RESUMEN
STUDY DESIGN: Cadaveric, biomechanic study. OBJECTIVE: To compare the range of motion profiles of the cervical spine following one-level anterior cervical discectomy and fusion (ACDF) constructs instrumented with either an interbody cage and anterior plate or integrated fixation cage in a cadaveric model. SUMMARY OF BACKGROUND DATA: While anterior plates with interbody cages are the most common construct of fixation in ACDF, newer integrated cage-plate devices seek to provide similar stability with a decreased implant profile. However, differences in postoperative cervical range of motion between the 2 constructs remain unclear. METHODS: Six cadaveric spines were segmented into 2 functional spine units (FSUs): C2-C5 and C6-T2. Each FSU was nondestructively bent in flexion-extension (FE), right-left lateral bending (LB), and right-left axial rotation (AR) at a rate of 0.5°/s under a constant axial load until a limit of 2-Nm was reached to evaluate baseline range of motion (ROM). Matched pairs were then randomly assigned to undergo instrumentation with either the standard anterior cage and plate (CP) or the integrated fixation cage (IF). Following instrumentation, ROM was then remeasured as previously described. RESULTS: For CP fixation, ROM increased by 61.2±31.7% for FE, 36.3±20.4% for LB, and 31.7±19.1% for AR. For IF fixation, ROM increased by 64.2±15.5% for FE, 56.7±39.8% for LB, and 94.5±65.1% for AR. There was no significant difference in motion between each group across FE, LB, and AR. CONCLUSION: This biomechanical study demonstrated increased motion in both the CP and IF groups relative to the intact, un-instrumented state. However, our model showed no differences in ROM between CP and IF constructs in any direction of motion. These results suggest that either method of instrumentation is a suitable option for ACDF with respect to constructing stiffness at time zero.
RESUMEN
STUDY DESIGN: Controlled laboratory study. OBJECTIVE: The aim was to compare motions at the upper instrumented vertebra (UIV) and supra-adjacent level (UIV+1) between two fixation techniques in thoracic posterior spinal fusion constructs. We hypothesized there would be greater motion at UIV+1 after cyclic loading across all constructs and bilateral pedicle screws (BPSs) with posterior ligamentous compromise would demonstrate the greatest UIV+1 range of motion. SUMMARY OF BACKGROUND DATA: Proximal junctional kyphosis is a well-recognized complication following long thoracolumbar posterior spinal fusion, however, its mechanism is poorly understood. MATERIALS AND METHODS: Twenty-seven thoracic functional spine units were randomly divided into three UIV fixation groups (n=9): (1) BPS, (2) bilateral transverse process hooks (TPHs), and (3) BPS with compromise of the posterior elements between UIV and UIV+1 (BPS-C). Specimens were tested on a servohydraulic materials testing system in native state, following instrumentation, and after cyclic loading. functional spine units were loaded in flexion-extension (FE), lateral bending, and axial rotation. RESULTS: After cyclic testing, the TPH group had a mean 29.4% increase in FE range of motion at UIV+1 versus 76.6% in the BPS group ( P <0.05). The BPS-C group showed an increased FE of 49.9% and 62.19% with sectioning of the facet joints and interspinous ligament respectively prior to cyclic testing. CONCLUSION: BPSs at the UIV led to greater motion at UIV+1 compared to bilateral TPH after cyclic loading. This is likely due to the increased rigidity of BPS compared to TPH leading to a "softer" transition between the TPH construct and native anatomy at the supra-adjacent level. Facet capsule compromise led to a 49.9% increase in UIV+1 motion, underscoring the importance of preserving the posterior ligamentous complex. Clinical studies that account for fusion rates are warranted to determine if constructs with a "soft transition" result in less proximal junctional kyphosis in vivo .
Asunto(s)
Cifosis , Tornillos Pediculares , Fusión Vertebral , Humanos , Fenómenos Biomecánicos , Columna Vertebral , Cifosis/cirugía , Ligamentos Articulares , Fusión Vertebral/métodos , Rango del Movimiento Articular , Vértebras Lumbares/cirugíaRESUMEN
Acromioclavicular joint injuries are common in young active patients. A wide variety of surgical techniques exist to address specific complications associated with surgery. Complications after surgery include loss of reduction, fracture of the clavicle or coracoid, failure of fixation, and prominent and symptomatic hardware. This technique aims to reduce these complications with an arthroscopic anatomic coracoclavicular ligament repair using knotless adjustable loop buttons with fifth-generation suture tape and no drilling of the coracoid.
RESUMEN
BACKGROUND: Current techniques for ulnar collateral ligament (UCL) reconstruction do not reproduce the anatomic ulnar footprint of the UCL. The purpose of this study was to describe a novel UCL reconstruction technique that utilizes proximal-to-distal ulnar bone tunnels to better re-create the anatomy of the UCL and to compare the biomechanical profile at time zero among this technique, the native UCL, and the traditional docking technique. HYPOTHESIS: The biomechanical profile of the anatomic technique is similar to the native UCL and traditional docking technique. STUDY DESIGN: Controlled laboratory study. METHODS: Ten matched cadaveric elbows were potted with the forearm in neutral rotation. The palmaris longus tendon graft was harvested, and bones were sectioned 14 cm proximal and distal to the elbow joint. Specimen testing included (1) native UCL testing performed at 90° of flexion with 0.5 N·m of valgus moment preload, (2) cyclic loading from 0.5 to 5 N·m of valgus moment for 1000 cycles at 1 Hz, and (3) load to failure at 0.2 mm/s. Elbows then underwent UCL reconstruction with 1 elbow of each pair receiving the classic docking technique using either anatomic (proximal to distal) or traditional (anterior to posterior) tunnel locations. Specimen testing was then repeated as described. RESULTS: There were no differences in maximum load at failure between the anatomic and traditional tunnel location techniques (mean ± SD, 34.90 ± 10.65 vs 37.28 ± 14.26 N·m; P = .644) or when including the native UCL (45.83 ± 17.03 N·m; P = .099). Additionally, there were no differences in valgus angle after 1000 cycles across the anatomic technique (4.58°± 1.47°), traditional technique (4.08°± 1.28°), and native UCL (4.07°± 1.99°). The anatomic group and the native UCL had similar valgus angles at failure (24.13°± 5.86° vs 20.13°± 5.70°; P = .083), while the traditional group had a higher valgus angle at failure when compared with the native UCL (24.88°± 6.18° vs 19.44°± 5.86°; P = .015). CONCLUSION: In this cadaveric model, UCL reconstruction with the docking technique utilizing proximal-to-distal ulnar tunnels better restored the ulnar footprint while providing valgus stability comparable with reconstruction with the docking technique using traditional anterior-to-posterior ulnar tunnel locations. These results suggest that utilization of the anatomic tunnel location in UCL reconstruction has similar biomechanical properties to the traditional method at the time of initial fixation (ie, not accounting for healing after reconstruction in vivo) while keeping the ulnar tunnels farther from the ulnar nerve. Further studies are warranted to determine if an anatomically based UCL reconstruction results in differing outcomes than traditional reconstruction techniques. CLINICAL RELEVANCE: Current UCL reconstruction techniques do not accurately re-create the ulnar UCL footprint. The UCL is a dynamic constraint to valgus loads at the elbow, and a more anatomic reconstruction may afford more natural joint kinematics. This more anatomic technique performs similarly to the traditional docking technique at time zero, and the results of this study may offer a starting point for future in vivo studies.
Asunto(s)
Ligamento Colateral Cubital , Ligamentos Colaterales , Articulación del Codo , Reconstrucción del Ligamento Colateral Cubital , Fenómenos Biomecánicos , Cadáver , Ligamento Colateral Cubital/cirugía , Ligamentos Colaterales/cirugía , Codo/cirugía , Articulación del Codo/fisiología , Articulación del Codo/cirugía , Antebrazo , Humanos , Reconstrucción del Ligamento Colateral Cubital/métodosRESUMEN
PURPOSE: To compare the biomechanical properties of high-tensile strength tape and high-tensile strength suture across 2 selected stitch techniques, the Krackow and whip stitch, in securing tendinous tissue during 5,000 cycles of nondestructive loading followed by a load to failure. METHODS: Fourteen matched pairs each of cadaveric Achilles, quadriceps, and patellar tendons (n = 84) were randomly assigned to either Krackow or whip stitch and sutured with either 2-mm high-tensile strength tape or No. 2 high-tensile strength suture. Specimens were preloaded to 20 N, cyclically loaded from 20 to 200 N for 5,000 cycles at 2 Hz, and then loaded to failure at 200 mm/min. Linear mixed models evaluated the effects of suture material and stitch technique on cyclic normalized tendon-suture elongation, total normalized tendon-suture elongation at 5,000 cycles, and maximum load at failure. RESULTS: Across all suture constructs, normalized elongation was greater during the initial 10 cycles, compared with all subsequent cycling intervals (all P < .001). There was less total normalized elongation (ß = -0.239; P = .007) and greater maximum load at failure in tape (ß = 163.71; P = .014) when used in the Krackow stitch compared with the whip stitch. CONCLUSIONS: Our findings indicate that tape used in the Krackow stitch maintains the most favorable fixation strength after enduring cyclic loading, with greater maximum load at failure. In addition, overall normalized elongation during long-term cyclic loading was predominately affected by the stitch technique used, regardless of the suture material; however, tape allowed less normalized elongation during the initial loading cycles, especially when placed in the whip stitch. CLINICAL RELEVANCE: Understanding the potential short- and long-term outcomes of suture material and stitch technique on securing tendinous tissue under repetitive stresses can help inform clinicians on optimal tendon fixation techniques for early postoperative activities.
Asunto(s)
Tendón Calcáneo , Técnicas de Sutura , Tendón Calcáneo/cirugía , Fenómenos Biomecánicos , Humanos , Suturas , Resistencia a la TracciónRESUMEN
OBJECTIVE: At this time, there is no validated tool for describing heterotopic ossification (HO) severity or measuring efficacy of therapies after amputation. This study aims to validate the Walter Reed classification system for reliable characterization of HO burden in residual limbs. DESIGN: Descriptive, Level IV. SETTING: US Military Trauma Referral Center. STUDY POPULATION: Five orthopaedic surgeon raters with varying experience levels assessed orthogonal radiographs of 100 randomly selected residual upper and lower limbs after combat-related amputation. INTERVENTION: A standardized education session on the Walter Reed HO classification system followed by 2 grading sessions, separated by a 2-week waiting period. MAIN OUTCOME MEASURES: Scores were analyzed for interobserver and intraobserver reliability using weighted Cohen's kappa, intraclass correlation coefficient, and Krippendorff's alpha for ordinal variables. RESULTS: After the waiting period, 89% of HO was rated the same by observers with an intraobserver kappa = 0.83 (95% confidence interval [CI] 0.75-0.92). Interobserver reliability was evaluated using group-wise comparison among observers, resulting in an overall Krippendorff's alpha = 0.78 (95% CI 0.76-0.80). Using intraclass correlation coefficient, interrater consistency was 0.94 (95% CI 0.91-0.96). CONCLUSIONS: The Walter Reed HO classification system is substantially reliable for use by raters with any level of orthopaedic training. In addition, it is reliable for evaluation of both through bone and disarticulation type amputations in the upper and lower extremities. However, in 11% of cases, a secondary read may vary, suggesting that this system is useful for understanding HO and developing interventions but may benefit from further refinement, including advanced imaging and clinical correlation.