RESUMEN
The role of substrate topography in phenotype expression of in vitro cultured cells has been widely assessed. However, the production of the nanostructured interface via the deposition of sol-gel synthesized nanoparticles (NPs) has not yet been fully exploited. This is also evidenced by the limited number of studies correlating the morphological, structural and chemical properties of the grown thin films with those of the sol-gel 'brick' within the framework of the bottom-up approach. Our work intends to go beyond this drawback presenting an accurate investigation of sol-gel TiO2 NPs shaped as spheres and rods. They have been fully characterized by complementary analytical techniques both suspended in apolar solvents, by dynamic light scattering (DLS) and nuclear magnetic resonance (NMR) and after deposition on substrates (solid state configuration) by transmission electron microscopy (TEM) and powder x-ray diffraction (PXRD). In the case of suspended anisotropic rods, the experimental DLS data, analyzed by the Tirado-Garcia de la Torre model, present the following ranges of dimensions: 4-5 nm diameter (∅) and 11-15 nm length (L). These results are in good agreement with that obtained by the two solid state techniques, namely 3.8(9) nm ∅ and 13.8(2.5) nm L from TEM and 5.6(1) ∅ and 13.3(1) nm L from PXRD data. To prove the suitability of the supported sol-gel NPs for biological issues, spheres and rods have been separately deposited on coverslips. The cell response has been ascertained by evaluating the adhesion of the epithelial cell line Madin-Darby canine kidney. The cellular analysis showed that titania films promote cell adhesion as well clustering organization, which is a distinguishing feature of this type of cell line. Thus, the use of nanostructured substrates via sol-gel could be considered a good candidate for cell culture with the further advantages of likely scalability and interfaceability with many different materials usable as supports.
Asunto(s)
Coloides/química , Nanoestructuras/química , Transición de Fase , Titanio/química , Animales , Proliferación Celular , Perros , Células de Riñón Canino Madin Darby , Nanosferas/química , Nanosferas/ultraestructura , Nanoestructuras/ultraestructura , Nanotubos/química , Nanotubos/ultraestructura , Ácido Oléico/química , Tamaño de la Partícula , Espectroscopía de Protones por Resonancia Magnética , Espectroscopía Infrarroja por Transformada de Fourier , Agua/químicaRESUMEN
A one-pot, multicomponent strategy was used to synthesize the first example of the dirhenium carbonyl coordination complex 2, in which the two metal atoms are connected through a chiral helical-shaped diphosphine oxide. Thanks to the flexibility of the helix of helicene 1, complex 2 was isolated in quite a good yield as a stable compound. It was characterized by analytical and spectroscopic techniques as well as by single-crystal X-ray analysis, which confirmed the chemical structure and the peculiar architecture of 2. In addition, computational studies were in agreement with the transitions observed in the experimental UV-vis spectrum, revealing the presence of two bands with maxima at about 520 (metal-to-ligand charge transfer) and 400 nm (IL).
RESUMEN
The novel [Re2(µ-H)(µ-OOC-CPDT)(CO)6(µ-3-Me-pydz)] complex (1; OOC-CPDT = 4H-cyclopenta[2,1-b:3,4-b']dithiophene-4-carboxylate, 3-Me-pydz = 3-methylpyridazine) has been prepared and characterized by single-crystal X-ray diffraction, density functional theory (DFT), and time-dependent DFT computations, UV-vis absorption and emission spectroscopy, and cyclic voltammetry (CV). The measured properties indicate the lack of electronic communication in the ground state between the CPDT and the rhenium diazine moieties. Oxidative electropolymerization of 1, achieved by repeated potential cycling (-0.4 to +1.0 V vs Fc(+)/Fc, in acetonitrile) with different supporting electrolytes, on different electrodes, afforded an electroactive and stable metallopolymer (poly-1). In situ measurements of the mass of the growing film (on a gold electrode, with an electrochemical quartz microbalance) confirmed the regularity of the polymerization process. The polymer exhibits two reversible oxidation peaks of the thiophene chain and a broad irreversible reduction peak (-1.4 V, quite close to that observed for the reduction of monomer 1), associated with a remarkably delayed sharp return peak, of comparable associated charge, appearing in close proximity (+0.3 V) to the first oxidation peak of the neutral polythiophene chain. This charge-trapping effect can be observed upon repeated cycles of p and n doping, and the negative charge is maintained even if the charged electrode is removed from the solution for many hours. Electrochemical impedance spectroscopy showed that the main CV oxidation peak corresponds to facile charge transfer, combined with very fast diffusion of both electrons and ions within the polymer. In summary, poly-1 provides a new example of a metallopolymer, in which the conductive properties of the π-conjugated system are added to the redox behavior of the pendant-isolated complexes.
RESUMEN
The highly porous and robust [Ni(8)(OH)(4)(OH(2))(2)(4,4'-(buta-1,3-diyne-1,4-diyl)bispyrazolato)(6)](n) MOF can be used as a proof of concept for the incorporation and release of the non-conventional [Ru(p-cymene)Cl(2)(pta)] RAPTA-C metallodrug.
Asunto(s)
Antineoplásicos/química , Compuestos Organometálicos/química , Rutenio/química , CimenosRESUMEN
In this communication, a series of observations and data analyses coherently confirms the suitability of the novel metal-organic framework (MOF) [Zn(4)(µ(4)-O)(µ(4)-4-carboxy-3,5-dimethyl-4-carboxy-pyrazolato)(3)] (1) in the capture of harmful volatile organic compounds (VOCs). It is worthy of attention that 1, whose crystal structure resembles that of MOF-5, exhibits remarkable thermal, mechanical, and chemical stability, as required if practical applications are sought. In addition, it selectively captures harmful VOCs (including models of Sarin and mustard gas, which are chemical warfare agents), even in competition with ambient moisture (i.e., under conditions mimicking operative ones). The results can be rationalized on the basis of Henry constant and adsorption heat values for the different essayed adsorbates as well as H(2)O/VOC partition coefficients as obtained from variable-temperature reverse gas chromatography experiments. To further strengthen the importance of 1, its performance in the capture of harmful VOCs has been compared with those of well-known materials, namely, a MOF with coordinatively unsaturated metal sites, [Cu(3)(btc)(2)] and the molecular sieve active carbon Carboxen. The results of this comparison show that coordinatively unsaturated metal sites (preferential guest-binding sites) are ineffective for the capture of VOCs in the presence of ambient moisture. Consequently, we propose that the driving force of the VOC-MOF recognition process is mainly dictated by pore size and surface hydrophobicity.