Chemical and physical properties of alginate-like exopolymers of aerobic granules and flocs produced from different wastewaters.

The influence of wastewater (WW) composition and the bioaggregates types (floccular vs. aerobic granular sludge - AGS) on the content, physical-chemical, hydrogel and rheological properties of Alginate-Like Exopolymers (ALE) was studied. Results showed that ALE are a complex mixture of proteins, humic acids and polysaccharides. Overall, rather similar ALE content and composition was observed for the different types of sludge. Only the AGS fed with acetate and propionate yielded significantly larger amount of ALE (261 ± 33 mg VSALE/g VSsludge, +49%) and of uronic sugars in ALE (254 ± 32 mgglucuronic acid/g VSALE, +62%) than bioaggregates fed with no/very little volatile fatty acids. Mannuronic acids are involved in the cohesion of the hydrogels. ALE hydrogels elasticity changed significantly with the type/origin of the bioaggregates. ALE hydrogels elasticity from AGS was always higher than from flocs when fed with real WW. Hence, different types of sludge impact the properties of the recovered ALE.

Impact of additive application on the establishment of fast and stable aerobic granulation.

Aerobic granular sludge (AGS) is a microbial biofilm self-aggregation, which is effective for nutrient and pollutant removal, through the development of dense microbial layers bound together with extracellular polymeric substances (EPSs). However, long start-up times and granule disintegration are still challenges ahead. An array of external additives, including ion chelating agents, sludge-based enhancers, and magnetic influence have been tested to overcome these barriers. The application of such additives may promote enhanced EPS production, neutralization of charges on the bacterial surface, acts as a core-induced agent, or as a bridge to connect EPSs and cell surfaces. Although additives may improve the granule formation without reducing treatment efficiencies, there are still environmental concerns due to the fate and toxicity of discharged excess sludge. This mini-review identifies an array of external additives and their mechanisms to improve granulation properties, and proposes discussion about the technical and economic viability of these additives. KEY POINTS: • Additives reduce granulation time and repair granule disintegration. • Biopolymer-based additives fulfill technical and environmental requirements. • Sludge-based additives are cheap and in line with the resource recovery concept. • The need for environmental-friendly additives for aerobic granular sludge process. • External additives affect granular biomass size distribution.

Biopolymers recovery: dynamics and characterization of alginate-like exopolymers in an aerobic granular sludge system treating municipal wastewater without sludge inoculum.

Alginate-like exopolymers (ALE) are present in the extracellular polymeric substances (EPS) of biological sludge such as aerobic granular sludge (AGS). The recovery of ALE from excess sludge produced by wastewater treatment plants (WWTP) is a relevant approach for the recovery of valuable products of industrial interest. However, little is known about dynamics of ALE content in sludge and associated factors. Thus, this study aimed at assessing the dynamics of EPS and ALE in terms of content, some chemical properties and influencing environmental factors along granulation in a sequencing batch reactor treating municipal wastewater. Results indicated that the EPS content was not correlated with the development of AGS, while the ALE content was higher, more stable and steadily increased after granulation achievement. Overall, 236 ± 27 mg VSALE/g VSsludge was recovered from AGS and 187 ± 94 mg VSALE/g VSsludge from flocs. However, the lower ALE content in flocs may be compensated by the higher sludge production rate in activated sludge systems. Principal component analysis (PCA) revealed that ALE content positively correlates with the nutrient and organic substrate conversion, and with the fraction of large AGS. Microbial analyses indicated that a stable microbial community composition was associated with a higher and more stable ALE content. ALE recovered from both flocs and AGS was endowed with hydrogel property, and no clear difference in their elemental composition and functional groups was observed. Therefore, our study provides insights about quantitative and qualitative aspects of ALE which are helpful for the improvement of waste biological sludge valorization.

Influência do biodiesel de soja na biodegradação anaeróbia do benzeno e tolueno / Soybean biodiesel effects on anaerobic biodegradation of benzene and toluene

A influência do biodiesel de soja na biodegradação dos hidrocarbonetos monoaromáticos benzeno e tolueno foi estudada sob condições anaeróbias em dois microcosmos montados com água subterrânea sintética, inóculo metanogênico, benzeno, tolueno e biodiesel. Na presença de biodiesel não foi observada biodegradação do benzeno e do tolueno. Com a biodegradação do biodiesel ocorreu a formação de acetato e metano, uso do sulfato e um aumento de 45 vezes no número de bactérias sulfato-redutoras. Esses resultados mostraram que, na mistura com benzeno e tolueno, o biodiesel foi biodegradado tanto sob condições de sulfato-redução quanto metanogênicas e que sua presença estimulou o crescimento da biomassa.

The effects of biodiesel on the biodegradation of benzene and toluene under anaerobic conditions were assessed using two microcosms constructed using synthetic groundwater, methanogenic inoculum and amended with benzene, toluene and biodiesel. In the presence of biodiesel, benzene and toluene degradation was substantially inhibited. Biodiesel degradation was followed by a production of acetate and methane, consumption of sulfate and a 45-fold increase in sulfate-reducing concentration. These results demonstrated that, in the presence of benzene and toluene, biodiesel was biodegraded under sulfate-reduction and methanogenic conditions and also stimulated biomass growth.

Nitrate addition to groundwater impacted by ethanol-blended fuel accelerates ethanol removal and mitigates the associated metabolic flux dilution and inhibition of BTEX biodegradation.

A comparison of two controlled ethanol-blended fuel releases under monitored natural attenuation (MNA) versus nitrate biostimulation (NB) illustrates the potential benefits of augmenting the electron acceptor pool with nitrate to accelerate ethanol removal and thus mitigate its inhibitory effects on BTEX biodegradation. Groundwater concentrations of ethanol and BTEX were measured 2 m downgradient of the source zones. In both field experiments, initial source-zone BTEX concentrations represented less than 5% of the dissolved total organic carbon (TOC) associated with the release, and measurable BTEX degradation occurred only after the ethanol fraction in the multicomponent substrate mixture decreased sharply. However, ethanol removal was faster in the nitrate amended plot (1.4 years) than under natural attenuation conditions (3.0 years), which led to faster BTEX degradation. This reflects, in part, that an abundant substrate (ethanol) can dilute the metabolic flux of target pollutants (BTEX) whose biodegradation rate eventually increases with its relative abundance after ethanol is preferentially consumed. The fate and transport of ethanol and benzene were accurately simulated in both releases using RT3D with our general substrate interaction module (GSIM) that considers metabolic flux dilution. Since source zone benzene concentrations are relatively low compared to those of ethanol (or its degradation byproduct, acetate), our simulations imply that the initial focus of cleanup efforts (after free-product recovery) should be to stimulate the degradation of ethanol (e.g., by nitrate addition) to decrease its fraction in the mixture and speed up BTEX biodegradation.