RESUMEN
The environmental radiation exposure in Canada has been monitored since 2002 by Health Canada's Fixed Point Surveillance network. The network consists of over eighty 7.6 cm × 7.6 cm sodium iodide spectrometers, and routinely reports to the public the environmental gamma radiation level throughout Canada. This paper describes the latest dose calibrations to air kerma and ambient dose equivalent for the future upgraded network. The calibration curves were developed using Monte Carlo techniques and further optimized via experiments in various reference fields. The dose calibration was validated over a wide range of gamma energy, dose measurement range, and angle of incidence under laboratory conditions. In environmental monitoring situations, the angular distribution of radiation exposure was analytically calculated by assuming a semi-infinite plume source, semi-infinite planar source, and infinite volume sources for the respective exposure scenarios of radioactive plume, ground contamination, and soil source. By coupling the resultant radiation angular distribution with detector's angular variation on dose response, the overall accuracy of dose measurement in each of these environmental scenarios was estimated. The accuracy is expected to be within ±3.7% for plume radiation, -5.6% for 137Cs ground contamination, and 0% to -17.1% for soil radioactive sources. The under-estimation for soil sources is mainly caused by absorption of radiation in the electronic system underneath the crystal.
Asunto(s)
Monitoreo de Radiación , Calibración , Método de Montecarlo , Dosis de Radiación , Monitoreo de Radiación/métodos , Yoduro de Sodio , SueloRESUMEN
A novel and sensitive approach for the accurate and precise determination of Pb in environmental samples is presented using transition metal ion-assisted photochemical vapor generation (PVG) for sample introduction with multicollector inductively coupled plasma mass spectrometry (MC-ICPMS) detection. A significant improvement in PVG efficiency of lead is achieved in the presence of transition metal ions (Co(2+) and Ni(2+)) in solutions of 5% (v/v) formic acid. The determination of Pb in digests of sediment or soil samples is readily achieved due to coexisting transition metal ions which facilitate the PVG reaction. The method detection limit of 0.005 ng g(-1) (3σ) using external calibration is comparable to that obtained using hydride generation (HG) ICPMS. However, PVG methodology is simpler, results in lower blanks, and avoids unstable reagents. The accuracy of the proposed method was demonstrated by analysis of several environmental certified reference materials (CRMs; SLRS-5 and SRM1640a river water CRMs and MESS-3, MESS-4, and SRM2702 sediments) with satisfying results. High precision of determination (<0.4% RSD) of Pb in river water and sediments was realized on the basis of isotope dilution calibration.