Solid-state dye-sensitized solar cells based on ZnO nanocrystals.

We report on the development of solution-processed ZnO-based dye-sensitized solar cells. We fabricate mesoporous ZnO electrodes from sol-gel processed nanoparticles, which are subsequently sensitized with conventional ruthenium complexes and infiltrated with the solid-state hole transporter medium 2, 2', 7, 7'-tetrakis-(N, N-di-p-methoxyphenylamine)-9, 9'-spirobifluorene (spiro-OMeTAD). Starting from ZnO nanorods synthesized from solution, we investigate the porous ZnO film morphology using various precursor formulations. The nature of the polymeric additive used in the initial ZnO formulation, as well as the ZnO electrode sintering treatment, is varied and its influence on device performance and charge dynamics, probed by transient perturbation techniques, is discussed. We show that using ethyl-cellulose in the initial ZnO formulation is responsible for an improved dye loading on the ZnO porous electrode, while a gradual sintering step at 350 degrees C is suitable for the proper removal of the organic phases that can be found in the ZnO films after their deposition by spin-coating. Using only 800 nm thick porous ZnO electrodes sensitized by N719, the best performing device exhibits a short-circuit current density of 2.43 mA cm(-2) under simulated solar emission of (100 mW cm(-2)), associated with an overall power conversion efficiency of 0.50%.

Nanoscale control of the network morphology of high efficiency polymer fullerene solar cells by the use of high material concentration in the liquid phase.

Despite the constant improvement of their power conversion efficiencies, organic solar cells based on an interpenetrating network of a conjugated polymer as donor and fullerene derivatives as acceptor materials still need to be improved for commercial use. In this context, we present a study on the optimization of solar cells based on poly(3-hexylthiophene) (P3HT) and [6,6]-phenyl C61 butyric acid methyl ester (PCBM) by varying a specific cell parameter, namely the concentration of the active layer components in the liquid phase before blend film deposition, in order to improve device performance and to better understand the relation between morphology and device operation. Our study shows a significant increase of the short-circuit current, open-circuit voltage and cell efficiency by properly choosing the formulation of the initial blend before film deposition. We demonstrate that the active layer morphology, which is strongly dependent on the initial material concentrations and the processing conditions, can greatly impact the electronic characteristics of the device, especially regarding charge recombination dynamics at the donor-acceptor interface. Our optimized P3HT:PCBM device exhibits both slow recombination and high photocurrent generation associated with an overall power conversion efficiency of 4.25% under 100 mW cm(-2) illumination (AM1.5G).

[Tenosynovial osteochondromatosis of the hand. A case report]. / Ostéochondromatose téno-synoviale à la main. A propos d'une observation.

A 14 year old boy presented with swelling of the middle finger. X-rays showed calcifications of the palmar surface of the head of the third metacarpal and over the first and second phalanges. The natural course was followed over a period of two years with a diagnosis of calcifying peritendonitis. Due to the increased volume of the calcification deforming the proximal phalanx, the masses were resected revealing a diagnosis of chondroma. The discovery of free foreign bodies in the synovial sheath of the flexors and histological examination established the diagnosis of tenosynovial osteochondromatosis, which is rarely located in the hand. No recurrence has been observed after 8 years of follow-up.