A model for predicting reduction in mobile phosphorus of lake sediment by aluminum drinking water treatment residuals.

Drinking water treatment residual (DWTR) derived from flocculation and sedimentation of raw water using aluminum coagulants is a valuable environmental remediation byproduct capable of inactivating phosphorus (P). However, no generalizable model exists in the literature to describe reduction of releasable (mobile) P in lake sediment as a result of DWTR addition. The reduction of mobile P (sum of labile P and reductant soluble P) was investigated in over 100 sub-samples using five sediment samples from two lakes and three DWTRs from different water treatment plants. A consistent relationship was determined across a range of mobile P contents (0.23 g/m2/cm to 0.92 g/m2/cm, or 15.8 to 186.1 µg/g DW) and DWTRs. The relationship was best described as a function of the mobile P content of the sediment and the oxalate-extractable aluminum content of the DWTR. An empirical model was developed to predict the immediate reduction in mobile P following the addition of DWTR containing aluminum. This model was validated using two additional lake sediments and one additional DWTR (R² = 0.995). Thus, the immediate inactivation of P in lake sediment following DWTR addition can be predicted with this model, which can be used with internal P loading or other water quality goals to determine an appropriate DWTR dose. Further recommendations were made about dosing DWTRs for lake restoration, allowing practitioners to use DWTR to inactivate P in lake sediment without conducting individual sorption experiments.

Denitrification of nitrate in regeneration waste brine using hybrid cation exchanger supported nanoscale zero-valent iron with/without palladium nanoparticles.

The Sustainable Development Goals require that reducing waste is a priority. This work described the application of an innovative zero-waste hybrid ion exchange nanotechnology that concurrently removed nitrate and induced denitrification to ammonia, with the ability to generate fertilizer for the agriculture sector from the recycled by-products. Herein, hybrid cation exchanger-supported zero-valent iron (Fe0), and bimetallic Fe0/Pd nanoparticles (HCIX-Fe0 and HCIX-Fe0/Pd) were synthesized and successfully validated for denitrification of nitrate in spent waste brine that contained nitrate. The kinetics of nitrate catalysis by both HCIX-Fe0 and HCIX-Fe0/Pd were compared and presented by six kinetic models, namely, zero-order, pseudo first- and second-order reaction, pseudo first- and second-order adsorption, and Elovich. HCIX-Fe0/Pd displayed a higher kinetic value than HCIX-Fe0, with k1 of 0.0019 and 0.0026 min-1, respectively. Nitrate was predominantly catalysed to NH4+ at a ratio of ammonia to other nitrogen compounds of around 80:20. Although HCIX-Fe0/Pd showed slightly better (14%) kinetic results, it was determined as unfavourable for real-life application due to low selectivity toward N2 gas and the need to use H2 gas. Based on practicability, the HCIX-Fe0 was further validated. The effect of salt (using NaCl) and the role of initial pH conditions were optimized and discussed. The recovery of nitrate removal was also calculated, and a recovery range of 91.42-99.14% was obtained for three consecutive runs. The sustainable, novel, zero waste hybrid ion exchange nanotechnology using the combination of two fixed-bed columns containing nitrate-selective resin for nitrate removal and novel HCIX-Fe0 for nitrate reduction to NH4+ may be a promising sustainable solution toward the goal of discharging zero nitrate waste to the environment.

Sensing performances of spinel ferrites MFe2O4 (M = Mg, Ni, Co, Mn, Cu and Zn) based electrochemical sensors: A review.

The history of ferrites comes from many centuries and was fundamental in many fields. Initially, ferrites were extracted directly from nature, but in the last century, scientists learned to produce ferrites with different properties that gave origin to many advances in industrial and instrumental applications. More recently, the designed preparation of ferrites with nanometric size revealed remarkable characteristics. In the last years, different spinel ferrites were used as electroactive layers to build high-performance modified electrodes. In this review, it is presented a critical overview of the utilization of spinel ferrites (with a general formula MFe2O4, where M2+ = Mg2+, Ni2+, Co2+, Cu2+, Mn2+ and Zn2+) to create differentiated voltammetric sensors. The association of these materials with graphene, glassy carbon, carbon nitride, ionic liquids, nanoparticles of noble metals, oxides of transition metals and other materials can produce notable synergic responses towards electrochemical activity. Some of these sensors can produce very sensitive signals and ample concentration ranges for compounds such hydrogen peroxide, glucose and bisphenol A, and present potential for many other applications. Along this review, all these aspects will be discussed and the main results are organized in tables, using as a base the metal associated with the ferrite.

Progress in COVID research and developments during pandemic.

The pandemic respiratory disease COVID-19 has spread over the globe within a small span of time. Generally, there are two important points are being highlighted and considered towards the successful diagnosis and treatment process. The first point includes the reduction of the rate of infections and the next one is the decrease of the death rate. The major threat to public health globally progresses due to the absence of effective medication and widely accepted immunization for the COVID-19. Whereas, understanding of host susceptibility, clinical features, adaptation of COVID-19 to new environments, asymptomatic infection is difficult and challenging. Therefore, a rapid and an exact determination of pathogenic viruses play an important role in deciding treatments and preventing pandemic to save the people's lives. It is urgent to fix a standardized diagnostic approach for detecting the COVID-19. Here, this systematic review describes all the current approaches using for screening and diagnosing the COVID-19 infectious patient. The renaissance in pathogen due to host adaptability and new region, facing creates several obstacles in diagnosis, drug, and vaccine development process. The study shows that adaptation of accurate and affordable diagnostic tools based on candidate biomarkers using sensor and digital medicine technology can deliver effective diagnosis services at the mass level. Better prospects of public health management rely on diagnosis with high specificity and cost-effective manner along with multidisciplinary research, specific policy, and technology adaptation. The proposed healthcare model with defined road map represents effective prognosis system.

Retracted: Imprinted ZnO nanostructure-based electrochemical sensing of calcitonin: A clinical marker for medullary thyroid carcinoma.

This article has been retracted: please see Elsevier Policy on Article Withdrawal (https://www.elsevier.com/about/our-business/policies/article-withdrawal). This article has been retracted at the request of the Editor following concerns raised by various readers. The article reports different electron micrographs for different sample preparations, but some images are of different areas from the same sample. Figure 4E is a magnified section of Figure 4C, and the images are identical as demonstrated by overlapping the images and adjusting for magnification scale. The article reports EDX spectra in Figure 5C and Figure 5D for samples that are reported as different. An overlay of the spectra indicate they are identical in magnitude and in the random fluctuations of noise except in the specific zones where the signal was expected to vary. These problems with the data presented cast doubt on all the data, and accordingly also the conclusions based on that data, in this publication. As such this article represents a severe abuse of the scientific publishing system. The scientific community takes a very strong view on this matter and apologies are offered to readers of the journal that this was not detected during the submission process.

Bismuth oxide decorated graphene oxide nanocomposites synthesized via sonochemical assisted hydrothermal method for adsorption of cationic organic dyes.

Bismuth oxide decorated graphene oxide (Bi2O3@GO) nanocomposites were successfully synthesized by sonochemical method followed by hydrothermal treatment. The structural, morphology/microstructure and functional groups were investigated through X-ray Diffraction (XRD), Field Emission Scanning Electron Microscopy (FESEM), Transmission Electron Microscopy (TEM) and Fourier Transform Infrared (FTIR) spectroscopy, respectively. In the FESEM and TEM studies, well dispersed Bi2O3 nanoparticles of size 3-5nm were found uniformly distributed throughout the surface and edges of GO sheets. The HRTEM measurements on the Bi2O3 nanoparticle decorated graphene oxide shows imaged lattice spacing of 3.2Å corresponding to (111) plane of Bi2O3 which confirms the successful synthesis of bismuth oxide decorated graphene oxide (Bi2O3@GO) nanocomposite. The synthesized nanocomposite was employed for adsorption and removal of cationic organic dyes like RhB from industrial wastewater. The effect of various parameters, viz., contact time, temperature, pH and amount of adsorbent on the adsorption capability as well as dye removal capacity of the adsorbent was studied in detail. Under optimized conditions, like, contact time (65min), amount of adsorbent (5mg), temperature (35°) and pH (4), the adsorption capacity of GO and Bi2O3@GO were recorded and the percentage of removal was found to be 64% and 80.7% for GO and Bi2O3@GO, respectively. The Bi2O3@GO nanocomposite shows higher adsorption capacity (320mg/g) as compare to only GO (224mg/g). The adsorption isotherm follows both the Temkin as well as Langmuir isotherm having heat of sorption 65.88 with Langmuir constant of 13.13 corresponding to the complete monolayer coverage of 387.44mg/g. The adsorption kinetics also follow, both pseudo first order and intraparticle diffusion model with adsorption capacity of 84.91mg/g and intra particle diffusion rate constant of 10.53mg/g min1/2 for Bi2O3@GO nanocomposites. Our results suggest that the prepared Bi2O3@GO nanocomposites possess potential application as high-performance renewable adsorbent for removal of toxic dyes from wastewater.

RETRACTED: Anisotropic (spherical/hexagon/cube) silver nanoparticle embedded magnetic carbon nanosphere as platform for designing of tramadol imprinted polymer.

This article has been retracted: please see Elsevier Policy on Article Withdrawal (https://www.elsevier.com/about/our-business/policies/article-withdrawal). This article has been retracted at the request of the Editor-in-Chief following concerns raised by a reader. The particles shown in Fig. 3F appear to be copies of each other as they share the identical arrangement of the characteristic speckles inside the particles. In addition, the extraordinary similarities observed between the data presented in Fig. 4C and in Fig. 3C in ACS Biomater. Sci. Eng., 2017, 3 (9), pp 2120­2135, 10.1021/acsbiomaterials.7b00089, Fig. 4A in Colloids and Surfaces B: Biointerfaces, Volume 142, 1 June 2016, Pages 248-258 10.1016/j.colsurfb.2016.02.053 and Fig. 1D in Biosensors and Bioelectronics, Volume 73, 15 November 2015, Pages 234-244, 10.1016/j.bios.2015.06.005 are highly unlikely. The problems with the data presented cast doubt on all the data, and accordingly also the conclusions based on that data, in this publication. As such this article represents a severe abuse of the scientific publishing system. The scientific community takes a very strong view on this matter and apologies are offered to readers of the journal that this was not detected during the submission process.

RETRACTED: Designing of carbon based fluorescent nanosea-urchin via green-synthesis approach for live cell detection of zinc oxide nanoparticle.

This article has been retracted: please see Elsevier Policy on Article Withdrawal (https://www.elsevier.com/about/our-business/policies/article-withdrawal). This article has been retracted at the request of Editor following concerns raised by a reader. There are significant concerns regarding the originality of the electron micrographs displayed in Fig. 1 (panels B-G, especially C). The concern is that these multi-particle images are comprised of copies of the same particles. These problems with the data presented cast doubt on all the data, and accordingly also the conclusions based on that data, in this publication. As such this article represents a severe abuse of the scientific publishing system. The scientific community takes a very strong view on this matter and apologies are offered to readers of the journal that this was not detected during the submission process

Single cell imprinting on the surface of Ag-ZnO bimetallic nanoparticle modified graphene oxide sheets for targeted detection, removal and photothermal killing of E. Coli.

A very cost-effective, fast, sensitive and specific imprinted polymer modified electrochemical sensor for the targeted detection, removal and destruction of Escherichia coli bacteria was developed onto the surface of Ag-ZnO bimetallic nanoparticle and graphene oxide nanocomposite. The nanocomposite played a dual role in this work, as a platform for imprinting of bacteria as well as a participated in their laser-light induced photo killing. In terms of sensing, our proposed sensor can detect E. Coli as few as 10CFUmL-1 and capture 98% of bacterial cells from their very high concentrated solution (105CFUmL-1). Similarly to the quantitative detection, we have also investigated the quantitative destruction of E. Coli and found that 16.0cm2 area of polymer modified glass plate is sufficient enough to kill 105CFUmL-1 in the small time span of 5 minutes. The obtained results suggest that our proposed sensor have potential to serve as a promising candidate for specific and quantitative detection, removal as well as the destruction of a variety of bacterial pathogens.