The push-pull intercrop Desmodium does not repel, but intercepts and kills pests.

Over two decades ago, an intercropping strategy was developed that received critical acclaim for synergizing food security with ecosystem resilience in smallholder farming. The push-pull strategy reportedly suppresses lepidopteran pests in maize through a combination of a repellent intercrop (push), commonly Desmodium spp., and an attractive, border crop (pull). Key in the system is the intercrop's constitutive release of volatile terpenoids that repel herbivores. However, the earlier described volatile terpenoids were not detectable in the headspace of Desmodium, and only minimally upon herbivory. This was independent of soil type, microbiome composition, and whether collections were made in the laboratory or in the field. Furthermore, in oviposition choice tests in a wind tunnel, maize with or without an odor background of Desmodium was equally attractive for the invasive pest Spodoptera frugiperda. In search of an alternative mechanism, we found that neonate larvae strongly preferred Desmodium over maize. However, their development stagnated and no larva survived. In addition, older larvae were frequently seen impaled and immobilized by the dense network of silica-fortified, non-glandular trichomes. Thus, our data suggest that Desmodium may act through intercepting and decimating dispersing larval offspring rather than adult deterrence. As a hallmark of sustainable pest control, maize-Desmodium push-pull intercropping has inspired countless efforts to emulate stimulo-deterrent diversion in other cropping systems. However, detailed knowledge of the actual mechanisms is required to rationally improve the strategy, and translate the concept to other cropping systems.

Effect of water salinity on immature performance and lifespan of adult Asian tiger mosquito.

BACKGROUND: Aedes albopictus (Skuse, 1894) is a vector for pathogens like dengue, chikungunya, and Zika viruses. Its adaptive capacity enables reproduction in temperate climates and development mainly in artificial containers with fresh water in urbanized areas. Nevertheless, breeding in coastal areas may also occur along with its aggressive invasiveness. Global warming and the consequent rise in sea levels will increase saline (> 30 ppt) or brackish (0.5-30 ppt salt) water in coastal regions. To address whether Ae. albopictus can breed in brackish water, we initiated the current study that analyses the survival of immature stages at different salinity concentrations and explores whether carryover effects occur in the resulting adults. This possible adaptation is important when considering the potential for development in new habitats and expansion of one of the world's most invasive species. METHODS: We investigated the influence of salinity on the survival of Ae. albopictus larvae and adults under laboratory-controlled conditions. First instar larvae were exposed to different salinity concentrations (0 to 30 ppt) and their development time, pupation, adult emergence, and overall survival were monitored daily. We used Kaplan-Meier and Cox regression models to analyze the survival rates at different salinity levels. Furthermore, life tables were constructed under each salinity concentration. RESULTS: Increasing salt concentrations significantly increased the mortality risk during immature development, while no significant effect was observed on adult mortality risk. A comparison between distilled and bottled water revealed a notable increase in overall mortality risk for individuals developing in distilled water. However, no significant effects were found when analyzing survival from the first larval stage to adult emergence and adult lifespan. The life expectancy of immature stages decreased with increasing salt concentrations, although salinity concentration did not significantly impact adult life expectancy. CONCLUSIONS: Our findings suggest that Ae. albopictus, previously considered freshwater species, can successfully develop and survive in brackish waters, even in the absence of characteristic structures found in euryhaline species. These adaptations may enable Ae. albopictus to establish new breeding sites and colonize unexplored territories. Knowledge of these physiological adaptations of Ae. albopictus to salinity should be pursued to increase the range of control of the species, and to make more accurate predictions of its dispersal and vectoring ability.

Identification and quantification of fluorinated polymers in consumer products by combustion ion chromatography and pyrolysis-gas chromatography-mass spectrometry.

Total fluorine was determined in 45 consumer product samples from the Swedish market which were either suspected or known to contain fluorinated polymers. Product categories included cookware (70-550 000 ppm F), textiles (10-1600 ppm F), electronics (20-2100 ppm F), and personal care products (10-630 000 ppm F). To confirm that the fluorine was organic in nature, and deduce structure, a qualitative pyrolysis-gas chromatography-mass spectrometry (pyr-GC/MS) method was validated using a suite of reference materials. When applied to samples with unknown PFAS content, the method was successful at identifying polytetrafluoroethylene (PTFE) in cookware, dental products, and electronics at concentrations as low as 0.1-0.2 wt%. It was also possible to distinguish between 3 different side-chain fluorinated polymers in textiles. Several products appeared to contain high levels of inorganic fluorine. This is one of the few studies to quantify fluorine in a wide range of consumer plastics and provides important data on the concentration of fluorine in materials which may be intended for recycling, along with insights into the application of pyr-GC/MS for structural elucidation of fluorinated polymers in consumer products.

Insecticide resistant mosquitoes remain thermal stress resistant, without loss of thermal plasticity.

A major component of mosquito's climate change response is their heat tolerance, and any ability to rapidly adjust to extreme environmental conditions through phenotypic plasticity. The excessive use of insecticides for the control of major mosquito species leads to resistant populations, however it is largely unclear if this concurrently impacts thermal stress resistance and their potential to adjust tolerance via phenotypic plasticity. Culex pipiens pipiens, Culex pipiens molestus and Aedes albopictus populations obtained from the same region were subjected for 12 generations to selection trials to larvicides Diflubenzuron (DFB) and Bacillus thuringiensis subsp. israelensis (Bti) to develop insecticide resistance. Adults emerging from the selected populations were acclimated at different temperatures and the upper and lower critical thermal limits (CTmax and CTmin) were estimated using dynamic thermal assays. In addition, the supercooling points (SCPs) of non-acclimated adults of resistant and control populations were determined. Our results revealed marked differences in thermal response among the three species, the different acclimation regimes and sexes. Aedes albopictus was more resistant in high than low temperatures compared to both Culex pipiens biotypes. Culex forms responded similarly to heat but differently to cold stress. In both forms, females responded better than males to all thermal stressors. Acclimation at higher and lower temperatures improves CTmax and CTmin values, respectively in both insecticide resistant and control populations of all three species. Overall, selection to insecticides did not affect the thermal performance of adults. Hence, insecticide-resistant mosquito populations perform similarly to untreated ones and are capable of readily adapting to new environmental changes rising concerns regarding their geographic range expansion and disease transmission globally.

Horizontal and Vertical Distribution of Perfluoroalkyl Acids (PFAAs) in the Water Column of the Atlantic Ocean.

Perfluoroalkyl acids (PFAAs) are widely distributed in the oceans which are their largest global reservoir, but knowledge is limited about their vertical distribution and fate. This study measured the concentrations of PFAAs (perfluoroalkyl carboxylic acids (PFCAs) with 6 to 11 carbons and perfluoroalkanesulfonic acids (PFSAs) with 6 and 8 carbons) in the surface and deep ocean. Seawater depth profiles from the surface to a 5000 m depth at 28 sampling stations were collected in the Atlantic Ocean from ∼50° N to ∼50° S. The results demonstrated PFAA input from the Mediterranean Sea and the English Channel. Elevated PFAA concentrations were observed at the eastern edge of the Northern Atlantic Subtropical Gyre, suggesting that persistent contaminants may accumulate in ocean gyres. The median ΣPFAA surface concentration in the Northern Hemisphere (n = 17) was 105 pg L-1, while for the Southern Hemisphere (n = 11) it was 28 pg L-1. Generally, PFAA concentrations decreased with increasing distance to the coast and increasing depth. The C6-C9 PFCAs and C6 and C8 PFSAs dominated in surface waters, while longer-chain PFAAs (C10-C11 PFCAs) peaked at intermediate depths (500-1500 m). This profile may be explained by stronger sedimentation of longer-chain PFAAs, as they sorb more strongly to particulate organic matter.

Lithium-ion battery recycling: a source of per- and polyfluoroalkyl substances (PFAS) to the environment?

Recycling of lithium-ion batteries (LIBs) is a rapidly growing industry, which is vital to address the increasing demand for metals, and to achieve a sustainable circular economy. Relatively little information is known about the environmental risks posed by LIB recycling, in particular with regards to the emission of persistent (in)organic fluorinated chemicals. Here we present an overview on the use of fluorinated substances - in particular per- and polyfluoroalkyl substances (PFAS) - in state-of-the-art LIBs, along with recycling conditions which may lead to their formation and/or release to the environment. Both organic and inorganic fluorinated substances are widely reported in LIB components, including the electrodes and binder, electrolyte (and additives), and separator. Among the most common substances are LiPF6 (an electrolyte salt), and the polymeric PFAS polyvinylidene fluoride (used as an electrode binder and a separator). Currently the most common LIB recycling process involves pyrometallurgy, which operates at high temperatures (up to 1600 °C), sufficient for PFAS mineralization. However, hydrometallurgy, an increasingly popular alternative recycling approach, operates under milder temperatures (<600 °C), which could favor incomplete degradation and/or formation and release of persistent fluorinated substances. This is supported by the wide range of fluorinated substances detected in bench-scale LIB recycling experiments. Overall, this review highlights the need to further investigate emissions of fluorinated substances during LIB recycling and suggests that substitution of PFAS-based materials (i.e. during manufacturing), or alternatively post-treatments and/or changes in process conditions may be required to avoid formation and emission of persistent fluorinated substances.