Wool Keratin 3D Scaffolds with Light-Triggered Antimicrobial Activity.

Photoactivatable keratin sponges were prepared from protein aqueous solutions by the freeze-drying method, followed by photofunctionalization with two different photosensitizers (PS): Azure A (AzA) and 5,10,15,20-tetrakis [4-(2-N,N,N-trimethylethylthio)-2,3,5,6-tetrafluorophenyl]porphyrin tetraiodide salt (TTFAP). The prepared sponges have a porosity between 49% and 80% and a mean pore size in the 37-80 µm range. As compared to AzA, TTFAP interacts more strongly with the sponges as demonstrated by a lower PS release (6% vs 20%), a decreased swelling ratio (1.6 vs 7.4), and a slower biodegradation rate. Nevertheless, AzA-loaded sponges showed the highest photoactivity, as also demonstrated by their higher antibactericidal activity toward both Gram-positive and Gram-negative bacteria. The obtained results suggest that the antimicrobial photodynamic effect can be finely triggered through a proper selection of the amount and type of photosensitizer, as well as through the irradiation time. Finally, all the prepared sponges support human fibroblast cells growth, while no significant cell viability impairment is observed upon light irradiation.

Tethered ansa-bridged titanium complexes immobilized on 3-mercaptopropyl-functionalized silica gel and their application for the hydrosilylation of imines.

Four tethered titanocene complexes were covalently immobilized onto 3-mercaptopropyl-functionalized silica gel. We have investigated the influence of the length of the tether and of the ansa-bridge on the activity in the heterogeneous hydrosilylation of the cyclic imine 2-phenylpyrroline, taken as an illustrative example. Possible metal leaching during the reaction was investigated using ICP/OES, recycling studies and the three-phase test. The novel immobilized catalysts exhibit an activity similar to their homogeneous analogues in the tested hydrosilylation reactions with a TOF of ~20 h(-1). Furthermore, our results indicate that metal leaching is negligible under the applied reaction conditions.

UV-induced immobilization of tethered zirconocenes on H-terminated silicon surfaces.

A tethered ethylenebis(indenyl) zirconocene was covalently immobilized on H-terminated Si(111) surfaces using UV-mediated alkene hydrosilylation, thus making possible the development of structured catalytic surfaces with highly controlled properties.

Photochemistry of Dihydrido(hydrotris(3,5-dimethylpyrazolyl)borato)(Z-cyclooctene)iridium. Synthetic Intermediates and Mechanism of the Photochemical Formation of Hydridophenyl(hydrotris(3,5-dimethylpyrazolyl)borato)(trimethyl phosphite)iridium.

The photolysis of a benzene solution of [Tp(Me2)IrH(2)(COE)], 1 (Tp(Me2) = hydrotris(3,5-dimethylpyrazolyl)borate, COE = Z-cyclooctene), in the presence of P(OMe)(3), gives the stable novel complex [Tp(Me2)IrH(C(6)H(5))(P(OMe)(3))], 3a. The photochemical syntheses of [Tp(Me2)IrH(2)(P(OMe)(3))], from 1 and P(OMe)(3) in diethyl ether, and [Tp(Me2)IrH(2)(CH(2)=CHCOO(t)Bu)], from 1 in tert-butyl acrylate, are also reported. The above reactions and several experiments using C(6)D(6) and P(OCD(3))(3) show that, in all cases, the primary photoproduct is the 16-electron, five-coordinate iridium(III) intermediate {Tp(Me2)IrH(2)}, 6a, produced by loss of COE from 1. The above experiments also allow the postulation of a mechanistic pathway for the formation of 3a which involves the oxidative addition of an aromatic C-H bond by 6a. Furthemore, the photochemical reaction of 1 in the presence of P(OCD(3))(3) shows that, under the reaction conditions used, oxidative addition of C-H bonds of P(OMe)(3) and of coordinated Tp(Me2)-ligands, presumably, to the intermediates 6a and {Tp(Me2)IrH(C(6)H(5))}, also occurs. Thus, coordinatively unsaturated iridium(III) species readily activate C-H bonds.