RESUMEN
Developing active and stable catalysts for carbon-free hydrogen production is crucial to mitigate the effects of climate change. Ammonia is a promising carbon-free hydrogen source, as it has a high hydrogen content and is liquid at low pressure, which allows its easy storage and transportation. We have recently developed a nickel-based catalyst with a small content of ruthenium supported on cerium oxide, which exhibits high activity and stability in ammonia decomposition. Here, we investigate mechanochemical milling for its synthesis, a faster and less energy-consuming technique than conventional ones. Results indicate that mechanochemical synthesis increases catalytic activity compared to the conventional incipient wetness impregnation method. The interaction between the metal precursors and the support is key in fine-tuning catalytic activity, which increases linearly with oxygen vacancies in the support. Moreover, the mechanochemical method modifies the oxidation state of Ni and Ru species, with a variation depending on the precursors.
RESUMEN
Ni-Fe nanocatalysts supported on CeO2 have been prepared for the catalysis of methane steam reforming (MSR) aiming for coke-resistant noble metal-free catalysts. The catalysts have been synthesized by traditional incipient wetness impregnation as well as dry ball milling, a green and more sustainable preparation method. The impact of the synthesis method on the catalytic performance and the catalysts' nanostructure has been investigated. The influence of Fe addition has been addressed as well. The reducibility and the electronic and crystalline structure of Ni and Ni-Fe mono- and bimetallic catalysts have been characterized by temperature programmed reduction (H2-TPR), in situ synchrotron X-ray diffraction (SXRD), X-ray photoelectron spectroscopy (XPS), and Raman spectroscopy. Their catalytic activity was tested between 700 and 950 °C at 108 L gcat-1 h-1 and with the reactant flow varying between 54 and 415 L gcat-1 h-1 at 700 °C. Hydrogen production rates of 67 mol gmet-1 h-1 have been achieved. The performance of the ball-milled Fe0.1Ni0.9/CeO2 catalyst was similar to that of Ni/CeO2 at high temperatures, but Raman spectroscopy revealed a higher amount of highly defective carbon on the surface of Ni-Fe nanocatalysts. The reorganization of the surface under MSR of the ball-milled NiFe/CeO2 has been monitored by in situ near-ambient pressure XPS experiments, where a strong reorganization of the Ni-Fe nanoparticles with segregation of Fe toward the surface has been observed. Despite the catalytic activity being lower in the low-temperature regime, Fe addition for the milled nanocatalyst increased the coke resistance and could be an efficient alternative to industrial Ni/Al2O3 catalysts.
