Influence of coating dental enamel with a TiF4-loaded polymeric primer on the adverse effects caused by a bleaching gel with 35% H2O2.

OBJECTIVE: To evaluate whether coating enamel with a polymeric primer (PPol) containing titanium tetrafluoride (TiF4) before applying a bleaching gel with 35% H2O2 (35% BG) increases esthetic efficacy, prevents changes in morphology and hardness of enamel, as well as reduces the cytotoxicity from conventional in-office bleaching. MATERIALS AND METHODS: Standardized enamel/dentin discs were stained and bleached for 45 min (one session) with 35% BG. Groups 2TiF4, 6TiF4, and 10TiF4 received the gel on the enamel previously coated with PPol containing 2 mg/mL, 6 mg/mL, or 10 mg/mL, respectively. No treatment or application of 35% BG directly on enamel were used as negative control (NC), and positive control (PC), respectively. UV-reflectance spectrophotometry (CIE L*a*b* system, ΔE00, and ΔWI, n = 8) determined the bleaching efficacy of treatments. Enamel microhardness (Knoop, n = 8), morphology, and composition (SEM/EDS, n = 4) were also evaluated. Enamel/dentin discs adapted to artificial pulp chambers (n = 8) were used for trans-amelodentinal cytotoxicity tests. Following the treatments, the extracts (culture medium + bleaching gel components diffused through the discs) were collected and applied to odontoblast-like MDPC-23 cells, which were assessed concerning their viability (alamarBlue, n = 8; Live/Dead, n = 4), oxidative stress (n = 8), and morphology (SEM). The amount of H2O2 in the extracts was also determined (leuco crystal violet/peroxidase, n = 8). The numerical data underwent one-criterion variance analysis (one-way ANOVA), followed by Tukey's test, at a 5% significance level. RESULTS: Regarding the ΔE00, no difference was observed among groups 2TiF4, 6TiF4, and PC (p > 0.05). The ΔWI was similar between groups 2TiF4 and PC (p > 0.05). The ΔWI of group 6TiF4 was superior to PC (p < 0.05), and group 10TiF4 achieved the highest ΔE00 and ΔWI values (p < 0.05). Besides limiting enamel microstructural changes compared to PC, group 10TiF4 significantly increased the hardness of this mineralized dental tissue. The highest cellular viability occurred in 10TiF4 compared to the other bleached groups (p < 0.05). Trans-amelodentinal H2O2 diffusion decreased in groups 2TiF4, 6TiF4, and 10TiF4 in comparison with PC (p < 0.05). CONCLUSION: Coating enamel with a PPol containing TiF4 before applying a 35% BG may increase enamel microhardness and esthetic efficacy and reduce the trans-amelodentinal cytotoxicity of conventional in-office tooth bleaching. The PPol containing 10 mg/mL of TiF4 promoted the best outcomes.

Catalysis-based approaches with biopolymers and violet LED to improve in-office dental bleaching.

This in vitro experimental investigation aimed to evaluate the impact of the combined application of a nanofiber scaffold (NS), a polymeric catalyst primer (PCP) containing 10 mg/mL of heme peroxidase enzyme, and violet LED (LEDv) on the esthetic efficacy (EE), trans-amelodentinal cytotoxicity (TC), and procedural duration of conventional in-office bleaching therapy. To achieve this, 96 standardized enamel/dentin discs were individually placed in artificial pulp chambers. A 35% hydrogen peroxide (H2O2) bleaching gel was administered for 45, 30, or 15 min to the enamel, either previously coated with NS + PCP or left uncoated, followed by irradiation with LEDv for 15 min or no irradiation. The established groups were as follows: G1, negative control (no treatment); G2, 35% H2O2/45 min; G3, NS + PCP + LEDv; G4, NS + PCP + 35%H2O2/45 min + LEDv; G5, NS + PCP + 35%H2O2/30 min + LEDv; and G6, NS + PCP + 35%H2O2/15 min + LEDv. Extracts (culture medium + gel components diffused through the discs) were collected and applied to odontoblast-like MDPC-23 cells. EE (ΔE00 and ΔWI) and TC were assessed using ANOVA/Tukey analysis (p < 0.05). The EE analysis revealed no statistical differences between G6 and G2 (p > 0.05). Cells in G6 exhibited higher viability and lower oxidative stress compared to other bleached groups (p < 0.05). In conclusion, employing NS + PCP + LEDv to catalyze a 35%H2O2 bleaching gel applied for 15 min to the enamel resulted in successful esthetic improvements and reduced the cytotoxicity commonly linked with traditional in-office bleaching procedures.

Pulp cell response to the application of silver diamine fluoride and potassium iodide on caries-like demineralized dentin.

OBJECTIVES: To investigate the response of pulp cells to the application of silver diamine fluoride (SDF) and potassium iodide (KI) on demineralized dentin. MATERIALS AND METHODS: The occlusal surfaces of human dentin discs (0.4 mm thick) with similar permeability were subjected to an artificial caries protocol, and then the discs were adapted into artificial pulp chambers. MDPC-23 cells were seeded on the healthy pulp dentin surface, while the demineralized surface was treated with SDF, KI, SDF + KI, or hydrogen peroxide (positive control-PC) (n = 8). The negative control (NC) received ultrapure water. After 24 h, cell viability (alamarBlue) and morphology (SEM) were evaluated. The extracts were then applied to new MDPC-23 cells seeded in culture plates to assess their viability and the formation of mineralized nodules (MN; Alizarin Red) after seven days. The data were analyzed using one-way analysis of variance/Tukey or Games-Howell tests (α = 5%). RESULTS: SDF and PC significantly reduced the viability of cells seeded on discs (45.6% and 71.0%, respectively). Only cells treated with SDF or PC detached from the dentin substrate, while the remaining cells showed altered morphology. Cells in contact with extracts showed less reduction in viability, but it was still more toxic compared to NC. Only PC reduced MN deposition. SDF + KI or KI alone did not affect the cell response. CONCLUSIONS: SDF applied alone showed a mild to moderate transdentinal cytotoxic effect on pulp cells. However, the combination of SDF + KI reduced the cytotoxic effects. Both materials used alone or in combination did not affect the mineralization ability of pulp cells. CLINICAL RELEVANCE: Besides improving esthetic results, associating potassium iodide with silver diamine fluoride may reduce the transdentinal cytotoxic effects of this cariostatic agent on pulp cells.

The influence of violet LED application time on the esthetic efficacy and cytotoxicity of a 35% H2O2 bleaching gel.

OBJECTIVE: To assess the potential influence of violet LED (V-LED) application time on the esthetic efficacy and cytotoxicity of a 35% H2O2 bleaching gel. METHODOLOGY: Stained and standardized enamel/dentin discs were subjected to one in-office tooth bleaching session (45 min), and the gel was either irradiated or not with V-LED. Thus, the following groups were established (n = 8): G1: No treatment (negative control, NC); G2: 35% H2O2 (positive control, PC); G3: 35%H2O2 + V-LED/15 min; G4: 35%H2O2 + V-LED/30 min; G5: 35%H2O2 + V-LED/45 min. First, esthetic efficacy was assessed (ΔE00 and ΔWI). Discs assembled in artificial pulp chambers were subjected to the same bleaching treatments. Then, the extracts (culture medium + diffused bleaching gel components) were collected and applied to MDPC-23 pulp cells, which were analyzed for viability (Live/Dead, MTT) and oxidative stress (OxS). The amount of H2O2 in the extracts was also determined (leuco crystal-violet/peroxidase). The data were subjected to ANOVA/Tukey at a 5% significance level. RESULTS: Although esthetic efficacy did not differ among the irradiated groups (G3, G4, and G5) (p > 0.05), their results were higher than in G2 (PC; p < 0.05). In the irradiated groups, the cell viability and OxS as well as the amount of H2O2 in the extracts were statistically similar to G2 (PC), regardless of irradiation time (p > 0.05). CONCLUSION: Although V-LED improves the esthetic outcome of in-office tooth bleaching, increasing irradiation time does not effect the color changes and cytotoxicity of this professional therapy.