RESUMEN
Pulse-modulated CW laser heat deposition modulates the darkness or the transparency of an aggregated medium in the high signal optical regimen. A recently reported work found that transient optical responses of molecular aggregates can be different depending on whether the sample is excited with a laser wavelength tuned within the absorption band of the monomer or within the absorption band of the aggregates. The different transient responses were attributed to different dynamic processes during the laser-induced disassembling of the molecular aggregates and may have implications in the field of organic electronics and optical devices, such as optical logical gates, optical power limiters and all-optical switching. In this paper laser beams with wavelengths of 663 nm and 532 nm were used to produce sudden changes in the thermodynamic equilibrium of the aggregation states of the ortho-toluidine blue dye, which allowed to observe the occurrence of the avalanche - mediated transient phenomenon in the laser-induced disassembling of ortho-toluidine blue (TBO) aggregates. A double exponential model was adjusted to the registered transient data. The obtained values for the fast components of the transient time responses of ortho-toluidine blue dye, for the studied concentrations, ranged from â¼ 6.5 to 9.5 ms at 532 nm, and from â¼ 43 to 48 ms at 663 nm. A single beam experiment was employed to evaluate the performance of the ortho-toluidine blue dye in a beam power-damping device, driven by the simultaneous and cooperative actions of the laser induced disassembling of aggregated dye units and the thermal lensing effect. It was found that the phenomenon of laser-induced dye disassembling of TBO, acting cooperatively with the thermal lensing effect, damps the laser beam power faster than the thermal lensing phenomenon alone. In addition, the results showed that the speed of the laser beam power-damping is dye dependent.
RESUMEN
Many studies have been conducted on the treatment of burns because they are important in morbidity and mortality. These studies are mainly focused on improving care and quality of life of patients. The aim of this study is the induction of standardized full-thickness burns of the skin of rats using the CO2 laser. The results show that non-contact technique using the CO2 laser is effective to induce such standardization of burning and is an important step in determining the efficiency of different therapies used in treating burns.