformin concentration (CA0), oxidant concentration (Cox), temperature (T), and pH in a response surface experimental design. The degradation percentages ranged from 26.1 to 87.3%, while the mineralization percentages varied between 15.1 and 64%. Analysis of variance (ANOVA) showed that the output variables were more significantly affected by CA0, Cox, and T. Besides, a reduction of CA0 and an increase of Cox up to 5000 µM maximizes the metformin degradation since the generation of radicals and their interaction with metformin molecules are favored. For the greatest degradation percentage, the first order apparent rate constant achieved was 0.084 min-1. Furthermore, while in acidic pH, temperature benefits metformin degradation, an opposite behavior is obtained in a basic medium because of recombination and inhibition reactions. Moreover, three degradation pathways were suggested based on the six products detected by HPLC-MS: N-cyanoguanidine m/z = 85; N,N-dimethylurea m/z = 89; N,N-dimethyl-cyanamide m/z = 71 N,N-dimethyl-formamide m/z = 74; glicolonitrilo m/z = 58; and guanidine m/z = 60. Finally, it was shown that in general the toxicity of the degradation byproducts was lower than the toxicity of metformin toward Chlamydomonas reinhardtii.

Synthesis of biochar from chili seeds and its application to remove ibuprofen from water. Equilibrium and 3D modeling.

In this work chili seeds (Capsicum annuum) were used as raw material in the synthesis of biochar at temperatures between 400 and 600 °C. The samples were chemically, texturally and morphologically characterized and their properties were correlated with the calcination temperature. The adsorption mechanism of IBP was elucidated by analyzing the effect of solution pH, ionic strength and temperature, whereas that, the intraparticle diffusion mechanism was clarified through the application of a 3D diffusional model. The results evidenced that raising the pyrolysis temperature promotes a greater content of disordered graphitic carbon (51.6-85.02%) with small surface area (0.52-0.18 m2/g) and low quantity of functional groups. The adsorption study demonstrated that the biochar synthesized at 600 °C (C600) enhances the adsorption capacity >50 folds compared with chili seeds. Moreover, at pH = 7 the adsorption mechanism is governed by π-acceptor and attractive electrostatic interactions, whereas at basic pH the main adsorption mechanism is π-acceptor. Additionally, hydrophobic interactions become important by increasing the presence of NaCl. The application of 3D diffusional model based on surface diffusion interpreted clearly the kinetic curves obtaining values of Ds ranging from 2.31 × 10-8-2.51 × 10-8 cm2 s-1. Besides, it was determined that intraparticle mass flux is larger along the shortest axis of the seed, and always directed toward the particle center. The maximum mass flux takes place in the center of particle, and it advances like a moving front as time was increased.