Composting of recovered rock wool from hydroponics for the production of soil amendment.

Due to its fibrous structure and high water holding capacity, rock mineral wool (RMW) has boosted the development of hydroponics. Consequently, the amount of waste RMW has also increased tremendously, which has stimulated the research and development of RMW reuse options. In this study, composting and degradability of RMW from hydroponics (gRMW) were tested in combination with different ratios of biowaste compost, including physical and chemical properties of the starting and final materials, and potential ecological hazards of the final product. gRMW had high water holding capacity and low organic matter content, which was easily degradable. Limits of toxic elements according to EU regulation were not exceeded. Degraded gRMW mixtures with compost did not exhibit toxicity to plants or aquatic bacteria and showed intermediate or limited habitat function for earthworms, which preferred the sole gRMW not mixed with compost. Overall, degraded gRMW exhibited parameters of safe soil amendment.

Strategies for livestock wastewater treatment and optimised nutrient recovery using microalgal-based technologies.

Global sustainable development faces several challenges in addressing the needs of a growing population. Regarding food industries, the heightening pressure to meet these needs has resulted in increased waste generation. Thus, recognising these wastes as valuable resources is crucial to integrating sustainable models into current production systems. For instance, the current 24 billion tons of nutrient-rich livestock wastewater (LW) generated yearly could be recovered and valorised via biological uptake through microalgal biomass. Microalgae-based livestock wastewater treatment (MbLWT) has emerged as an effective technology for nutrient recovery, specifically targeting carbon, nitrogen, and phosphorus. However, the viability and efficacy of these systems rely on the characteristics of LW, including organic matter and ammonium concentration, content of suspended solids, and microbial load. Thus, this systematic literature review aims to provide guidance towards implementing an integral MbLWT system for nutrient control and recovery, discussing several pre-treatments used in literature to overcome the challenges regarding LW as a suitable media for microalgae cultivation.

Removal and fate of 18 bisphenols in lab-scale algal bioreactors.

The removal of 18 bisphenols at wastewater relevant concentrations (µg L-1 range) was investigated and compared between Chlorella vulgaris cultures with pH adjusted to 6.8 and pH non-adjusted cultures where pH raised to above 10. Bisphenols with a high partition coefficient (log P > 6) partitioned to biomass soon after spiking, whereas bisphenols with a low partition coefficient (log P < 4) remained largely in the aqueous phase. Hydrophobic bisphenols and BPF isomers were removed to a large degree in pH adjusted conditions, while BPS and BPAF were the most recalcitrant. The overall average removal after 13 days was similar in both experiments, with 72 ± 2% and 73 ± 5% removed in pH non-adjusted and pH adjusted series, respectively. The removal correlated with chlorophyll a concentration for most bisphenols meaning that algae played a crucial role in their removal, while culture pH also governed the removal of some compounds.

Extraction and Identification of a Wide Range of Microplastic Polymers in Soil and Compost.

Microplastic pollution is globally widespread; however, the presence of microplastics in soil systems is poorly understood, due to the complexity of soils and a lack of standardised extraction methods. Two commonly used extraction methods were optimised and compared for the extraction of low-density (polyethylene (PE)) and high-density microplastics (polyethylene (PET)), olive-oil-based extraction, and density separation with zinc chloride (ZnCl2). Comparable recoveries in a low-organic-matter matrix (soil; most >98%) were observed, but in a high-organic-matter matrix (compost), density separation yielded higher recoveries (98 ± 4% vs. 80 ± 11%). Density separation was further tested for the extraction of five microplastic polymers spiked at different concentrations. Recoveries were >93% for both soil and compost, with no differences between matrices and individual polymers. Reduction in levels of organic matter in compost was tested before and after extraction, as well as combined. Double oxidation (Fenton's reagent and 1 M NaOH) exhibited the highest reduction in organic matter. Extracted microplastic polymers were further identified via headspace solid-phase microextraction-gas chromatography-mass spectrometry (HS-SPME-GC-MS). This method has shown the potential for descriptive quantification of microplastic polymers. A linear relationship between the number of particles and the signal response was demonstrated for PET, polystyrene (PS), polyvinyl chloride (PVC), and PE (R2 > 0.98 in alluvial soil, and R2 > 0.80 in compost). The extraction and identification methods were demonstrated on an environmental sample of municipal biowaste compost, with the recovery of 36 ± 9 microplastic particles per 10 g of compost, and the detection of PS and PP.

Microalgae-based removal of contaminants of emerging concern: Mechanisms in Chlorella vulgaris and mixed algal-bacterial cultures.

Incomplete removal of contaminants of emerging concern (CECs) has been reported for conventional wastewater treatment technologies. Microalgae-based treatment has recently gained interest thanks to simultaneous removal capacity of organic and inorganic compounds and potentially CECs. In this study, a lab-scale monoculture of Chlorella vulgaris and mixed microalgal-bacterial culture were compared in terms of removal of 28 CECs (bisphenols, 2018 EU Watch List substances, including neonicotinoids, pharmaceuticals, selected transformation products). The removal pathways in light and dark abiotic controls were also studied. Batch photobioreactors were run at hydraulic retention times of 11-12 days and CECs spiked at environmentally relevant concentrations (1-20 µg L-1). The mixed culture was better at removing bisphenols, compared to C. vulgaris. Bisphenols' log Kow was significant in removal pathways, where bisphenols with high log Kow were removed abiotically while bisphenols with low log Kow were mainly biodegraded. The removal degrees and the pathways of pharmaceuticals and EU Watch List substances were comparable between both cultures, showing no impact of log Kow for most compounds; however, the removal with C. vulgaris was faster for some. High log Kow was associated with high removal of estradiol in abiotic controls, showing the importance of adsorption onto biomass and suspended matter.

Adsorption of acetamiprid, chlorantraniliprole and flubendiamide on different type of microplastics present in alluvial soil.

The presence of microplastics (MPs) and their effects have been widely investigated in the aquatic environment, whereas the research done in the terrestrial environment is incomparably lacking. MPs are considered a pollutant in soil on agricultural land, where they can act as a vector for other pollutants, namely organic chemical compounds, such as pesticides. In soil, presence of MPs is affecting the growth and life of microorganisms in it. The interactions between two types of MPs and three pesticides in the mixture with alluvial soil were studied. Adsorption of acetamiprid, chlorantraniliprole and flubendiamide in concentrations of 1, 5 and 10 mg L-1 onto polyester fibres and polypropylene particles of 0.5-1 mm size was studied at 1% and 5% (w/w) of their content in soil. Results showed that the adsorption of pesticides was dependent on their octanol/water partition coefficient, with the most highly adsorbed pesticide also being the most hydrophobic, regardless of the type and form of MPs. Adsorption of pesticides onto MP particles was confirmed in soil-MPs mixtures with 5% polypropylene and 5% polyester at all tested pesticides' concentrations, proving that MPs in soil systems act as carriers to pollutants. MPs in soil decreased the soil's intrinsic capacity to retain pesticides, indicating the possibility of a greater mobility of pesticides on MPs through the soil system.

Facile synthesis, structure, biocompatibility and antimicrobial property of gold nanoparticle composites from cellulose and keratin.

A novel, one-pot method was developed to synthesize gold nanoparticle composite from cellulose (CEL), wool keratin (KER) and chloroauric acid. Two ionic liquids, butylmethylimmidazolium chloride and ethylmethylimmidazolium bis(trifluoromethylsulfonyl)imide were used to dissolve CEL, KER and HAuCl4. X-ray diffraction and X-ray photoelectron results show that Au3+ was completely reduced to Au0NPs with size of (5.5±1) nm directly in the composite with NaBH4. Spectroscopy and imaging results indicate that CEL and KER remained chemically intact and were homogeneously distributed in the composites with Au0NPs. Encapsulating Au0NPs into [CEL+KER] composite made the composite fully biocompatible and their bactericidal capabilities were increased by the antibacterial activity of Au0NPs. Specifically, the [CEL+KER+Au0NPs] composite exhibited up to 97% and 98% reduction in growth of antibiotic resistant bacteria such as vancomycin resistant Enterococcus faecalis and methicillin resistant Staphylococcus aureus, and was not cytotoxic to human fibroblasts. While [CEL+KER] composite is known to possess some antibacterial activity, the enhanced antibacterial observed here was due solely to added Au0NPs. These results together with our previous finding that [CEL+KER] composites can be used for controlled delivery of drugs clearly indicate that the [CEL+KER+Au0NPs] composites possess all required properties for successful use as dressing to treat chronic ulcerous infected wounds.

One-Pot Synthesis of Biocompatible Silver Nanoparticle Composites from Cellulose and Keratin: Characterization and Antimicrobial Activity.

A novel, simple method was developed to synthesize biocompatible composites containing 50% cellulose (CEL) and 50% keratin (KER) and silver in the form of either ionic (Ag+) or Ag0 nanoparticles (Ag+NPs or Ag0NPs). In this method, butylmethylimmidazolium chloride ([BMIm+Cl-]), a simple ionic liquid, was used as the sole solvent and silver chloride was added to the [BMIm+Cl-] solution of [CEL+KER] during the dissolution process. The silver in the composites can be maintained as ionic silver (Ag+) or completely converted to metallic silver (Ag0) by reducing it with NaBH4. The results of spectroscopy [Fourier transform infrared and X-ray diffraction (XRD)] and imaging [scanning electron microscopy (SEM)] measurements confirm that CEL and KER remain chemically intact and homogeneously distributed in the composites. Powder XRD and SEM results show that the silver in the [CEL+KER+Ag+] and [CEL+KER+Ag0] composites is homogeneously distributed throughout the composites in either Ag+ (in the form of AgClNPs) or Ag0NPs form with sizes of 27 ± 2 or 9 ± 1 nm, respectively. Both composites were found to exhibit excellent antibacterial activity against many bacteria including Escherichia coli, Staphylococcus aureus, Pseudomonas aeruginosa, methicillin-resistant S. aureus (MRSA), and vancomycin-resistant Enterococus faecalis (VRE). The antibacterial activity of both composites increases with the Ag+ or Ag0 content in the composites. More importantly, for the same bacteria and the same silver content, the [CEL+KER+AgClNPs] composite is relatively more toxic than [CEL+KER+Ag0NPs] composite. Experimental results confirm that there was hardly any Ag0NPs release from the [CEL+KER+Ag0NPs] composite, and hence its antimicrobial activity and biocompatibility is due not to any released Ag0NPs but rather entirely to the Ag0NPs embedded in the composite. Both AgClNPs and Ag0NPs were found to be toxic to human fibroblasts at higher concentration (>0.72 mmol), and for the same silver content, the [CEL+KER+AgClNPs] composite is relatively more toxic than the [CEL+KER+Ag0NPs] composite. As expected, by lowering the Ag0NPs concentration to 0.48 mmol or less, the [CEL+KER+Ag0NPs] composite can be made biocompatible while still retaining its antimicrobial activity against bacteria such as E. coli, S. aureus, P. aeruginosa, MRSA, and VRE. These results, together with our previous finding that [CEL+KER] composites can be used for the controlled delivery of drugs such as ciprofloxacin, clearly indicate that the [CEL+KER+Ag0NPs] composite possesses all of the required properties for it to be successfully used as a high-performance dressing to treat chronic ulcerous infected wounds.

Synthesis, structure and antimicrobial property of green composites from cellulose, wool, hair and chicken feather.

Novel composites between cellulose (CEL) and keratin (KER) from three different sources (wool, hair and chicken feather) were successfully synthesized in a simple one-step process in which butylmethylimidazolium chloride (BMIm(+)Cl(-)), an ionic liquid, was used as the sole solvent. The method is green and recyclable because [BMIm(+)Cl(-)] used was recovered for reuse. Spectroscopy (FTIR, XRD) and imaging (SEM) results confirm that CEL and KER remain chemically intact and homogeneously distributed in the composites. KER retains some of its secondary structure in the composites. Interestingly, the minor differences in the structure of KER in wool, hair and feather produced pronounced differences in the conformation of their corresponding composites with wool has the highest α-helix content and feather has the lowest content. These results correlate well with mechanical and antimicrobial properties of the composites. Specifically, adding CEL into KER substantially improves mechanical strength of [CEL+KER] composites made from all three different sources, wool, hair and chicken feathers i.e., [CEL+wool], [CEL+hair] and [CEL+feather]. Since mechanical strength is due to CEL, and CEL has only random structure, [CEL+feather] has, expectedly, the strongest mechanical property because feather has the lowest content of α-helix. Conversely, [CEL+wool] composite has the weakest mechanical strength because wool has the highest α-helix content. All three composites exhibit antibacterial activity against methicillin resistant Staphylococcus aureus (MRSA). The antibacterial property is due not to CEL but to the protein and strongly depends on the type of the keratin, namely, the bactericidal effect is strongest for feather and weakest for wool. These results together with our previous finding that [CEL+KER] composites can control release of drug such as ciprofloxacin clearly indicate that these composites can potentially be used as wound dressing.