Potential Source Apportionment and Meteorological Conditions Involved in Airborne 131I Detections in January/February 2017 in Europe.

Traces of particulate radioactive iodine (131I) were detected in the European atmosphere in January/February 2017. Concentrations of this nuclear fission product were very low, ranging 0.1 to 10 µBq m-3 except at one location in western Russia where they reached up to several mBq m-3. Detections have been reported continuously over an 8-week period by about 30 monitoring stations. We examine possible emission source apportionments and rank them considering their expected contribution in terms of orders of magnitude from typical routine releases: radiopharmaceutical production units > sewage sludge incinerators > nuclear power plants > spontaneous fission of uranium in soil. Inverse modeling simulations indicate that the widespread detections of 131I resulted from the combination of multiple source releases. Among them, those from radiopharmaceutical production units remain the most likely. One of them is located in Western Russia and its estimated source term complies with authorized limits. Other existing sources related to 131I use (medical purposes or sewage sludge incineration) can explain detections on a rather local scale. As an enhancing factor, the prevailing wintertime meteorological situations marked by strong temperature inversions led to poor dispersion conditions that resulted in higher concentrations exceeding usual detection limits in use within the informal Ring of Five (Ro5) monitoring network.

The impact of the Solar magnetic field on 7Be activity concentration in aerosols.

In this paper the impact of the Solar magnetic field on 7Be activity concentration in aerosols was investigated. The changes in the 7Be activity in aerosols in the period from the second part of 22nd to the second part of 24th Solar cycle were mathematically processed using the Fourier analysis and the 22 years period was pointed out. It corresponds to the most intense period of the Solar polar field strength for the same observed period. The Pearson's linear coefficient between the average annual value of 7Be activity in aerosols and the Solar polar field strength was 0.58.

The Fourier analysis applied to the relationship between (7)Be activity in the Serbian atmosphere and meteorological parameters.

Air sample monitoring in Serbia, Belgrade started in the 1960s, while (7)Be activity in air and total (dry and wet) deposition has been monitored for the last 22 years by the Environment and Radiation Protection Department of the Institute for Nuclear Sciences, Vinca. Using this data collection, the changes of the (7)Be activity in the air and the total (wet and dry) deposition samples, as well as their correlation with meteorological parameters (temperature, pressure, cloudiness, sunshine duration, precipitation and humidity) that affect (7)Be concentration in the atmosphere, were mathematically described using the Fourier analysis. Fourier analysis confirmed the expected; the frequency with the largest intensity in the harmonic spectra of the (7)Be activity corresponds to a period of 1 year, the same as the largest intensity frequency in Fourier series of meteorological parameters. To analyze the quality of the results produced by the Fourier analysis, we compared the measured values of the parameters with the values calculated according to the Fourier series. Absolute deviations between measured and predicted mean monthly values are in range from 0.02 mBq/m(3) to 0.7 mBq/m(3) for (7)Be activity in air, and 0.01 Bq/m(2) and 0.6 Bq/m(2) for (7)Be activity in deposition samples. Relatively good agreement of measured and predicted results offers the possibility of prediction of the (7)Be activity.

Comparison of two methods for high purity germanium detector efficiency calibration for charcoal canister radon measurement.

The charcoal canister method of radon measurement according to US Environment Protection Agency protocol 520/5-87-005 is widely used for screening. This method is based on radon adsorption on coal and measurement of gamma radiation of radon daughters. For the purpose of gamma spectrometry, appropriate efficiency calibration of the measuring system must be performed. The most usual method of calibration is using standard canister, a sealed canister with the same matrix and geometry as the canisters used for measurements, but with the known activity of radon. In the absence of standard canister, a different method of efficiency calibration has to be implemented. This study presents the results of efficiency calibration using the EFFTRAN efficiency transfer software. Efficiency was calculated using a soil matrix cylindrical secondary reference material as a starting point. Calculated efficiency is then compared with the one obtained using standard canister and applied to a realistic measurement in order to evaluate the results of the efficiency transfer.

Application of GEANT4 simulation on calibration of HPGe detectors for cylindrical environmental samples.

The determination of radionuclide activity concentration requires a prior knowledge of the full-energy peak (FEP) efficiency at all photon energies for a given measuring geometry. This problem has been partially solved by using procedures based on Monte Carlo simulations, developed in order to complement the experimental calibration procedures used in gamma-ray measurements of environmental samples. The aim of this article is to apply GEANT4 simulation for calibration of two HPGe detectors, for measurement of liquid and soil-like samples in cylindrical geometry. The efficiencies obtained using a simulation were compared with experimental results, and applied to a realistic measurement. Measurement uncertainties for both simulation and experimental values were estimated in order to see whether the results of the realistic measurement fall within acceptable limits. The trueness of the result was checked using the known activity of the measured samples provided by IAEA.

Uncertainty evaluation in radon concentration measurement using charcoal canister.

Active charcoal detectors are used for testing the concentration of radon in dwellings. The method of measurement is based on radon adsorption on coal and measurement of gamma radiation of radon daughters. The contributions to the final measurement uncertainty are identified, based on the equation for radon activity concentration calculation. Different methods for setting the region of interest for gamma spectrometry of canisters were discussed and evaluated. The obtained radon activity concentration and uncertainties do not depend on peak area determination method.