Interplay between CO Disproportionation and Oxidation: On the Origin of the CO Reaction Onset on Atomic Layer Deposition-Grown Pt/ZrO2 Model Catalysts.

Pt/ZrO2 model catalysts were prepared by atomic layer deposition (ALD) and examined at mbar pressure by operando sum frequency generation (SFG) spectroscopy and near-ambient pressure X-ray photoelectron spectroscopy (NAP-XPS) combined with differentially pumped mass spectrometry (MS). ALD enables creating model systems ranging from Pt nanoparticles to bulk-like thin films. Polarization-dependent SFG of CO adsorption reveals both the adsorption configuration and the Pt particle morphology. By combining experimental data with ab initio density functional theory (DFT) calculations, we show that the CO reaction onset is determined by a delicate balance between CO disproportionation (Boudouard reaction) and oxidation. CO disproportionation occurs on low-coordinated Pt sites, but only at high CO coverages and when the remaining C atom is stabilized by a favorable coordination. Thus, under the current conditions, initial CO oxidation is found to be strongly influenced by the removal of carbon deposits formed through disproportionation mechanisms rather than being determined by the CO and oxygen inherent activity. Accordingly, at variance with the general expectation, rough Pt nanoparticles are seemingly less active than smoother Pt films. The applied approach enables bridging both the "materials and pressure gaps".

Roughening of Copper (100) at Elevated CO Pressure: Cu Adatom and Cluster Formation Enable CO Dissociation.

Carbon monoxide participates in many copper-catalyzed reactions, which makes CO-induced structural changes of Cu catalysts key for important industrial processes. We have studied the interaction of carbon monoxide with the Cu(100) single crystal termination at 120, 200, and 300 K by means of low-energy electron diffraction (LEED), temperature-programmed desorption (TPD), X-ray photoelectron spectroscopy (XPS), polarization-modulation infrared reflection absorption spectroscopy (PM-IRAS), and density functional theory (DFT) calculations. The absorption band of CO (2082-2112 cm-1) at elevated gas pressure (up to 5 mbar) and at 200/300 K was found at a higher wavenumber than the characteristic band of the c(2 × 2)CO structure and was consistent with CO adsorbed on low-coordinated Cu atoms. The combined PM-IRAS/DFT analysis revealed that exposure to CO induced surface roughening through the formation of Cu adatoms and clusters on the (100) terraces. The roughened surface seemed surprisingly active for CO dissociation, which indicates its unique catalytic properties.

Polarization-Dependent SFG Spectroscopy of Near Ambient Pressure CO Adsorption on Pt(111) and Pd(111) Revisited.

Polarization-dependent sum frequency generation (SFG) vibrational spectroscopy was employed to examine CO overlayers on Pt(111) and Pd(111) single crystal surfaces at room temperature. Utilizing different polarization combinations (SSP and PPP) of the visible and SFG light allows to determine the molecular orientation (tilt angle) of interface molecules but the analysis of the measured Ippp/Issp is involved and requires a proper optical interface model. For CO/Pt(111), the hyperpolarizability ratio R=ßaac/ßccc=ßbbc/ßccc is not exactly known and varying R in the range 0.1-0.5 yields tilt angles of 40°-0°, respectively. Based on the known perpendicular adsorption of CO on Pt, an exact R-value of 0.49 was determined. Polarization-dependent SFG spectra in the pressure range 10-4 to 36 mbar did not indicate any change of the tilt angle of adsorbed CO. Modeling also indicated a strong dependence of Ippp/Issp on the incidence angles of visible and IR laser beams. Complementing previous low temperature/low pressure data, room temperature CO adsorption on Pd(111) was examined from 10-6 to 250 mbar. The absolute PPP and SSP spectral intensities on Pt and Pd were simulated, as well as the expected Ippp/Issp ratios. Although CO on Pt and Pd should exhibit similar intensities (at high CO coverage), the higher Ippp/Issp ratio for Pd (48 vs. 27 on Pt) renders the detection of adsorbed CO in SSP spectra difficult. The presence or absence of CO species in SSP spectra can thus not simply be correlated to tilted or perpendicular CO molecules, respectively. Careful modeling, including not only molecular and interface properties, but also the experimental configuration (incidence angles), is certainly required even for seemingly simple adsorbate-substrate systems.

Atmospheric pressure reaction cell for operando sum frequency generation spectroscopy of ultrahigh vacuum grown model catalysts.

A new custom-designed ultrahigh vacuum (UHV) chamber coupled to a UHV and atmospheric-pressure-compatible spectroscopic and catalytic reaction cell is described, which allows us to perform IR-vis sum frequency generation (SFG) vibrational spectroscopy during catalytic (kinetic) measurements. SFG spectroscopy is an exceptional tool to study vibrational properties of surface adsorbates under operando conditions, close to those of technical catalysis. This versatile setup allows performing surface science, SFG spectroscopy, catalysis, and electrochemical investigations on model systems, including single crystals, thin films, and deposited metal nanoparticles, under well-controlled conditions of gas composition, pressure, temperature, and potential. The UHV chamber enables us to prepare the model catalysts and to analyze their surface structure and composition by low energy electron diffraction and Auger electron spectroscopy, respectively. Thereafter, a sample transfer mechanism moves samples under UHV to the spectroscopic cell, avoiding air exposure. In the catalytic cell, SFG spectroscopy and catalytic tests (reactant/product analysis by mass spectrometry or gas chromatography) are performed simultaneously. A dedicated sample manipulation stage allows the model catalysts to be examined from LN2 temperature to 1273 K, with gaseous reactants in a pressure range from UHV to atmospheric. For post-reaction analysis, the SFG cell is rapidly evacuated and samples are transferred back to the UHV chamber. The capabilities of this new setup are demonstrated by benchmark results of CO adsorption on Pt and Pd(111) single crystal surfaces and of CO adsorption and oxidation on a ZrO2 supported Pt nanoparticle model catalyst grown by atomic layer deposition.

Reverse Water-Gas Shift or Sabatier Methanation on Ni(110)? Stable Surface Species at Near-Ambient Pressure.

The interaction of CO, CO2, CO + H2, CO2 + H2, and CO + CO2 + H2 with the nickel (110) single crystal termination has been investigated at 10(-1) mbar in situ as a function of the surface temperature in the 300-525 K range by means of infrared-visible sum frequency generation (IR-vis SFG) vibrational spectroscopy and by near-ambient pressure X-ray photoelectron spectroscopy (NAP-XPS). Several stable surface species have been observed and identified. Besides atomic carbon and precursors for graphenic C phases, five nonequivalent CO species have been distinguished, evidencing the role of coadsorption effects with H and C atoms, of H-induced activation of CO, and of surface reconstruction. At low temperature, carbonate species produced by the interaction of CO2 with atomic oxygen, which stems from the dissociation of CO2 into CO + O, are found on the surface. A metastable activated CO2(-) species is also detected, being at the same time a precursor state toward dissociation into CO and O in the reverse water-gas shift mechanism and a reactive species that undergoes direct conversion in the Sabatier methanation process. Finally, the stability of ethylidyne is deduced on the basis of our spectroscopic observations.