High-density culture of human islets on top of silicone rubber membranes.

Islet culture has emerged as a standard practice prior to clinical transplantation. However, culturing large numbers of islets requires low islet density (number of islets per unit surface area) and, consequently, 20 to 30 flasks per pancreas in order to avoid hypoxia-induced death (HID). There is a need for a simple, practical, small-footprint culture vessel that will accommodate aseptic maintenance of entire human islet isolations while avoiding HID. In this communication, we examine the hypothesis that by improving oxygen transfer through culture of islets on silicone rubber membranes (SRM), we may increase islet surface coverage and reduce the number of flasks required while avoiding HID. Our results demonstrate that islets cultured for up to 48 hours in vessels with SRM bottoms at 2000 to 4000 islet equivalents (IE)/cm(2), a surface coverage 10- to 20-fold higher than the standard culture protocol, displayed no significant loss of viability. In contrast, islets cultured for 48 hours at 4000 IE/cm(2) in flasks with gas-impermeable bottoms suffered a 60% to 70% reduction in viability. The data suggest that it is possible to culture all islets isolated from a human pancreas on SRM in a single, standard-sized vessel while maintaining the same viability as with the current, standard culture protocols that require 20 to 30 flasks. This approach may lead to substantial improvements in islet culture for research and clinical transplantation.

Pancreas oxygenation is limited during preservation with the two-layer method.

BACKGROUND: The two-layer method (TLM) for pancreas preservation reportedly improves islet yield and transplantation outcome relative to previous methods. Increased ATP concentrations support the hypothesis that these improvements are related to better oxygenation from the perfluorocarbon solution. However, there are limited direct measurements of oxygen partial pressure, (pO(2)) in pancreata preserved with the TLM. Theory predicts that only a small fraction of a human pancreas can be oxygenated externally. In this report we examine pancreas oxygenation with the TLM using theory and direct pO(2) measurements. METHODS: pO(2) profiles in cylindrical pancreata were calculated at various temperatures with a diffusion-reaction model. The pO(2) was measured using fiber optic sensors in the core of porcine pancreatic tissue preserved with the TLM in media saturated with 100% oxygen. RESULTS: The model predicts that at 8 degrees C, even in the absence of an external pO(2) gradient, oxygen penetration depth is about 1 mm and insensitive to pancreas diameter, while the oxygenated volume fraction is about 15% for a 2.5-cm-diameter pancreas. Experimental measurements verified that pO(2) is virtually zero in the core of a 1-cm-thick pancreatic piece preserved with the TLM. Penetration of solution around the sensor may be responsible for the observed lag and for the previously reported nonzero pO(2) measurements. Reoxygenation of heat-treated tissue took several hours. CONCLUSIONS: The TLM can oxygenate only a small volume fraction of a human pancreas. Pancreas oxygenation through the native vasculature should be explored to further improve yield of viable islets.