RESUMEN
In systems with reduced dimensions, quantum fluctuations have a strong influence on the electronic conduction, even at very low temperatures. In superconductors, this is especially interesting, since the coherent state of the superconducting electrons strongly interacts with these fluctuations and therefore is a sensitive tool to study them. In this paper, we report on comprehensive measurements of superconducting nanowires in the quantum phase slip regime. Using an intrinsic electromigration process, we have developed a method to lower the nanowire's resistance in situ and therefore eliminate quantum phase slips in small consecutive steps. We observe critical (Coulomb) blockade voltages and superconducting critical currents, in good agreement with theoretical models. Between these two regimes, we find a continuous transition displaying a nonlinear metallic-like behavior. The reported intrinsic electromigration technique is not limited to low temperatures, as we find a similar change in resistance that spans over 3 orders of magnitude also at room temperature. Aside from superconducting quantum circuits, such a technique to reduce the resistance may also have applications in modern electronic circuits.
RESUMEN
The unusual superconducting properties of granular aluminum oxide have been recently investigated for application in quantum circuits. However, the intrinsic irregular structure of this material requires a good understanding of the transport mechanisms and, in particular, the effect of disorder, especially when patterned at the nanoscale level. In view of these aspects, electric transport and voltage fluctuations have been investigated on thin-film based granular aluminum oxide nanowires, in the normal state and at temperatures between 8 and 300 K. The nonlinear resistivity and two-level tunneling fluctuators have been observed. Regarding the nature of the noise processes, the experimental findings give a clear indication in favor of a dynamic random resistor network model, rather than the possible existence of a local ordering of magnetic origin. The identification of the charge carrier fluctuations in the normal state of granular aluminum oxide nanowires is very useful for improving the fabrication process and, therefore, reducing the possible sources of decoherence in the superconducting state, where quantum technologies that are based on these nanostructures should work.
RESUMEN
Superconducting quantum information processing machines are predominantly based on microwave circuits with relatively low characteristic impedance, about 100 Ω, and small anharmonicity, which can limit their coherence and logic gate fidelity1,2. A promising alternative is circuits based on so-called superinductors3-6, with characteristic impedances exceeding the resistance quantum RQ = 6.4 kΩ. However, previous implementations of superinductors, consisting of mesoscopic Josephson junction arrays7,8, can introduce unintended nonlinearity or parasitic resonant modes in the qubit vicinity, degrading its coherence. Here, we present a fluxonium qubit design based on a granular aluminium superinductor strip9-11. We show that granular aluminium can form an effective junction array with high kinetic inductance and be in situ integrated with standard aluminium circuit processing. The measured qubit coherence time [Formula: see text] illustrates the potential of granular aluminium for applications ranging from protected qubit designs to quantum-limited amplifiers and detectors.
RESUMEN
Superconducting high kinetic inductance elements constitute a valuable resource for quantum circuit design and millimeter-wave detection. Granular aluminum (grAl) in the superconducting regime is a particularly interesting material since it has already shown a kinetic inductance in the range of nH/â¡ and its deposition is compatible with conventional Al/AlOx/Al Josephson junction fabrication. We characterize microwave resonators fabricated from grAl with a room temperature resistivity of 4×10^{3} µΩ cm, which is a factor of 3 below the superconductor to insulator transition, showing a kinetic inductance fraction close to unity. The measured internal quality factors are on the order of Q_{i}=10^{5} in the single photon regime, and we demonstrate that nonequilibrium quasiparticles (QPs) constitute the dominant loss mechanism. We extract QP relaxation times in the range of 1 s and we observe QP bursts every â¼20 s. The current level of coherence of grAl resonators makes them attractive for integration in quantum devices, while it also evidences the need to reduce the density of nonequilibrium QPs.
RESUMEN
The quantum Rabi model describes the fundamental mechanism of light-matter interaction. It consists of a two-level atom or qubit coupled to a quantized harmonic mode via a transversal interaction. In the weak coupling regime, it reduces to the well-known Jaynes-Cummings model by applying a rotating wave approximation. The rotating wave approximation breaks down in the ultra-strong coupling regime, where the effective coupling strength g is comparable to the energy ω of the bosonic mode, and remarkable features in the system dynamics are revealed. Here we demonstrate an analog quantum simulation of an effective quantum Rabi model in the ultra-strong coupling regime, achieving a relative coupling ratio of g/ω ~ 0.6. The quantum hardware of the simulator is a superconducting circuit embedded in a cQED setup. We observe fast and periodic quantum state collapses and revivals of the initial qubit state, being the most distinct signature of the synthesized model.An analog quantum simulation scheme has been explored with a quantum hardware based on a superconducting circuit. Here the authors investigate the time evolution of the quantum Rabi model at ultra-strong coupling conditions, which is synthesized by slowing down the system dynamics in an effective frame.